ABSTRACT
The use of surfactants represents a valuable method to enhance the access of the microorganisms to low-soluble and recalcitrant compounds in bioremediation techniques. The choice of surfactants is the first step of feasibility studies for this application. So far, no defined procedures are present in literature to select the most suitable surfactant for the treatment of a specific contaminated site. Furthermore, the characterisation of physico-chemical parameters is important to understand the reason of successes and failures. In this paper a step procedure to select and characterise a commercial surfactant to be used in bioremediation enhancement of hydrocarbon-contaminated media was developed. Among the commercial surfactants, the procedure was applied to alkyl polyethoxylates (Brij family) and sorbitan derivates (Tween family). The selection resulted in the application of Brij 56 and Tween 80 as biodegradation-enhancer in different lab scale systems for remediation of diesel contamination. In liquid systems, Tween 80 greatly increased biodegradation of highly branched and high-molecular weight hydrocarbons, while Brij 56 enhanced degradation of highly branched hydrocarbons. Based on these results, the potential applications and the limitations of these surfactants at full scale level were estimated.
Subject(s)
Environmental Restoration and Remediation/methods , Gasoline , Hydrocarbons/metabolism , Soil Microbiology , Soil Pollutants/metabolism , Surface-Active Agents/chemistryABSTRACT
The effect of Tween 80 and selected bacteria additions on the bioremediation of PAH contaminated landfill soil (70.38mgkg(-1)) was evaluated in a slurry phase bioreactor. A phenanthrene-degrading consortium was selected by enrichment cultures and used as autochthonous inoculum. The Tween 80 addition increased the aqueous concentration of both high and low molecular weight PAHs. In the experiment with Tween 80 and inoculum addition, added microorganisms improved (>90%) the biodegradation of two- and three-ring PAHs as well as of the four-ring PAHs pyrene and fluoranthene. Biodegradation of the higher molecular weight PAHs was about 30% in experiments with Tween 80 addition, with and without inoculum addition.
Subject(s)
Biodegradation, Environmental , Bioreactors , Hydrocarbons/analysis , Polycyclic Compounds/analysis , Refuse Disposal/methods , Soil Pollutants/metabolism , Hydrolysis , Kinetics , Molecular Weight , Phenanthrenes/analysis , Polysorbates/analysis , Pyrenes/analysis , Soil , SolubilityABSTRACT
The aim of the research was to verify the possibility of applying bioremediation as a treatment strategy on a poly(vinyl chloride) (PVC) manufacturing site in the north of Italy contaminated by diethylhexyl phthalate (DEHP) at a concentration of 5.51 mg/g of dry soil. Biodegradation kinetic experiments with DEHP contaminated soil samples were performed in both slurry- and solid-phase systems. The slurry-phase results showed that the cultural conditions, such as N and P concentrations and the addition of a selected DEHP degrading strain, increased the natural DEHP degradation rate. On the basis of these data, experiments to simulate bioventing on contaminated soil columns were performed. The DEHP concentration reached 0.63 mg/g of dry soil in 76 days (89% of degradation). A kinetic equation was developed to fit the experimental data and to predict the concentration of contaminant after treatment. The data obtained are encouraging for a future in situ application of the bioventing technology.
Subject(s)
Diethylhexyl Phthalate/isolation & purification , Diethylhexyl Phthalate/metabolism , Models, Theoretical , Soil Pollutants/isolation & purification , Soil Pollutants/metabolism , Biodegradation, Environmental , Chemical Industry , Gases , Kinetics , Soil MicrobiologyABSTRACT
The research was focused on the slurry-phase biodegradation of naphthalene in soil. Among ex situ techniques, the slurry phase offers the advantage of increased availability of contaminants to bacteria. From naphthalene contaminated soil, a Pseudomonas putida M8 strain capable to degrade naphthalene was selected. Experiments were performed in a stirred and oxygenated reactor. In this study, the influence of air flow rate and agitation rate on volatilisation and biodegradation of naphthalene was investigated. The hydrocarbon disappearance, the carbon dioxide production, and the ratio of total heterotrophic and naphthalene-degrading bacteria was monitored. The results obtained confirm that the selected bioremediation technology is successful in the treatment of contaminated soils.
Subject(s)
Bacteria, Aerobic/physiology , Naphthalenes/metabolism , Soil Pollutants/metabolism , Biodegradation, Environmental , Bioreactors , Kinetics , Pseudomonas putida/physiologyABSTRACT
Municipal solid waste incinerator (MSWI) fly ash was investigated to study metal distribution on the particle surface. A detailed investigation into the distribution of chlorine, copper, iron, and zinc was carried out by electron microscopy coupled with X-ray fluorescence spectroscopy. Compositional and leaching test data were used to identify the correlation of significant variables and to formulate a hypothesis about metals speciation. The presence of copper chloride, iron, and zinc oxides was inferred. The iron and zinc accumulation in the submicron nuclei indicates that these metals came from the condensation of volatile species. As far as concerns copper, morphological data together with the element correlation study suggest that this element accumulates on particles involved in heterogeneous condensation processes. Furthermore, during such processes, particles of small size containing copper are formed.
Subject(s)
Carbon/chemistry , Incineration , Metals, Heavy/analysis , Coal Ash , Copper/analysis , Copper/chemistry , Microscopy, Electron, Scanning , Particle Size , Particulate MatterABSTRACT
The performance of the supercritical fluid extraction (SFE) technique to obtain a new and more appropriate model support for PCDD/F formation studies was investigated. To characterize fly ash and model supports and relate their chemical-physical properties, surface area and pore size were determined. To evaluate the influence on reactivity of the different model supports with respect to raw fly ash, a kinetic study of the thermal behavior of dibenzofuran (DF) was performed. Rate constants as well as the activation and thermodynamic parameters for the different systems were also compared. The model support obtained from SFE was very similar to raw fly ash from the structural, physical-chemical, and kinetic points of view.
