Enhanced Light Trapping in GaAs/TiO2-Based Photocathodes for Hydrogen Production.

Photoelectrochemical cells (PEC) are appealing devices for the production of renewable energy carriers. In this context, III-V semiconductors such as GaAs are very promising materials due to their tunable band gaps, which can be appropriately adjusted for sunlight harvesting. Because of the high cost of these semiconductors, the nanostructuring of the photoactive layer can help to improve the device efficiency as well as drastically reduce the amount of material needed. III-V nanowire-based photoelectrodes benefit from the intrinsically high aspect ratio of nanowires, their enhanced ability to trap light, and their improved charge separation and collection abilities and thus are particularly attractive for PECs. However, III-V semiconductors often suffer from corrosion in aqueous electrolytes, preventing their utilization over long periods under relevant working conditions. Here, photocathodes of GaAs nanowires protected with thin TiO2 shells were prepared and studied under simulated sunlight irradiation to assess their photoelectrochemical performances in correlation with their structural degradation, highlighting the advantageous nanowire geometry compared to its thin-film counterpart. Morphological and electronic parameters, such as the aspect ratio of the nanowires and their doping pattern, were found to strongly influence the photocatalytic performances of the system. This work highlights the advantageous combination of nanowires featuring a buried radial p-n junction with Co nanoparticles used as a hydrogen evolution catalyst. The nanostructured photocathodes exhibit significant photocatalytic activities comparable with previous noble-metal-based systems. This study demonstrates the potential of a GaAs nanostructured semiconductor and its reliable use for photodriven hydrogen production.

Background-Free Near-Infrared Biphoton Emission from Single GaAs Nanowires.

The generation of photon pairs from nanoscale structures with high rates is still a challenge for the integration of quantum devices, as it suffers from parasitic signals from the substrate. In this work, we report type-0 spontaneous parametric down-conversion at 1550 nm from individual bottom-up grown zinc-blende GaAs nanowires with lengths of up to 5 µm and diameters of up to 450 nm. The nanowires were deposited on a transparent ITO substrate, and we measured a background-free coincidence rate of 0.05 Hz in a Hanbury-Brown-Twiss setup. Taking into account transmission losses, the pump fluence, and the nanowire volume, we achieved a biphoton generation of 60 GHz/Wm, which is at least 3 times higher than that of previously reported single nonlinear micro- and nanostructures. We also studied the correlations between the second-harmonic generation and the spontaneous parametric down-conversion intensities with respect to the pump polarization and in different individual nanowires.

Growing self-assisted GaAs nanowires up to 80µm long by molecular beam epitaxy.

Ultralong GaAs nanowires were grown by molecular beam epitaxy using the vapor-liquid-solid method. In this ultralong regime we show the existence of two features concerning the growth kinetic and the structural properties. Firstly, we observed a non-classical growth mode, where the axial growth rate is attenuated. Secondly, we observed structural defects at the surface of Wurtzite segments located at the bottom part of the nanowires. We explain these two phenomena as arising from a particular pathway of the group V species, specific to ultralong nanowires. Finally, the optical properties of such ultralong nanowires are studied by photoluminescence experiments.

Highly linear polarized emission at telecom bands in InAs/InP quantum dot-nanowires by geometry tailoring.

Nanowire (NW)-based opto-electronic devices require certain engineering in the NW geometry to realize polarized-dependent light sources and photodetectors. We present a growth procedure to produce InAs/InP quantum dot-nanowires (QD-NWs) with an elongated top-view cross-section relying on the vapor-liquid-solid method using molecular beam epitaxy. By interrupting the rotation of the sample during the radial growth sequence of the InP shell, hexagonal asymmetric (HA) NWs with long/short cross-section axes were obtained instead of the usual symmetrical shape. Polarization-resolved photoluminescence measurements have revealed a significant influence of the asymmetric shaped NWs on the InAs QD emission polarization with the photons being mainly polarized parallel to the NW long cross-section axis. A degree of linear polarization (DLP) up to 91% is obtained, being at the state of the art for the reported DLP values from QD-NWs. More importantly, the growth protocol herein is fully compatible with the current applications of HA NWs covering a wide range of devices such as polarized light emitting diodes and photodetectors.

InAs quantum dot in a needlelike tapered InP nanowire: a telecom band single photon source monolithically grown on silicon.

