ABSTRACT
RATIONALE: The offline coupling of high-performance thin-layer chromatography (HPTLC) with atmospheric solids analysis probe mass spectrometry (ASAP-MS) was evaluated for the characterization of polymeric additives in gasoline. METHODS: A protocol was developed to optimize the ion signal. A glass capillary was moistened with deionized water, and then dipped into silica gel scratched from an HPTLC plate. The capillary tube was fixed to the ASAP holder and introduced into the ionization source for analysis by MS. Silica gel, reversed-phase C18 and cellulose stationary phases were evaluated. RESULTS: The effect of the stationary phase and the nature of analyte were evaluated using polypropylene glycol and polyisobutylene succinimide polyamine as analyte molecules. The optimal ionization conditions are significantly different between ASAP and HPTLC/ASAP-MS analyses. In particular, a higher desorption gas temperature was required to produce ions from the silica gel HPTLC plate. The presence of the stationary phase reduces the internal energy of the ions and limits the fragmentation. CONCLUSIONS: HPTLC/ASAP-MS is a very fast and efficient technique for the analysis of polymers in formulated fuels. Good ionization efficiency was obtained with all investigated stationary phases.
ABSTRACT
Comprehensive two-dimensional gas chromatography (GC × GC) coupled to time-of-flight mass spectrometry is a powerful separation tool for complex petroleum product analysis. However, the most commonly used electron ionization (EI) technique often makes the identification of the majority of hydrocarbons impossible due to the exhaustive fragmentation and lack of molecular ion preservation, prompting the need of soft-ionization energies. In this study, three different soft-ionization techniques including photo ionization (PI), chemical ionization (CI), and field ionization (FI) were compared against EI to elucidate their relative capabilities to reveal different base oil hydrocarbon classes. Compared with EI (70 eV), PI (10.8 eV) retained significant molecular ion (M+· ) information for a large number of isomeric species including branched-alkanes and saturated monocyclic hydrocarbons along with unique fragmentation patterns. However, for bicyclic/polycyclic naphthenic and aromatic compounds, EI played upper hand by retaining molecular as well as fragment ions to identify the species, whereas PI exhibited mainly molecular ion signals. On the other hand, CI revealed selectivity towards different base oil groups, particularly for steranes, sulfur-containing thiophenes, and esters, yielding protonated molecular ions (M + H)+ for unsaturated and hydride abstracted ions (M-H+ ) for saturated hydrocarbons. FI, as expected, generated intact molecular ions (M+· ) irrespective to the base oil chemical classes. It allowed elemental composition by TOFMS with a mass resolving power up to 8000 (FWHM) and a mass accuracy of 1 mDa, leading to the calculation of heteroatomic content, double bond equivalency, and carbon number of the compounds. The qualitative and quantitative results presented herein offer a unique perspective into the detailed comparison of different ionization techniques corresponding to several hydrocarbon classes.
ABSTRACT
Polyalphaolefins (PAOs) are saturated alpha olefin oligomers used as a base stock oil for synthetic lubricants. The synthetic base stocks are manufactured from linear alpha olefins by catalytic oligomerization processes. The aim of this work was the characterization of different PAO grades, synthesized from different linear alpha olefins using two oligomerization processes, acid and metallocene catalyses. Negative ion atmospheric pressure photoionization (APPI) coupled with ion mobility spectrometry-mass spectrometry (IMS-MS) permitted the detection of intact PAO adducts with either chloride, bromide or iodide ions using halogenated solvents (e.g. dichloromethane, dibromomethane and diiodomethane) and toluene as the dopant. The best signal-to-noise ratio was obtained with dichloromethane. The APPI mass spectra displayed characteristic ion distributions for high viscosity PAO grades. The mass shift between two adjacent ions permitted the identification of repeating units and consequently the monomers of alpha olefins used to manufacture the PAO. For low PAO grades, the halide anion adducts were not detected as they are less stable. The IMS-MS data, as well as the correlated variables, i.e. the drift time and full width at half maximum (FWHM) of the IMS peaks, can be used to differentiate polyalphaolefins of the same grade but differently synthesized.
