Understanding Yb3+-sensitized photon avalanche in Pr3+ co-doped nanocrystals: modelling and optimization.

Among different upconversion processes where the emitted photon has higher energy than the one absorbed, photon avalanche (PA) is unique, because the luminescence intensity increases by 2-3 orders of magnitude in response to a tiny increase in excitation intensity. Since its discovery in 1979, PA has been observed in bulk materials but until recently, obtaining it at the nanoscale has been a significant challenge. In the present work, the PA phenomenon in ß-NaYF4 colloidal nanocrystals co-doped with Pr3+ and Yb3+ ions was successfully observed at 482 nm (3P0 → 3H4) and 607 nm (3P0 → 3H6) under excitation at 852 nm. The impact of Pr3+ ion concentration and pump power dependence on PA behavior was investigated, i.e. PA non-linearity slopes of luminescence intensity curves as a function of pump power density as well as PA thresholds. The highest slopes, namely 8.6 and 9.0, and the smallest thresholds equal to 286 kW cm-2 and 281 kW cm-2, observed for emission bands at 607 nm and 482 nm, respectively, were obtained for NaYF4:0.5%Pr3+,15%Yb3+@NaYF4 colloidal nanocrystals. Besides experimental research, simulations of PA behavior in Pr3+, Yb3+ co-doped materials were performed based on differential rate equations describing the phenomena that contribute to the existence of PA. The influence of different processes leading to PA, e.g. the rates of nonradiative and radiative transitions as well as energy transfers, on PA performance was simulated aiming to understand their roles in this complex sensitized system.

Quantitative Comparison of the Light-to-Heat Conversion Efficiency in Nanomaterials Suitable for Photothermal Therapy.

Functional colloidal nanoparticles capable of converting between various energy types are finding an increasing number of applications. One of the relevant examples concerns light-to-heat-converting colloidal nanoparticles that may be useful for localized photothermal therapy of cancers. Unfortunately, quantitative comparison and ranking of nanoheaters are not straightforward as materials of different compositions and structures have different photophysical and chemical properties and may interact differently with the biological environment. In terms of photophysical properties, the most relevant information to rank these nanoheaters is the light-to-heat conversion efficiency, which, along with information on the absorption capacity of the material, can be used to directly compare materials. In this work, we evaluate the light-to-heat conversion properties of 17 different nanoheaters belonging to different groups (plasmonic, semiconductor, lanthanide-doped nanocrystals, carbon nanocrystals, and metal oxides). We conclude that the light-to-heat conversion efficiency alone is not meaningful enough as many materials have similar conversion efficiencies─in the range of 80-99%─while they significantly differ in their extinction coefficient. We therefore constructed their qualitative ranking based on the external conversion efficiency, which takes into account the conventionally defined light-to-heat conversion efficiency and its absorption capacity. This ranking demonstrated the differences between the samples more meaningfully. Among the studied systems, the top-ranking materials were black porous silicon and CuS nanocrystals. These results allow us to select the most favorable materials for photo-based theranostics and set a new standard in the characterization of nanoheaters.

Laser Refrigeration by an Ytterbium-Doped NaYF4 Microspinner.

Thermal control of liquids with high (micrometric) spatial resolution is required for advanced research such as single molecule/cell studies (where temperature is a key factor) or for the development of advanced microfluidic devices (based on the creation of thermal gradients at the microscale). Local and remote heating of liquids is easily achieved by focusing a laser beam with wavelength adjusted to absorption bands of the liquid medium or of the embedded colloidal absorbers. The opposite effect, that is highly localized cooling, is much more difficult to achieve. It requires the use of a refrigerating micro-/nanoparticle which should overcome the intrinsic liquid heating. Remote monitoring of such localized cooling, typically of a few degrees, is even more challenging. In this work, a solution to both problems is provided. Remote cooling in D2 O is achieved via anti-Stokes emission by using an optically driven ytterbium-doped NaYF4 microparticle. Simultaneously, the magnitude of cooling is determined by mechanical thermometry based on the analysis of the spinning dynamics of the same NaYF4 microparticle. The angular deceleration of the NaYF4 particle, caused by the cooling-induced increase of medium viscosity, reveals liquid refrigeration by over -6 K below ambient conditions.

Enhancing FRET biosensing beyond 10 nm with photon avalanche nanoparticles.