Realizing single photon sources emitting in the telecom band on silicon substrates is essential to reach complementary-metal-oxide-semiconductor (CMOS) compatible devices that secure communications over long distances. In this work, we propose the monolithic growth of needlelike tapered InAs/InP quantum dot-nanowires (QD-NWs) on silicon substrates with a small taper angle and a nanowire diameter tailored to support a single mode waveguide. Such a NW geometry is obtained by a controlled balance over axial and radial growths during the gold-catalyzed growth of the NWs by molecular beam epitaxy. This allows us to investigate the impact of the taper angle on the emission properties of a single InAs/InP QD-NW. At room temperature, a Gaussian far-field emission profile in the telecom O-band with a beam divergence angle θ = 30° is demonstrated using a single InAs QD embedded in a 2° tapered InP NW. Moreover, single photon emission is observed at cryogenic temperature for an off-resonant excitation and the best result, g2(0) = 0.05, is obtained for a 7° tapered NW. This all-encompassing study paves the way for the monolithic growth on silicon of an efficient single photon source in the telecom band based on InAs/InP QD-NWs.

Impact of the Ga flux incidence angle on the growth kinetics of self-assisted GaAs nanowires on Si(111).

In this work we show that the incidence angle of group-III element fluxes plays a significant role in the diffusion-controlled growth of III-V nanowires (NWs) by molecular beam epitaxy (MBE). We present a thorough experimental study on the self-assisted growth of GaAs NWs by using a MBE reactor equipped with two Ga cells located at different incidence angles with respect to the surface normal of the substrate, so as to ascertain the impact of such a parameter on the NW growth kinetics. The as-obtained results show a dramatic influence of the Ga flux incidence angle on the NW length and diameter, as well as on the shape and size of the Ga droplets acting as catalysts. In order to interpret the results we developed a semi-empirical analytical model inspired by those already developed for MBE-grown Au-catalyzed GaAs NWs. Numerical simulations performed with the model allow us to reproduce thoroughly the experimental results (in terms of NW length and diameter and of droplet size and wetting angle), putting in evidence that under formally the same experimental conditions the incidence angle of the Ga flux is a key parameter which can drastically affect the growth kinetics of the NWs grown by MBE.

Nanoscale investigation of a radial p-n junction in self-catalyzed GaAs nanowires grown on Si (111).

One obstacle for the development of nanowire (NW) solar cells is the challenge to assess and control their nanoscale electrical properties. In this work a top-cell made of p-n GaAs core/shell NWs grown on a Si(111) substrate by Molecular Beam Epitaxy (MBE) is investigated by high resolution charge collection microscopy. Electron Beam Induced Current (EBIC) analyses of single NWs have validated the formation of a homogeneous radial p-n junction over the entire length of the NWs. The radial geometry leads to an increase of the junction area by 38 times with respect to the NW footprint. The interface between the NWs and the Si(111) substrate does not show any electrical loss, which would have led to a decrease of the EBIC signal. Single NW I-V characteristics present a diodic behavior. A model of the radial junction single NW is proposed and the electrical parameters are estimated by numerical fitting of the I-Vs and of the EBIC map. Solar cells based on NW arrays were fabricated and analyzed by EBIC microscopy, which evidenced the presence of a Schottky barrier at the NW/ITO top contact. Improvement of the top contact quality is achieved by thermal annealing at 400 °C, which strongly reduces the parasitic Schottky barrier.

Thermoelectric La-doped SrTiO3 epitaxial layers with single-crystal quality: from nano to micrometers.

High-quality thermoelectric La0.2Sr0.8TiO3 (LSTO) films, with thicknesses ranging from 20 nm to 0.7 µm, have been epitaxially grown on SrTiO3(001) substrates by enhanced solid-source oxide molecular-beam epitaxy. All films are atomically flat (with rms roughness < 0.2 nm), with low mosaicity (<0.1°), and present very low electrical resistivity (<5 × 10-4 Ω cm at room temperature), one order of magnitude lower than standard commercial Nb-doped SrTiO3 single-crystalline substrate. The conservation of transport properties within this thickness range has been confirmed by thermoelectric measurements where Seebeck coefficients of approximately -60 µV/K have been recorded for all films. These LSTO films can be integrated on Si for non-volatile memory structures or opto-microelectronic devices, functioning as transparent conductors or thermoelectric elements.

Redshifted and blueshifted photoluminescence emission of InAs/InP quantum dots upon amorphization of phase change material.

We present the mechanisms underlying the redshifted and blueshifted photoluminescence (PL) of quantum dots (QDs) upon amorphization of phase change material (PCM). We calculated the stress and energy shift distribution induced by volume expansion using finite element method. Simulation result reveals that redshift is obtained beneath the flat part of amorphous mark, while blueshift is obtained beneath the edge region of amorphous mark. Simulation result is accompanied by two experimental studies; two-dimensional PL intensity mapping of InAs/InP QD sample deposited by a layer of PCM, and an analysis on the relationship between PL intensity ratio and energy shift were performed.

