Decreasing the degree of polymerization of microcrystalline cellulose by mechanical impact and acid hydrolysis.

Depolymerization of cellulose is often used as a (pre)treatment protocol within the catalytic valorization strategies of cellulose. Typical depolymerization protocols yield polymerization degrees above 70 anhydroglucose units (AGU). However, shorter cellulose fibers are of interest in the search for accessible dietary fiber additives or renewable materials with distinct mechanical properties (bio-composites). In this work, short-polymer microcrystalline celluloses (SMCC) with an average polymerization degree between 29 and 70 AGU were produced with material yields of 95 % and above by combining a planetary ball mill pretreatment with mild acid hydrolysis. By first decreasing the levelling-off degree of polymerization (LODP) with an intensive ball mill treatment, a mild acid hydrolysis protocol was sufficient to ensure high yields of SMCC. Furthermore, the desired polymerization degree could be obtained by tuning the process parameters.

Extruded Wheat Bran Consumption Increases Serum Short-Chain Fatty Acids but Does Not Modulate Psychobiological Functions in Healthy Men: A Randomized, Placebo-Controlled Trial.

Background: Incorporation of wheat bran (WB) into food products increases intake of dietary fiber, which has been associated with improved mood and cognition and a lower risk for psychiatric disorders such as depression, with short-chain fatty acids (SCFAs) as candidate mediators of these effects. Modifying WB using extrusion cooking increases SCFA production in vitro relative to unmodified WB. Objective: The aim of this study was to evaluate the effects of extruded WB on psychobiological functioning and the mediating role of SCFAs. Methods: In a randomized, triple-blind, placebo-controlled trial, 69 healthy male participants consumed 55 g of breakfast cereal containing either extruded WB or placebo daily for 28 days. At pre- and post-intervention visits, the cortisol response to experimentally induced stress was measured as a primary outcome. In addition, serum SCFAs and brain-derived neurotrophic factors were quantified as potential mediators. Secondary psychobiological outcomes included subjective stress responses, responses to experimentally induced fear, cortisol awakening response, heart rate variability, and retrospective subjective mood ratings. Intestinal permeability, fecal SCFAs, and stool consistency were measured as secondary biological outcomes. Results: Extruded WB increased serum acetate and butyrate (p < 0.05). None of the primary or secondary outcomes were affected by the intervention. Participants who consumed a placebo exhibited an increase in the percentage of fecal dry weight but did not report increased constipation. Despite these statistically significant effects, these changes were small in magnitude. Conclusions: Extruded WB consumption increased serum short-chain fatty acids but did not modulate psychobiological functions in healthy men. Effective modulation of psychobiological functions may require greater increases in SCFAs than those achieved following extruded WB consumption. Rather than attempting to induce health benefits with a single fiber-rich food, combinations of different fibers, particularly highly fermentable ones, might be needed to further increase SCFA production and uptake in the systemic circulation to observe an effect on psychobiological processes.

Changing Wheat Bran Structural Properties by Extrusion-Cooking on a Pilot and Industrial Scale: A Comparative Study.

Extrusion-cooking can be used to change the techno-functional and nutrition-related properties of wheat bran. In this study, pilot-scale (BC21) and industrial-scale (BC45) twin-screw extrusion-cooking using different types of extrusion (single-pass, double-pass and acid extrusion-cooking) and process parameters (temperature, moisture) were compared for their impact on wheat bran. When applying the same process settings, the higher strong water-binding capacity, extract viscosity and extractability displayed by bran extruded using the industrial set-up reflected a more considerable wheat bran structure degradation compared to pilot-scale extrusion-cooking. This was attributed to the overall higher specific mechanical energy (SME), pressure and product temperature that were reached inside the industrial extruder. When changing the type of extrusion-cooking from single-pass to double-pass and acid extrusion-cooking, wheat bran physicochemical characteristics evolved in the same direction, irrespective of extruder scale. The differences in bran characteristics were, however, smaller on industrial-scale. Results show that the differentiating power of the latter can be increased by decreasing the moisture content and increasing product temperature, beyond what is possible in the pilot-scale extruder. This was confirmed by using a BC72 industrial-scale extruder at low moisture content. In conclusion, the extruder scale mainly determines the SME that can be reached and determines the potential to modify wheat bran.

The Effect of Wet Milling and Cryogenic Milling on the Structure and Physicochemical Properties of Wheat Bran.

Wheat bran consumption is associated with several health benefits, but its incorporation into food products remains low because of sensory and technofunctional issues. Besides, its full beneficial potential is probably not achieved because of its recalcitrant nature and inaccessible structure. Particle size reduction can affect both technofunctional and nutrition-related properties. Therefore, in this study, wet milling and cryogenic milling, two techniques that showed potential for extreme particle size reduction, were used. The effect of the milling techniques, performed on laboratory and large scale, was evaluated on the structure and physicochemical properties of wheat bran. With a median particle size (d50) of 6 µm, the smallest particle size was achieved with cryogenic milling on a laboratory scale. Cryogenic milling on a large scale and wet milling on laboratory and large scale resulted in a particle size reduction to a d50 of 28-38 µm. In the milled samples, the wheat bran structure was broken down, and almost all cells were opened. Wet milling on laboratory and large scale resulted in bran with a more porous structure, a larger surface area and a higher capacity for binding water compared to cryogenic milling on a large scale. The extensive particle size reduction by cryogenic milling on a laboratory scale resulted in wheat bran with the highest surface area and strong water retention capacity. Endogenous enzyme activity and mechanical breakdown during the different milling procedures resulted in different extents of breakdown of starch, sucrose, ß-glucan, arabinoxylan and phytate. Therefore, the diverse impact of the milling techniques on the physicochemical properties of wheat bran could be used to target different technofunctional and health-related properties.

