Three-dimensional spatial analysis of temporomandibular joint in adolescent Class II division 1 malocclusion patients: comparison of Twin-Block and clear functional aligner.

BACKGROUND: Our study aimed to use three-dimensional (3D) spatial morphological measurement methods to compare the influence of Twin-Block and clear functional aligners on the temporomandibular joint (TMJ) of adolescent Class II division 1 malocclusion mandibular retraction patients. We also aimed to explore the similarities and differences in the effects on the TMJ upon using Twin-Block and clear functional aligner. METHODS: Cone-beam computed tomography (CBCT) data of 49 patients with Class II division 1 malocclusion (Twin-Block group: 24; clear functional aligner group: 25) were collected before and after functional orthodontic treatment, and a 3D model of the TMJ was reconstructed using MIMICS 21.0 software. Eighteen measurement parameters, including the anterior, superior, and posterior joint spaces, were measured and compared using the 3D model. RESULTS: After the two groups underwent functional appliance treatment, the height, volume, and surface area of the condyle, length of the mandibular ramus and mandibular length increased; The retro-displaced condyle moved to the middle position of the articular fossa, while the rest of the condylar position did not change significantly. Remodeling of the articular fossa after treatment was not evident. The superior joint space of the clear functional aligner group increased, but there was no significant change after Twin-Block appliances treatment. CONCLUSIONS: Both appliances promote condylar growth and sagittal and vertical development of the mandible in adolescent Class II division 1 malocclusion mandibular retraction patients. The length of the mandibular ramus showed a more significant increase following treatment with the Twin-Block appliances than with clear function aligners.

Computational fluid dynamics simulation of changes in the morphology and airflow dynamics of the upper airways in OSAHS patients after treatment with oral appliances.

OBJECTIVES: To explore the changes of morphology and internal airflow in upper airways (UA) after the use of oral appliances (OAs) in patients with obstructive sleep apnea hypopnea syndrome (OSAHS), and investigate the mechanisms by which OAs function as a therapy for OSAHS. METHODS: Eight OSAHS patients (all male, aged 37-58, mean age 46.25) underwent CT scans before and after OA use. Then, computational fluid dynamics(CFD) models were built on the base of the CT scans using Mimics and ANSYS ICEM CFD software. The internal airflow of the upper airways was simulated using ANSYS-FLUENT and the results were analyzed using ANSYS-CFD-Post. The data were analyzed to identify the most important changes of biomechanical properties between patients with and without OA intervention. Upper airway morphology and the internal airflow changes were compared using t-tests and Spearman correlation coefficient analysis. RESULTS: The narrowest area of upper airways was found to be located in the lower bound of velopharynx, where the volume and pressure were statistically significantly increased (P<0.05) and the air velocity was statistically significantly decreased (P<0.05) in the presence of the OA(P<0.05). After wearing OA, pharyngeal resistance was significantly decreased (P<0.05), from 290.63 to 186.25Pa/L, and the airflow resistance of the pharynx has reduced by 35.9%. CONCLUSION: The enlargement of the upper airway after wearing the OA changed its airflow dynamics, which decreased the negative pressure and resistance in narrow areas of the upper airways. Thus, the collapsibility of the upper airways was reduced and patency was sustained.