Subject(s)
Benzofurans/chemistry , Models, Theoretical , Polychlorinated Dibenzodioxins/analogs & derivatives , Polychlorinated Dibenzodioxins/chemistry , Refuse Disposal , Soil Pollutants/analysis , Incineration , Kinetics , Porosity , TemperatureABSTRACT
Ligand binding by the aryl hydrocarbon receptor (AhR), a member of the bHLH-PAS family of transcriptional regulatory proteins, has been mapped to a region within the second 'PAS' domain, a conserved sequence motif first discovered in the Per-ARNT-Sim family of proteins. In addition to the bacterial photoactive yellow protein (PYP), which had been proposed as a structural prototype for the three dimensional fold of PAS domains, two crystal structures of the PAS domain have recently been determined: the human potassium channel HERG and the heme binding domain of the bacterial O(2) sensing FixL protein. The three structures reveal a highly conserved structural framework in evolutionary rather distant PAS domains, provide a more general view of how these domains can recognize their ligands and suggest a structure-function relationship that we exploited to build a three-dimensional model of the ligand binding domain (LBD) of the mouse aryl hydrocarbon receptor (mAhR). The model allowed us to putatively identify the residues responsible for the recognition of polychlorinated dibenzo-p-dioxins (PCDDs) by AhR receptors and to formulate an hypothesis on the signal transduction mechanism.
Subject(s)
Polychlorinated Dibenzodioxins/analogs & derivatives , Polychlorinated Dibenzodioxins/metabolism , Receptors, Aryl Hydrocarbon/metabolism , Amino Acid Sequence , Binding Sites , Models, Molecular , Molecular Sequence Data , Protein Structure, Secondary , Receptors, Aryl Hydrocarbon/chemistryABSTRACT
The organic fraction of a sludge from a wastewater biological treatment plant is characterized by the total organic carbon, TOC, content, cyclohexane and toluene extractions, and thermal desorptions in nitrogen and air flow at different temperatures. The inorganic fraction is characterized by water extraction, FT-IR spectroscopy, thermogravimetric analysis, and scanning electron microscopy/energy dispersion X-ray analysis. The thermal degradation rate of organic carbon is studied in batch experiments in air, in the 250-500 degrees C temperature range. The sample TOC is used to measure the decrease of reagent concentration with time. The TOC vs time data are well fitted by a generalized kinetic model, previously proposed for the MSWIs fly ash thermal degradation. The rate constants of the immediate carbon gasification, k2, and of the dissociative oxygen chemisorption, k1, followed by C(O) intermediate gasification, k3, together with activation and thermodynamic parameters are calculated. The rate determining step is the C(O) oxidation. The influence of desorbed or extracted organic compounds on kinetics and the role of the C(O) formation in explaining the reaction mechanism as well as the comparison with fly ash kinetics are discussed.
Subject(s)
Refuse Disposal , Sewage/chemistry , Waste Disposal, Fluid , Gases , Incineration , Kinetics , Organic Chemicals , Oxidation-Reduction , Oxygen , Spectroscopy, Fourier Transform Infrared , TemperatureABSTRACT
The synergy of the micro FT-IR (Fourier Transform-Infrared) and SEM-EDX (Scanning Electron Microscopy-Energy Dispersive X-ray) techniques has been shown to be particularly helpful and effective for the characterization of inorganic compounds in fly ashes. The experimental data obtained by these techniques have been interpreted in comparison with those of other techniques. The presence of calcium carbonate, some sulfates, ammonium nitrate, calcium hydrogen phosphate, some chlorides, some oxides and aluminium silicates have been verified.
Subject(s)
Carbon/analysis , Refuse Disposal , Aluminum Silicates/analysis , Calcium Carbonate/analysis , Calcium Phosphates/analysis , Chlorides/analysis , Coal Ash , Industrial Waste , Italy , Microscopy, Electron, Scanning , Nitrates/analysis , Oxides/analysis , Particulate Matter , Spectroscopy, Fourier Transform Infrared , Sulfates/analysisABSTRACT
A methodology based on molecular modeling and chemometrics is applied to identify the geometrical pharmacophore and the stereoelectronic requirements for the activity in a series of inhibitors of 3-hydroxy 3-methylglutaryl coenzyme A (HMG-CoA) reductase, an enzyme involved in cholesterol biosynthesis. These inhibitors present two common structural features - a 3,5-dihydroxy hepatanoic acid which mimics the active portion of the natural substrate HMG-CoA and a lipophilic region which carries both polar and bulky groups. A total of 432 minimum energy conformations of 11 homologous compounds showing different levels of biological activity are calculated by the molecular mechanics MM2 method. Five atoms are selected as representatives of the relevant fragments of these compounds and three interatomic distances, selected among 10 by means of a Principal Component Analysis (PCA), are used to describe the three-dimensional disposition of these atoms. A cluster analysis procedure, performed on the whole set of conformations described by these three distances, allows the selection of one cluster whose centroid represents a geometrical model for the HMG-CoA reductase pharmacophore and the conformations included are candidates as binding conformations. To obtain a refinement of the geometrical model and to have a better insight into the requirements for the activity of these inhibitors, the Molecular Electrostatic Potential (MEP) distributions are determined by the MNDO semiempirical method.