The impact of wheat (Triticum aestivum L.) bran on wheat starch gelatinization: A differential scanning calorimetry study.

The effect of wheat bran on starch gelatinization temperature was investigated. Dynamic water vapour sorption and water retention capacity experiments showed that bran bound up to 3 times more water than starch. However, examining starch gelatinization in starch-bran-water mixtures with differential scanning calorimetry showed that the effect of substituting starch by bran differed from that of moving into a regime of limiting water. Modelling the effect of the mixture composition on starch gelatinization behavior indicated that the onset (To) and peak (Tp) gelatinization temperatures were positively impacted by the bran concentration in water. The conclusion temperature (Tc) was negatively affected by the water content. Fractionation experiments demonstrated that the increased To and Tp were mainly caused by the extractable wheat bran components, such as potassium and phosphorus, which decrease the plasticization capacity of the solvent. The mechanism behind our observations was explained with the side-chain liquid-crystalline polymeric model for starch.

Extrusion-Cooking Modifies Physicochemical and Nutrition-Related Properties of Wheat Bran.

The potential of extrusion-cooking to change the physicochemical characteristics of wheat bran, increase its nutritional value and decrease its recalcitrance towards fermentation was investigated in this study. The conditions in a twin-screw extruder were varied by changing screw configuration, moisture content and barrel temperature. The former was not previously investigated in studies on bran extrusion. Extrusion-cooking resulted in an increased water-holding capacity and extract viscosity of bran, suggesting shear-induced structure degradation and structure loosening due to steam explosion at the extruder outlet. Modelling showed that the extent of these modifications mainly correlates with the amount of specific mechanical energy (SME) input, which increases with an increasing number of work sections in the screw configuration and a decreasing moisture content and barrel temperature. Extrusion led to solubilisation of arabinoxylan and ferulic acid. Moreover, it led to starch melting and phytate degradation. Upon fermentation of the most modified sample using a human faecal inoculum, small numeric pH decreases and short-chain fatty acid production increases were observed compared to the control bran, while protein fermentation was decreased. Overall, extrusion-cooking can improve the nutrition-related properties of wheat bran, making it an interesting technique for the modification of bran before further use or consumption as an extruded end product.

Study into the effect of microfluidisation processing parameters on the physicochemical properties of wheat (Triticum aestivum L.) bran.

The physicochemical properties of wheat bran have an effect on its technofunctional and nutritional profile. The possibility to induce physicochemical modifications in wheat bran using microfluidisation was investigated. An I-optimal experimental design was used to investigate the effect of microfluidisation processing parameters (pressure, number of passes, bran concentration and initial particle size) on important properties of wheat bran (particle size, microstructure, chemical composition, water retention capacity (WRC), extractability, viscosity and sedimentation). With the parameters used in this study, microfluidisation reduced wheat bran median particle size to 14.8 µm and disintegrated starch granules from the attached endosperm. This coincided with an increased extractability of starch and arabinoxylan. While the initial particle size was of minor importance, a higher pressure, larger number of passes and lower bran concentration during microfluidisation resulted in a smaller particle size, higher WRC and extractability, and an increased viscosity and stability in a 2% wheat bran suspension.

Impact of Preharvest Sprouting of Wheat (Triticum aestivum) in the Field on Starch, Protein, and Arabinoxylan Properties.

To obtain detailed knowledge on possible changes in the properties of starch, proteins, and arabinoxylan as a result of field preharvest sprouting (PHS), three wheat varieties were harvested at maturity and several weeks later when severe PHS had occurred. Falling number values of flour dropped from 306 to 147 s (Sahara), 382 to 155 s (Forum), and 371 to 230 s (Tobak). Blocking of α-amylase activity demonstrated that the decline in falling number and changes in RVA pasting and gelation properties were not caused by changes in intrinsic starch properties as a result of PHS. PHS had no influence on the SDS-extractability and molecular weight distribution of the proteins. For arabinoxylan, incipient breakdown was noticed, leading to a higher amount and average degree of polymerization of water extractable arabinoxylan. Results show that strategies to cope with severely PHS in wheat should focus on blocking enzyme activities.

Evolution and Distribution of Hydrolytic Enzyme Activities during Preharvest Sprouting of Wheat (Triticum aestivum) in the Field.

To date, research on preharvest sprouted (PHS) wheat has mostly been conducted on kernels germinated under laboratory conditions, which differ widely from conditions in the field. To obtain detailed knowledge of the evolution of hydrolytic enzyme activities in PHS wheat (Triticum aestivum), a broad collection of samples from three varieties was obtained by harvesting before, at, and after maturity. Delaying harvest time coupled with periods of heavy rainfall caused sprouting in the kernels, observed as a drop in Falling Number and an increase in α-amylase activity. The appearance of α- and ß-amylase, peptidase, and endoxylanase activity during field sprouting was independent from each other. Consequently, Falling Number could not be used to predict activity of other hydrolytic enzymes. When differentiating endogenous from kernel-associated microbial enzymes, results showed that α- and ß-amylase and peptidase activity of PHS kernels were predominantly of endogenous origin, whereas endoxylanase activity was largely from microbial origin.