Preparation of Cubosomes with Improved Colloidal and Structural Stability Using a Gemini Surfactant.

Cubosomes are nanoparticles with bicontinuous cubic internal nanostructures that have been considered for use in drug delivery systems (DDS). However, their low structural stability is a crucial concern for medical applications. Herein, we investigated the use of a gemini surfactant, sodium dilauramidoglutamide lysine (DLGL), which is composed of two monomeric surfactants linked with a spacer to improve the structural stability of cubosomes prepared with phytantriol (PHY). Uniform nanosuspensions comprising a specific mixing ratio of DLGL and PHY in water prepared via ultrasonication were confirmed by using dynamic light scattering. Small-angle X-ray scattering and cryo-transmission electron microscopy revealed the formation of Pn3̅m cubosomes in a range of DLGL/PHY solid ratios between 1 and 3% w/w. By contrast, cubosome formation was not observed at DLGL/PHY solid ratios of 5% w/w or higher, suggesting that excess DLGL interfered with cubosome formation and caused them to transform into small unilamellar vesicles. The addition of phosphate-buffered saline to the nanosuspension caused aggregation when the solid ratio of DLGL/PHY was less than 5% w/w. However, Im3̅m cubosomes were obtained at solid ratios of DLGL/PHY of 6, 7.5, and 10% w/w. The lattice parameters of the Pn3̅m and Im3̅m cubosomes were approximately 7 and 11-13 nm, respectively. The lattice parameters of Im3̅m cubosomes were affected by the concentration of DLGL. Pn3̅m cubosomes were surprisingly stable for 4 weeks at both 25 and 5 °C. In conclusion, DLGL, a gemini surfactant, was found to act as a new stabilizer for PHY cubosomes at specific concentrations. Cubosomes composed of DLGL are stable under low-temperature storage conditions, such as in refrigerators, making them a viable option for heat-sensitive DDS.

In vivo screening of subcutaneous tolerability for the development of novel excipients.

To develop safe subcutaneous formulations and minimize the risk of local irritation, it is essential to optimize the composition of active pharmaceutical ingredients and excipients. Depending on the physicochemical properties of the active pharmaceutical ingredient, additional excipients may be required to improve the stability and solubility of the active pharmaceutical ingredient. However, some of these excipients may not have been previously used in injectable drugs. Owing to the lack of safety data for such excipients, especially those used in subcutaneous dosing, it is important to evaluate their potential for local irritation during the early stages of formulation development. We evaluated the tolerability of 44 formulations with 24 candidate novel excipients, such as surfactants, polymers, and lipids, in a single subcutaneous dose in rats. Excipient formulations were administered as single bolus subcutaneous injections with an injection volume of 1 mL. The injection sites were observed for 2 days, and macroscopic and microscopic examinations were conducted. Local tolerability was evaluated on the basis of severity, incidence, and pathophysiology of each finding. Formulations that caused tissue degeneration or necrosis, which is indicative of tissue injury, were determined to be irritative and poorly tolerated. A single-dose subcutaneous screening study in rats was considered effective in ranking the safety of candidate excipients during the formulation optimization phase.

Changeable net charge on nanoparticles facilitates intratumor accumulation and penetration.

The Enhanced Permeability and Retention (EPR) effect is a golden strategy for the nanoparticle (NP)-based targeting of solid tumors, and the surface property of NPs might be a determinant on their targeting efficiency. Poly(ethylene glycol) (PEG) is commonly used as a shell material; however, it has been pointed out that PEG-coated NPs may exhibit accumulation near tumor vasculature rather than having homogenous intratumor distribution. The PEG shell plays a pivotal role on prolonged blood circulation of NPs but potentially impairs the intratumor retention of NPs. In this study, we report on a shell material to enhance tumor-targeted delivery of NPs by maximizing the EPR effect: polyzwitterion based on ethylenediamine-based carboxybetaine [PGlu(DET-Car)], which shows the changeable net charge responding to surrounding pH. The net charge of PGlu(DET-Car), is neutral at physiological pH 7.4, allowing it to exhibit a stealth property during the blood circulation; however, it becomes cationic for tissue-interactive performance under tumorous acidic conditions owing to the stepwise protonation behavior of ethylenediamine. Indeed, the PGlu(DET-Car)-coated NPs (i.e., gold NPs in the present study) exhibited prolonged blood circulation and remarkably enhanced tumor accumulation and retention than PEG-coated NPs, achieving 32.1% of injected dose/g of tissue, which was 4.2 times larger relative to PEG-coated NPs. Interestingly, a considerable portion of PGlu(DET-Car)-coated NPs clearly penetrated into deeper tumor sites and realized the effective accumulation in hypoxic regions, probably because the cationic net charge of PGlu(DET-Car) is augmented in more acidic hypoxic regions. This study suggests that the changeable net charge on the NP surface in response to tumorous acidic conditions is a promising strategy for tumor-targeted delivery based on the EPR effect.

An Ethylenediamine-based Switch to Render the Polyzwitterion Cationic at Tumorous pH for Effective Tumor Accumulation of Coated Nanomaterials.

