ABSTRACT
In order to further realize the resource reuse of walnut meal after oil extraction, walnut meal was used as raw material to prepare polypeptide, and its angiotensin-converting enzyme (ACE) inhibitory activity was investigated. The ACE inhibitory peptides were prepared from walnut meal protein by alkaline solution and acid precipitation. The hydrolysis degree and ACE inhibition rate were used as indexes to optimize the preparation process by single-factor experiment and response surface method. The components with the highest ACE activity were screened by ultrafiltration, and their antioxidant activities were evaluated in vitro. The effect of gastrointestinal digestion on the stability of walnut peptide was analyzed by measuring molecular weight and ACE inhibition rate. The results showed that the optimal extraction conditions were pH 9.10, hydrolysis temperature 54.50 °C, and hydrolysis time 136 min. The ACE inhibition rate of walnut meal hydrolysate (WMH) prepared under these conditions was 63.93% ± 0.43%. Under the above conditions, the fraction less than 3 kDa showed the highest ACE inhibitory activity among the ACE inhibitory peptides separated by ultrafiltration. The IC50 value of scavenging ·OH free radical was 1.156 mg/mL, the IC50 value of scavenging DPPH free radical was 0.25 mg/mL, and the IC50 value of scavenging O2- was 3.026 mg/mL, showing a strong total reducing ability. After simulated gastrointestinal digestion in vitro, the ACE inhibitory rate of walnut peptide decreased significantly, but it still maintained over 90% ACE inhibitory activity. This study provides a reference for the application of low-molecular-weight walnut peptide as a potential antioxidant and ACE inhibitor.
ABSTRACT
The ultrasonic-assisted extraction (UAE) method was employed to separate Cinnamomum camphora proanthocyanidin-rich extracts (PCEs). This extraction process was optimized by the Box-Behnken design, and the optimal conditions, on a laboratory scale, were as follows: an ethanol concentration of 75%, a liquid-to-solid ratio of 24 mL/g, an ultrasonic time of 39 min, and an ultrasonic power of 540 W. Under the obtained conditions, the PCE yield extracted by UAE was higher than that from heat reflux extraction and soaking extraction. An ultra-performance liquid chromatography-tandem mass spectrometry analysis was employed to characterize the phloroglucinolysis products of the C. camphora PCEs, by which epigallocatechin, catechin, epicatechin, and (-)-epigallocatechin-3-O-gallate were identified as the terminal units; epigallocatechin, epicatechin, and (-)-epigallocatechin-3-O-gallate were recognized as extension units. The C. camphora PCEs possessed higher anti-ultraviolet activity in vitro compared with the commercially available sunscreen additive of benzophenone with respect to their ethanol solutions (sun protection factor of 27.01 ± 0.68 versus 1.96 ± 0.07 at a concentration of 0.09 mg/mL) and sunscreens (sun protection factor of 17.36 ± 0.62 versus 14.55 ± 0.47 at a concentration of 20%). These results demonstrate that C. camphora PCEs possess an excellent ultraviolet-protection ability and are promising green sunscreen additives that can replace commercial additives.
Subject(s)
Catechin , Cinnamomum camphora , Proanthocyanidins , Ultrasonics , Sunscreening Agents , Ethanol/chemistry , Plant Extracts/pharmacology , Plant Extracts/chemistryABSTRACT
An aqueous enzymatic-ultrasound cavitation extraction (AEUCE) method was developed to separate Sapium sebiferum seed kernel oil. In this process, neutral proteinase was screened as the propriate enzyme. The Plackett-Burman and Box-Behnken designs were employed to optimize AEUCE. We determined the optimal extraction conditions, producing an oil yield of 84.22 ± 3.17 %. Gas chromatography-mass spectrometry (GC-MS) analysis indicated that the S. sebiferum seed kernel oil was abundant in unsaturated fatty acids (>92 %) and that the compositions of the fatty acid profiles extracted by AEUCE were similar to those obtained from Soxhlet extraction, but their contents were slightly different. The physicochemical properties analysis showed that the oil extracted by AEUCE was comparable to that obtained from Soxhlet extraction. The results showed that the developed AEUCE is an efficient technique that can separate high-quality plant oils. The S. sebiferum seed kernel oil obtained from this extraction method is a promising substitute for vegetable oils used in biodiesel production.
Subject(s)
Euphorbiaceae , Water/chemistry , Plant Oils/chemistry , Seeds/chemistry , Fatty Acids/analysisABSTRACT
Odor is an important characteristic of walnut oil; walnut oil aromas from different varieties smell differently. In order to compare the differences of volatile flavor characteristics in different varieties of walnut oil, the volatile organic compounds (VOCs) of walnut oil from five different walnut varieties in Northwest China were detected and analyzed using headspace gas chromatography-ion mobility spectrometry (HS-GC-IMS). The results showed that 41 VOCs in total were identified in walnut oil from five different varieties, including 14 aldehydes, 8 alcohols, 4 ketones, and 2 esters. Walnut oil (WO) extracted from the "Zha343" variety was most abundant in VOCs. The relative odor activity value (ROAV) analysis showed that aldehydes were the main aroma substances of walnut oil; specifically, hexanal, pentanal, and heptanal were the most abundant. Fingerprints and heat map analysis indicated that WO extracted from the "Xin2", "185", "Xin'guang", and "Zha343" varieties, but not from the "Xinfeng" variety, had characteristic markers. The relative content differences of eight key VOCs in WO from five varieties can be directly compared by Kruskal-Wallis tests, among which the distribution four substances, hexanal (M), hexanal (D), pentanal (M), (E)-2-hexanal (M), presented extremely significant differences (P<0.01). According to the results of the principal component analysis (PCA), WO extracted from the "Zha343" variety was distinct from the other four varieties; in addition, WO extracted from the "Xin2" variety exhibited similarity to WO extracted from the "185" variety, and WO extracted from the "Xinfeng" variety showed similarity to WO extracted from the "Xin'guang" variety. These results reveal that there are certain differences in the VOCs extracted from five different WO varieties, making it feasible to distinguish different varieties of walnut oil or to rapidly detect walnut oil quality based on its volatile substances profile.