ABSTRACT
Polyalphaolefins (PAOs) are polymers produced from linear alpha olefins through catalytic oligomerization processes. The PAOs are known as synthetic high-performance base stock fluids used to improve the efficiency of many other synthetic products. In this study, we report the direct characterization of PAOs using atmospheric solid analysis probe (ASAP) coupled with ion mobility spectrometry-mass spectrometry (IMS-MS). We studied different PAOs grades exhibiting low- and high-viscosity index. Specific adjustments of the ASAP source parameters permitted the monitoring of ionization processes as three mechanisms could occur for these compounds: hydride abstraction, nitrogen addition, and/or the formation of [M-2H]+⢠ions. Several series of fragment ions were obtained, which allowed the identification of the alpha olefin used to synthesize the PAO. The use of the ion mobility separation dimension provides information on isomeric species. In addition, the drift time versus m/z plots permitted rapid comparison between PAO samples and to evidence their complexity. These 2D plots appear as fingerprints of PAO samples. To conclude, the resort to ASAP-IMS-MS provides a rapid characterization of the PAO samples in a direct analysis approach, without any sample preparation. Graphical Abstract á .
ABSTRACT
The characterization of organic mixtures by comprehensive two-dimensional gas chromatography (GC×GC) coupled to electron impact (EI) ionization time-of-flight mass spectrometry (TOF-MS) allows the detection of thousands of compounds. However, owing to the exhaustive fragmentation following EI ionization, despite the use of mass spectral libraries, a majority of the compounds remains unidentified because of the lack of parent ion preservation. Thus, soft-ionization energies leading to organic compounds being ionized with limited or no fragmentation, retaining the molecular ion, has been of interest for many years. In this study, photoionization (PI) was evaluated as the ion source for GC×GC-TOF-MS measurements. First, capabilities and limitations of PI were tested using an authentic mixture of compounds of several chemical classes. Ionization energy exhibited by PI, equivalent to 10.8 eV, resulted in significant retention of molecular ion information; [M]+⢠for alkanes, ketones, FAMEs, aromatics, [M-H]+⢠for chloroalkanes, and [M-H2O]+⢠for alcohols. Second, considering the potential of PI for hydrocarbons, base oils, complex mixtures of saturated and unsaturated hydrocarbons blended for finished lubricant formulations, were extensively evaluated. Several chemical classes of hydrocarbons were positively identified including a large number of isomeric compounds, both aliphatics and cyclics. Interestingly, branched-alkanes were ionized with lower excess internal energy, not only retaining the molecular ions but also exhibiting unique fragmentation patterns. The results presented herein offer a unique perspective into the detailed molecular characterization of base oils. Such unprecedented identification power of PI coupled with GC×GC-TOF-MS is the first report covering volatiles to low-volatile organic mixtures.
ABSTRACT
Formulated lubricants are complex mixtures composed of base oil(s) and additives with various functions (detergents, corrosion inhibiter, antioxidant, viscosity modifiers, etc.). Because of the aliphatic nature of base oil and the chemical diversity of additives, the characterization of lubricant is currently a long and complex process. The comprehensive analysis of lubricant samples involves several techniques such as nuclear magnetic resonance, mass spectrometry, chromatography and infrared spectroscopy. The coupling of atmospheric solid analysis probe (ASAP) with ion mobility-mass spectrometry (IM-MS) has been shown to be an efficient tool for the characterization of complex mixture containing vaporizable polar to non-polar compounds. This approach affords the coupling of a direct ionization technique that does not require sample preparation, with a bi-dimensional separation method with high peak capacity. In this work, we show that ASAP-IM-MS is a suitable method for rapid and direct characterization of lubricant samples. Indeed, base oil and additives yielded, by ASAP, ions series which could be separated by IM-MS. Molecular additives such as Zn-dithiocarbamate, phosphite, thiophosphate and Alkyl diphenylamine were ionized as molecular ions [M](+â¢) or protonated molecules [M + H](+), depending of their polarity. In some cases, fragment ions were observed, confirming the additive identification. In addition, high molecular weight polymeric additives such as poly(alkyl methacrylate) (PAM) were pyrolized in the ASAP source leading to characteristic fragment ions. ASAP-IM-MS is shown to be a powerful tool for studying complex mixtures, allowing the first comprehensive analysis of lubricants in just a few minutes.