Förster Resonance Energy Transfer (FRET) between donor (D) and acceptor (A) molecules is a phenomenon commonly exploited to study or visualize biological interactions at the molecular level. However, commonly used organic D and A molecules often suffer from photobleaching and spectral bleed-through, and their spectral properties hinder quantitative analysis. Lanthanide-doped upconverting nanoparticles (UCNPs) as alternative D species offer significant improvements in terms of photostability, spectral purity and background-free luminescence detection, but they bring new challenges related to multiple donor ions existing in a single large size UCNP and the need for nanoparticle biofunctionalization. Considering the relatively short Förster distance (typically below 5-7 nm), it becomes a non-trivial task to assure sufficiently strong D-A interaction, which translates directly to the sensitivity of such bio-sensors. In this work we propose a solution to these issues, which employs the photon avalanche (PA) phenomenon in lanthanide-doped materials. Using theoretical modelling, we predict that these PA systems would be highly susceptible to the presence of A and that the estimated sensitivity range extends to distances 2 to 4 times longer (i.e. 10-25 nm) than those typically found in conventional FRET systems. This promises high sensitivity, low background and spectral or temporal biosensing, and provides the basis for a radically novel approach to combine luminescence imaging and self-normalized bio-molecular interaction sensing.

Single-Cell Biodetection by Upconverting Microspinners.

Near-infrared-light-mediated optical tweezing of individual upconverting particles has enabled all-optical single-cell studies, such as intracellular thermal sensing and minimally invasive cytoplasm investigations. Furthermore, the intrinsic optical birefringence of upconverting particles renders them light-driven luminescent spinners with a yet unexplored potential in biomedicine. In this work, the use of upconverting spinners is showcased for the accurate and specific detection of single-cell and single-bacteria attachment events, through real-time monitoring of the spinners rotation velocity of the spinner. The physical mechanisms linking single-attachment to the angular deceleration of upconverting spinners are discussed in detail. Concomitantly, the upconversion emission generated by the spinner is harnessed for simultaneous thermal sensing and thermal control during the attachment event. Results here included demonstrate the potential of upconverting particles for the development of fast, high-sensitivity, and cost-effective systems for single-cell biodetection.

Spectral properties of Tm3+ doped NaYF4 up-converting nanoparticles under single and double photoexcitation wavelengths.

As soon as excited long-living levels of lanthanides become populated, numerous novel photoexcitation schemes may become available. It paves the way to numerous new possibilities or applications, such as up-conversion (UC) enhancement or intentional depletion towards stimulated emission depletion microscopy (STED). However, this type of studies requires the possibility of performing power dependent measurements upon both single and double photoexcitation. In this article a newly developed setup for double photoexcitation is presented together with preliminary data of Tm3+ doped NaYF4 nanoparticles with different composition and concentration. The results demonstrate different susceptibility of Tm3+ luminescence to numerous factors, such as chemical architecture (composition and design) of the nanoparticles as well as relative photoexcitation intensity at different wavelengths (∼800 nm and 1064 nm).

Near-infrared excited luminescence and in vitro imaging of HeLa cells by using Mn2+ enhanced Tb3+ and Yb3+ cooperative upconversion in NaYF4 nanocrystals.

Advanced biodetection and bioimaging require fluorescent labels which exhibit many, easily distinguishable colors to identify or study numerous biotargets in a single sample. Although numerous different colors have been demonstrated with lanthanide doped nanoparticles, these colors usually originate from various ratios of overlapping multiple emission bands from activators, which severely limits the number of available labels. As a consequence, different lanthanide doped labels cannot be easily distinguished from each other (e.g. Er3+ from Ho3+) in a quantitative way, when such labels are co-localized during microscopy wide-field imaging. It is therefore reasonable to expand the available choice of spectral signatures and not rely on just different colors. Other ions, such as Tb3+ or Eu3+, can offer new possibilities and unique spectral features in upconversion mode in this respect. For example, despite partial overlap with Er3+ or Ho3+ emission spectra, Tb3+ ions display also unique and easily distinguishable spectral features at 580 nm. Unfortunately, in terms of brightness, Tb3+ emission in upconversion mode is typically too weak to be useful. To improve the Tb3+ upconversion emission intensity, a new approach, i.e. Mn2+ co-doping, has been proposed and verified in this work. A versatile optimization of Tb3+, Yb3+ and Mn2+ ion concentrations has been performed based on luminescence spectra and lifetime studies. The most intense emission was achieved for nanoparticles doped with 10% Mn2+ ions, with over 30 times brighter intensity of Tb3+ ions compared to the emission of nanocrystals without the addition of Mn2+ ions. Additionally, as a proof of the concept, the surface of nanoparticles was coated with proteins and conjugated with folic acid, and such biofunctionalized nanoparticles were subsequently used for bioimaging of HeLa cells.