Subject(s)
Juglans , Volatile Organic Compounds , Gas Chromatography-Mass Spectrometry/methods , Volatile Organic Compounds/analysis , Ion Mobility Spectrometry/methods , Aldehydes/analysisABSTRACT
The carbohydrate is the main ingredient of purple sweet potato. A polysaccharide, named PSP, was separated and purified from purple sweet potato by extraction with hot water, precipitation with ethanol, deproteinization with Sevag reagent and column chromatography with Sephadex G-100. The purity and structure were studied with HPLC, UV-Vis, GC-MS and NMR. The PSP is a neutral polysaccharide with Mw of 470 kDa. The monosaccharide composition of PSP contained D-xylose, d-glucose, D-galactose with ratio of 1.0: 8.3: 1.3. The backbone of PSP was composed of the residues of â6)-D-Glcp-(1 â and â2, 6)-D-Glcp-(1â. The branches of PSP contained the residues of â3)-D-Galp-(1â, and D-Xylp-(1â. The antitumor activity in vitro of PSP was analyzed with HT-29 cells. And the SEM, AO staining, MDC staining and hoechst 33342 staining were performed to study the effect on apoptosis of HT-29 cells by PSP. The results revealed that the PSP can significantly inhibit the proliferation of HT-29 cells from induction apoptosis. The manuscript provided valuable knowledges on structural characteristics of the polysaccharides from purple sweet potato.
Subject(s)
Ipomoea batatas , Ipomoea batatas/chemistry , Polysaccharides/pharmacology , Polysaccharides/chemistry , Antioxidants/chemistry , Glucose , Monosaccharides/chemistryABSTRACT
Catalyst deactivation is a problem of great concern for many heterogeneous reactions. Here, an urchin-like LaPO4 catalyst was easily developed for pentane-2,3-diol dehydration; it has an impressive ability to restore the activity inâ situ by itself during the reaction, accounting for its high stability. This facilitates the efficient production of renewable penta-1,3-diene from pentane-2,3-dione via a novel approach, where penta-2,3-diol was obtained as an intermediate in 95 % yield under mild conditions.
ABSTRACT
A Brønsted acid ionic liquid, 3-methyl-1-(4-sulfonylbutyl) imidazolium hydrogensulfate ([HO3S(CH2)4mim]HSO4), was used for the first time for the preparation of a sulfonated carbon catalyst. The catalyst was prepared from the residue obtained after recovery of the essential oil from the leaves of Cinnamomum longepaniculatum. The sulfonated carbon catalyst with an amorphous structure attained high acidic efficiency at a sulfonation temperature of 200 °C for 2 h of sulfonation time, and was characterised. SEM morphologies revealed that the carbon catalyst consisted of uniform carbon microspores. FTIR analysis, elemental analysis, and X-ray photoelectron spectroscopy revealed that the sulfonic acid group was successfully introduced on the surface of the sulfonated carbon catalyst. The result of TG analysis showed that the obtained sulfonated carbon catalyst has high thermal stability. Good acid and catalytic activity of the obtained sulfonated carbon catalyst were observed for the preparation of ellagic acid and gallic acid, which is comparable to those of diluted sulfuric acid and a sulfonated carbon catalyst that had been prepared with concentrated sulfuric acid. The excellent reusability of the sulfonated carbon catalyst was also confirmed by repeated experimental trials. In summary, the sulfonated catalyst derived from the residue obtained after recovery of essential oil from the leaves of C. longepaniculatum is an economic, eco-benign and promising substitute for traditional mineral acid catalysts for acidic catalysis in industrial applications.
ABSTRACT
Porous carbon is exceptionally useful, but it remains a great challenge to develop a facile route to prepare porous carbon materials with hierarchical structure and enhanced porosity. This work demonstrates a novel synthetic pathway for hierarchical carbonaceous materials (HCM) using isobutene and formaldehyde as carbon precursors via silica templates impregnated with phosphorus. Different from the traditional nanocasting method, the formation of the carbon structure is caused by heavy coke deposits on the solid catalyst in the course of the olefin/aldehyde vapor reaction. The coke-derived carbonaceous materials indicated by transmission electron microscopy (TEM) and nitrogen adsorption-desorption measurement are hierarchically mesoporous structures with a large surface area (971 m2 g-1) and pore volume (1.91 cm3 g-1). We have demonstrated for the first time that the olefin/aldehyde reaction may provide a convenient route to develop a porous carbon texture. The newly developed method may lead to porous carbon having scientific and technological importance in adsorption and catalysis applications.