ABSTRACT
There is an urgent need for disinfection and sterilization devices accessible to the public that can be fulfilled by innovative strategies for using cold atmospheric pressure plasmas. Here, we demonstrate a successful novel combination of a flexible printed circuit design of a dielectric barrier discharge (flex-DBD) with an environmentally safe chemical reagent for surface decontamination from bacterial contaminants. Flex-DBD operates in ambient air, atmospheric pressure, and room temperature without any additional gas flow at a power density not exceeding 0.5 W/cm2. The flex-DBD activation of a 3% hydrogen peroxide solution results in the reduction in the bacterial load of a surface contaminant of > 6log10 in 90 s, about 3log10 and 2log10 better than hydrogen peroxide alone or the flex-DBD alone, respectively, for the same treatment time. We propose that the synergy between plasma and hydrogen peroxide is based on the combined action of plasma-generated OH· radicals in the hydrogen peroxide solution and the reactive nitrogen species supplied by the plasma effluent. A scavenger method verified a significant increase in OH· concentration due to plasma treatment. Novel in-situ FTIR absorption spectra show the presence of O3, NO2, N2O, and other nitrogen species. Ozone dissolving in the H2O2 solution can effectively generate OH· through a peroxone process. The addition of the reactive nitrogen species increases the disinfection efficiency of the hydroxyl radicals and other oxygen species. Hence, plasma activation of a low concentration hydrogen peroxide solution, using a hand-held flexible DBD device results in a dramatic improvement in disinfection.
Subject(s)
Disinfectants/chemistry , Hydrogen Peroxide/chemistry , Escherichia coli/drug effects , Surface PropertiesABSTRACT
In this work, solid targets made from boron and boron nitride (BN) materials are ablated by a nanosecond pulsed laser at sub-atmospheric pressures of nitrogen and helium gases. The excited species in the ablation plume from the target are probed by spatiotemporally resolved optical emission spectroscopy (OES). The evaluation of the chemical composition of the plasma plume revealed that for both boron-rich targets, emission from BN molecules is always observed in nitrogen-rich environments. In addition, BN molecules are also present when ablating a boron nitride target in a helium gas environment, an indication that BN molecules in the plume may originate from the solid target. Furthermore, the ablation of the BN target features emission of B2N molecules, regardless of the pressure and surrounding gas. These results suggest that the ablation of the BN target is more favorable for the generation of complex molecules containing boron and nitrogen species and possibly hint that BN is also more favorable feedstock for high-yield BN nanomaterial synthesis. Plasma parameters such as the electron temperature (peak value of 1.3 eV) and density (peak value of 2 × 1018 cm-3) were also investigated in this work in order to discuss the chemical dynamics in the plume.
ABSTRACT
This corrects the article DOI: 10.1103/PhysRevLett.122.185001.
ABSTRACT
High-yield production of high-quality boron-nitride nanotubes (BNNTs) has been reported recently in several publications. A boron-rich material is evaporated using a laser or plasma in a nitrogen-rich atmosphere to supply precursor gaseous species for nucleation and growth of BNNTs. Either hydrogen was added or pressure was increased in the system to achieve high yield and high purity of the synthesized nanotubes. According to the widely-accepted "root grow" mechanism, upon gas cooling, boron droplets form first, then they adsorb nitrogen from the surrounding gas species, and BNNTs grow on their surfaces. However, what are the precursor species that provide nitrogen for the growth is still an open question. To answer this question, we performed thermodynamic calculations for determining the B-N mixture composition considering a broad set of gas species. For the first time, condensation of boron was taken into account and was shown to have a drastic effect on thegas chemical composition. B2N molecules were identified to be a major source of nitrogen for the growth of BNNTs. The presence of B2N molecules in a B-N gas mixture was verified by our spectroscopic measurements during laser ablation of boron-rich targets in nitrogen. It was shown that the increase of pressure has a quantitative effect on the mixture composition yielding an increase of the precursor density. Hydrogen addition might open an additional channel of nitrogen supply to support the growth of BNNTs. The nitrogen atoms react with abundant H2 molecules to form NH2 and then NH3 precursor species, instead of just recombining back to inert N2 molecules, as in the no-hydrogen case. In addition, thermodynamics was applied in conjunction with agglomeration theory to predict the size of the boron droplets upon growth of BNNTs. Analytical relations for the identification of crucial species densities were derived.
ABSTRACT
Self-organization and anomalous transport in gradient-drift driven turbulence in partially magnetized plasmas with crossed electric and magnetic fields is demonstrated in two-dimensional fluid simulations. The development of large scale structures and flows is shown to occur as a result of the inverse energy cascade from short wavelength instabilities. The turbulence shows complex interaction of small scale modes with large scale zonal flow modes, vortices, and streamers resulting in strongly intermittent anomalous transport that significantly exceeds the classical collisional values. The turbulence driven secondary instabilities and large scale structures are shown to dominate the anomalous electron current. Such anomalous transport and structures are consistent with a number of experimental observations in laboratory plasmas.
ABSTRACT
We have synthesized boron nitride nanotubes (BNNTs) in an arc in the presence of boron and nitrogen species. We find that BNNTs are often attached to large nanoparticles, suggesting that root-growth is a likely mechanism for their formation. Moreover, the tube-end nanoparticles are composed of boron, without transition metals, indicating that transition metals are not necessary for the arc synthesis of BNNTs. To gain further insight into this process we have studied key mechanisms for root growth of BNNTs on the surface of a liquid boron droplet by ab initio molecular dynamics simulations. We find that nitrogen atoms reside predominantly on the droplet surface where they organize to form boron nitride islands below 2400 K. To minimize contact with the liquid particle underneath, the islands assume non-planar configurations that are likely precursors for the thermal nucleation of cap structures. Once formed, the caps are stable and can easily incorporate nitrogen and boron atoms at their base, resulting in further growth. Our simulations support the root-growth mechanism of BNNTs and provide comprehensive evidence of the active role played by liquid boron.
ABSTRACT
Boron nitride nanotubes (BNNTs) were successfully synthesized by a dc arc discharge using a boron-rich anode as synthesis feedstock in a nitrogen gas environment at near atmospheric pressure. The synthesis was achieved independent of the cathode material suggesting that under such conditions the arc operates in so-called anodic mode with the anode material being consumed by evaporation due to the arc heating. To sustain the arc current by thermionic electron emission, the cathode has to be at sufficiently high temperature, which for a typical arc current density of ~100 A/cm2, is above the boron melting point (2350 K). With both electrodes made from the same boron-rich alloy, we found that the arc operation unstable due to frequent sticking between two molten electrodes and formation of molten droplets. Stable and reliable arc operation and arc synthesis were achieved with the boron-rich anode and the cathode made from a refractory metal which has a melting temperature above the melting point of boron. Ex-situ characterization of synthesized BNNTs with electron microscopy and Raman spectroscopy revealed that independent of the cathode material, the tubes are primarily single and double walled. The results also show evidence of root-growth of BNNTs produced in the arc discharge.