Optical Forces at the Nanoscale: Size and Electrostatic Effects.

The reduced magnitude of the optical trapping forces exerted over sub-200 nm dielectric nanoparticles complicates their optical manipulation, hindering the development of techniques and studies based on it. Improvement of trapping capabilities for such tiny objects requires a deep understanding of the mechanisms beneath them. Traditionally, the optical forces acting on dielectric nanoparticles have been only correlated with their volume, and the size has been traditionally identified as a key parameter. However, the most recently published research results have shown that the electrostatic characteristics of a sub-100 nm dielectric particle could also play a significant role. Indeed, at present it is not clear what optical forces depend. In this work, we designed a set of experiments in order to elucidate the different mechanism and properties (i.e., size and/or electrostatic properties) that governs the magnitude of optical forces. The comparison between experimental data and numerical simulations have shown that the double layer induced at nanoparticle's surface, not considered in the classical description of nanoparticle's polarizability, plays a relevant role determining the magnitude of the optical forces. Here, the presented results constitute the first step toward the development of the dielectric nanoparticle over which enhanced optical forces could be exerted, enabling their optical manipulation for multiples purposes ranging from fundamental to applied studies.

Shaping Luminescent Properties of Yb3+ and Ho3+ Co-Doped Upconverting Core-Shell ß-NaYF4 Nanoparticles by Dopant Distribution and Spacing.

At the core of luminescence color and lifetime tuning of rare earth doped upconverting nanoparticles (UCNPs), is the understanding of the impact of the particle architecture for commonly used sensitizer (S) and activator (A) ions. In this respect, a series of core@shell NaYF4 UCNPs doped with Yb3+ and Ho3+ ions are presented here, where the same dopant concentrations are distributed in different particle architectures following the scheme: YbHo core and YbHo@…, …@YbHo, Yb@Ho, Ho@Yb, YbHo@Yb, and Yb@YbHo core-shell NPs. As revealed by quantitative steady-state and time-resolved luminescence studies, the relative spatial distribution of the A and S ions in the UCNPs and their protection from surface quenching has a critical impact on their luminescence characteristics. Although the increased amount of Yb3+ ions boosts UCNP performance by amplifying the absorption, the Yb3+ ions can also efficiently dissipate the energy stored in the material through energy migration to the surface, thereby reducing the overall energy transfer efficiency to the activator ions. The results provide yet another proof that UC phosphor chemistry combined with materials engineering through intentional core@shell structures may help to fine-tune the luminescence features of UCNPs for their specific future applications in biosensing, bioimaging, photovoltaics, and display technologies.

The impact of shell host (NaYF4/CaF2) and shell deposition methods on the up-conversion enhancement in Tb³âº, Yb³âº codoped colloidal α-NaYF4 core-shell nanoparticles.

Lanthanide doped, up-converting nanoparticles have found considerable interest as luminescent probes in the field of bio-detection. Although the nanoparticles (NPs) have already been successfully applied for fluorescent bio-imaging and bio-assays, the efficiency of the up-conversion process seems to be the bottle-neck in rigorous applications. In this work, we have shown enhancement of the up-conversion in colloidal α-NaYF4:Yb(3+), Tb(3+) doped nanocrystals owing to passivation of their surface. We have studied quantitatively the influence of the shell type (NaYF4 and CaF2), its thickness, as well as the shell deposition method (i.e. single thick shell vs. multi-layer shell) on the luminescent properties of the nanoparticles. The results showed that up to 40-fold up-conversion intensity enhancement may be obtained for the core-shell nanoparticles in comparison with the bare core nanoparticles, irrespective of the shell type and deposition method. Moreover, the suitability of the NaYF4:Yb(3+), Tb(3+) core-shell NPs for multi-color emission and spectral multiplexing has been presented.