Polyzwitterions are employed as coating polymers for biomaterials to induce an antifouling property on the surface. Fine-tuning the betaine structure switches the antifouling property to be interactive with anionic tissue constituents in response to a tumorous pH gradient. The ethylenediamine moiety in the carboxybetaine enabled stepwise protonation and initiated the di-protonation process around tumorous pH (6.5). The net charge of the developed polyzwitterion (PGlu(DET-Car)) was thus neutral at pH 7.4 for antifouling, but was cationic at pH 6.5 for interaction with anionic constituents. Quantum dots coated with PGlu(DET-Car) exhibited comparable stealth and enhanced tumor accumulation relative to the PEG system. The present study provides a novel design of smart switchable polyzwitterion based on a precise control of the net charge.

Enhancing the Solubility and Oral Bioavailability of Poorly Water-Soluble Drugs Using Monoolein Cubosomes.

Monoolein cubosomes containing either spironolactone (SPI) or nifedipine (NI) were prepared using a high-pressure homogenization technique and characterized in terms of their solubility and oral bioavailability. The mean particle size, polydispersity index (PDI), zeta potential, solubility and encapsulation efficiency (EE) values of the SPI- and NI-loaded cubosomes were determined to be 90.4 nm, 0.187, -13.4 mV, 163 µg/mL and 90.2%, and 91.3 nm, 0.168, -12.8 mV, 189 µg/mL and 93.0%, respectively, which were almost identical to those of the blank cubosome. Small-angle X-ray scattering analyses confirmed that the SPI-loaded, NI-loaded and blank cubosomes existed in the cubic space group Im3̄m. The lattice parameters of the SPI- and NI-loaded cubosomes were 147.6 and 151.6 Å, respectively, making them almost identical to that of blank cubosome (151.0 Å). The in vitro release profiles of the SPI- and NI-loaded cubosomes showed that they released less than 5% of the drugs into various media over 12-48 h, indicating that most of the drug remained encapsulated within the cubic phase of their lipid bilayer. Furthermore, the in vivo pharmacokinetic results suggested that these cubosomes led to a considerable increase in the systemic oral bioavailability of the drugs compared with pure dispersions of the same materials. Notably, the stability results indicated that the mean particle size and PDI values of these cubosomes were stable for at least 4 weeks. Taken together, these results demonstrate that monoolein cubosomes represent promising drug carriers for enhancing the solubility and oral bioavailability of poorly water-soluble drugs.

The use of surfactants to enhance the solubility and stability of the water-insoluble anticancer drug SN38 into liquid crystalline phase nanoparticles.

Cubosomes were used to increase the aqueous solubility of the water insoluble anticancer drug SN38. The results showed that the use of a common cubosome formulation consisting of phytantriol (PHYT) as the matrix amphiphile (PHYT-cubosome) led to a 6-fold increase in the solubility of SN38. However, mean hydrodynamic diameter (DH) and polydispersity index (PDI) of these PHYT-cubosome particles were 345±49nm and 0.37±0.05, respectively, making them unsuitable for intravenous applications. Several additives were investigated to increase the solubility of SN38 and reduce the DH and PDI values of the resulting particles. Charged additives such as didodecyldimethyl ammonium bromide (DDAB) and sodium dodecyl sulfate (SDS) led to improvements in the physiochemical properties of the cubosomes. Notably, the PHYT-DDAB and PHT-SDS cubosomes led to 15- and 14-fold increases in the aqueous solubility of SN38, respectively. Moreover, the SN38 loaded into the PHYT-DDAB and PHYT-SDS cubosomes was found to be highly stable, with very little hydrolysis to its inactive acid form. In summary, the addition of DDAB and SDS to PHYT-cubosome nanoparticle drug delivery systems not only led to considerable improvements in their physiochemical properties, but also enhanced the aqueous solubility of SN38 and increased its chemical stability.

Development of highly stable nifedipine solid-lipid nanoparticles.

To improve the solubility of the drug nifedipine (NI), highly stabilized solid-lipid nanoparticles (SLNs) of nifedipine (NI-SLNs) were prepared by high pressure homogenization using two phospholipids, followed by lyophilization with individual sugar moieties (four monosaccharides and four disaccharides). The mean particle diameter, polydispersity index (PDI), zeta potential, drug loading, and the encapsulation efficiency of the NI-SLN suspension were determined to be 68.5 nm, 0.3, -62.1 mV, 2.7%, and 97.5%, respectively. In comparison with the NI-SLNs, the NI-SLNs lyophilized with trehalose (NI-SLN-Tre) showed a slight increase in the particle size from 68.5 to 107.7 nm, but the PDI decreased from 0.38 to 0.33, and no significant change in zeta potential was observed. Aqueous re-dispersibility study demonstrated that NI-SLNs lyophilized with trehalose had the maximum concentration (14.7 µg/mL) at 5 min, compared with lyophilized SLNs using other sugars; the use of other sugars also resulted in significant changes in the particle size, PDI, and zeta potential. A trehalose concentration of 2.5% w/v and a two-fold dilution of the SLN suspension were found to be the best conditions for lyophilization. Data from lyophilized SLNs using differential scanning calorimetry, powder X-ray diffraction, Fourier-transform infrared spectroscopy, and scanning electron microscopy indicated eventual transformation of NI-SLN-Tre from a crystalline to an amorphous state during the homogenization process. Finally, a stability study was performed with NI-SLN-Tre for up to 6 months at 30°C and 65% relative humidity, with no significant deterioration observed, suggesting that trehalose might be a useful cryoprotectant for NI-SLNs.