10 Gbit/s all-optical NRZ-OOK to RZ-OOK format conversion in an ultra-small III-V-on-silicon microdisk fabricated in a CMOS pilot line.

We report the demonstration of an all-optical, bias free and error-free (bit-error-rate ~10(-12)), 10 Gbit/s non-return-to-zero (NRZ) to return-to-zero (RZ) data format conversion using a 7.5 µm diameter III-V-on-silicon microdisk resonator. The device is completely processed in a 200 mm CMOS pilot line. The data format conversion is based on the phenomenon of pulse carving of an NRZ optical data stream by an optical clock. The underlying physical effect for the pulse carving is the change in the refractive index caused by the generation of free-carriers in a pump -probe configuration. We believe it to be the first NRZ-to-RZ format convertor built on a hybrid III-V-on-silicon technology platform.

Milliwatt-level fiber-coupled laser power from photonic crystal band-edge laser.

We report unprecedentedly high output powers measured from large area two-dimensional square-lattice photonic-crystal band-edge lasers (BELs), patterned by holographic lithography. In order to ensure mechanical rigidity, the BELs were fabricated in an InP-based epilayer bonded onto a fused silica substrate beforehand. The BEL devices, employing the surface-emitting Γ-point monopole band-edge mode, provide a fiber-coupled single mode output power as high as 2.6 mW and an external differential quantum efficiency of ~4%. The results of a three-dimensional finite-difference time-domain simulation agree with the experimental observation that the large BELs are beneficial for achieving both high power output and high differential quantum efficiency.

Subwavelength plasmonic lasing from a semiconductor nanodisk with silver nanopan cavity.

We report the experimental demonstration of an optically pumped silver-nanopan plasmonic laser with a subwavelength mode volume of 0.56(lambda/2n)(3). The lasing mode is clearly identified as a whispering-gallery plasmonic mode confined at the bottom of the silver nanopan from measurements of the spectrum, mode image, and polarization state, as well as agreement with numerical simulations. In addition, the significant temperature-dependent lasing threshold of the plasmonic mode contrasts and distinguishes them from optical modes. Our demonstration and understanding of these subwavelength plasmonic lasers represent a significant step toward faster, smaller coherent light sources.

Room temperature low-threshold InAs/InP quantum dot single mode photonic crystal microlasers at 1.5 microm using cavity-confined slow light.

We have designed, fabricated, and characterized an InP photonic crystal slab structure that supports a cavity-confined slow-light mode, i.e. a bandgap-confined valence band-edge mode. Three dimensional finite difference in time domain calculations predict that this type of structure can support electromagnetic modes with large quality factors and small mode volumes. Moreover these modes are robust with respect to fabrication imperfections. In this paper, we demonstrate room-temperature laser operation at 1.5 mum of a cavity-confined slow-light mode under pulsed excitation. The gain medium is a single layer of InAs/InP quantum dots. An effective peak pump power threshold of 80 microW is reported.

Carrier-injection-based electro-optic modulator on silicon-on-insulator with a heterogeneously integrated III-V microdisk cavity.

A compact electro-optic modulator on silicon-on-insulator is presented. The structure consists of a III-V microdisk cavity heterogeneously integrated on a silicon-on-insulator wire waveguide. By modulating the loss of the active layer included in the cavity through carrier injection, the power of the transmitted light at the resonant wavelength is modulated; approximately 10 dB extinction ratio and 2.73 Gbps dynamic operation are demonstrated without using any special driving techniques.

Room-temperature InAs/InP Quantum Dots laser operation based on heterogeneous "2.5 D" Photonic Crystal.

The authors report on the design, fabrication and operation of heterogeneous and compact "2.5 D" Photonic Crystal microlaser with a single plane of InAs quantum dots as gain medium. The high quality factor photonic structures are tailored for vertical emission. The devices consist of a top two-dimensional InP Photonic Crystal Slab, a SiO(2) bonding layer, and a bottom high index contrast Si/SiO(2) Bragg mirror deposited on a Si wafer. Despite the fact that no more than about 5% of the quantum dots distribution effectively contribute to the modal gain, room-temperature lasing operation, around 1.5 microm, was achieved by photopumping. A low effective threshold, on the order of 350 microW, and a spontaneous emission factor, over 0.13, could be deduced from experiments.