ABSTRACT
The use of visible absorbing and fluorescent tags for sensing and structural analysis of carbohydrates is a promising route in a variety of medical, diagnostic, and therapeutic contexts. Here we report an easy method for covalent attachment of nonfluorescent push-pull chromophores based on the 4-cyano-5-dicyanomethylene-2-oxo-3-pyrroline ring to carbohydrate moieties. The impact of sugar grafting on the optical properties of the push-pull chromophore in the gas phase and in solution was investigated by absorption and action spectroscopy and theoretical methods. The labeled sugars efficiently absorb photons in the visible range, as demonstrated by their intense photodissociation in a quadrupole ion trap. A strong blue shift (-70 nm) of the gas-phase photodissociation intensity maximum is observed upon sugar grafting, whereas no such effect is visible on the solution absorption spectra. Molecular dynamics simulations of labeled maltose in the gas phase describe strong interactions between the sulfonated chromophore and the carbohydrate, which lead to cyclic conformations. These are not observed in the simulations with explicit solvation. Time-dependent density functional theory (TD-DFT) calculations on model molecules permit us to attribute the observed shift to the formation of such cyclic conformations and to the displacement of the negative charge relative to the aromatic moiety of the chromophore.
Subject(s)
Carbohydrates/chemistry , Models, Theoretical , Gases/chemistry , Maltose/chemistry , Molecular Dynamics Simulation , Solutions/chemistry , Spectrophotometry, UltravioletABSTRACT
The development of strategies based on mass spectrometry to help for deep structural analysis of acidic oligosaccharides remains topical. We thus examined the dissociation behavior of deprotonated ions of heparin-derived di- to tetra-saccharides under UV irradiation at 220 nm. Depending on the ionization state of the carboxylic groups, an oxidized species issued from electron photodetachment was observed in complement to photoinduced fragmentation of precursor ions. The influence of the charge location in the oligosaccharide dianions on the balance between photodissociation and electron photodetachment is examined and a way to direct the relaxation pathways, (i.e., dissociation versus electron detachment), is proposed using sodium adducts. The oxidized species was subjected to activated-electron photodetachment (activated-EPD) leading to complementary informative fragment ions to those issued from photodissociation. Directed photoinduced dissociation at 220 nm and activated-EPD should complement the more conventional CAD and IRMPD activation modes for deeper structural analysis of acidic oligosaccharides-derived anions.
Subject(s)
Heparin/chemistry , Mass Spectrometry/methods , Oligosaccharides/chemistry , Heparin/radiation effects , Hydrogen-Ion Concentration , Oligosaccharides/radiation effects , Photochemistry/methods , Ultraviolet RaysABSTRACT
A set of three heparin-derived disaccharide deprotonated ions was isolated in a linear ion trap and subjected to UV laser irradiation in the 220-290 nm wavelength range. The dissociation yields of the deprotonated molecular ions were recorded as a function of laser wavelength. They revealed maximum absorption at 220 nm for the nonsulfated disaccharide, but centered at 240 nm for the sulfated species. The comparison of the fragmentation patterns between ultraviolet photodissociation (UVPD) at 240 nm and CID modes showed roughly the same distribution of fragment ions resulting from glycosidic bond cleavages. Interestingly, UVPD favored additional cross ring cleavages of A and X type ion series enabling easier sulfate group location. It also reduced small neutral losses (H(2)O).