ABSTRACT
Two-dimensional (2D) transition metal dichalcogenide (TMD) layers are highly promising as field-effect transistor (FET) channels in the atomic-scale limit. However, accomplishing this superiority in scaled-up FETs remains challenging due to their van der Waals (vdW) bonding nature with respect to conventional metal electrodes. Herein, we report a scalable approach to fabricate centimeter-scale all-2D FET arrays of platinum diselenide (PtSe2) with in-plane platinum ditelluride (PtTe2) edge contacts, mitigating the aforementioned challenges. We realized a reversible transition between semiconducting PtSe2 and metallic PtTe2 via a low-temperature anion exchange reaction compatible with the back-end-of-line (BEOL) processes. All-2D PtSe2 FETs seamlessly edge-contacted with transited metallic PtTe2 exhibited significant performance improvements compared to those with surface-contacted gold electrodes, e.g., an increase of carrier mobility and on/off ratio by over an order of magnitude, achieving a maximum hole mobility of â¼50.30 cm2 V-1 s-1 at room temperature. This study opens up new opportunities toward atomically thin 2D-TMD-based circuitries with extraordinary functionalities.
ABSTRACT
We report the optical phonon shifts induced by phase transition effects of vanadium dioxide (VO2) in monolayer molybdenum disulfide (MoS2) when interfacing with a VO2 film showing a metal-insulator transition coupled with structural phase transition (SPT). To this end, the monolayer MoS2 directly synthesized on a SiO2/Si substrate by chemical vapor deposition was first transferred onto a VO2/c-Al2O3 substrate in which the VO2 film was prepared by a sputtering method. We compared the MoS2 interfaced with the VO2 film with the as-synthesized MoS2 by using Raman spectroscopy. The temperature-dependent Raman scattering characteristics exhibited the distinct phonon behaviors of the E2g1 and A1g modes in the monolayer MoS2. Specifically, for the as-synthesized MoS2, there were no Raman shifts for each mode, but the enhancement in the Raman intensities of E2g1 and A1g modes was clearly observed with increasing temperature, which could be interpreted by the significant contribution of the interface optical interference effect. In contrast, the red-shifts of both the E2g1 and A1g modes for the MoS2 transferred onto VO2 were clearly observed across the phase transition of VO2, which could be explained in terms of the in-plane tensile strain effect induced by the SPT and the enhancement of electron-phonon interactions due to an increased electron density at the MoS2/VO2 interface through the electronic phase transition. This study provides further insights into the influence of interfacial hybridization for the heterogeneous integration of 2D transition-metal dichalcogenides and strongly correlated materials.
ABSTRACT
A hydrothermally synthesized rhodium/antimony co-doped TiO2 nanorod and titanate nanotube (RS-TONR/TNT) composite was prepared for removal of heavy metals and organic pollutants from water under visible light irradiation. The composite provides the dual function of simultaneous adsorption of heavy metal ions and enhanced degradation of dissolved organic compounds. Acid treatment transformed titanate nanotubes to irregular tubular structures distributed homogeneously over untransformed RS/TONRs. Synergistic removal and degradation was studied with various heavy metals, Orange (II) dye, and Bisphenol A. The adsorption capacity of the composite for heavy metal ions was Pb(II)â¯>â¯Cd(II)â¯>â¯Cu(II)â¯>â¯Zn(II). The adsorbed metals enhanced photocatalytic degradation of the organic pollutants, but Cu was most effective, with degradation exceeding 70% for the dye and 80% for Bisphenol A after 5â¯h of treatment. Photocatalytic activity was enhanced more by adsorption than photodeposition of Cu ions. A decrease in XRD rutile peak intensity with adsorbed metal indicates a change in crystallinity which may enhance photocatalytic activity. Thick and bulging nanostructures in FE-SEM images signify ion adsorption within titanate pores. BET analysis indicated titanate nanotubes with adsorbed metal are mesoporous but their tubular structure persists. XPS showed more active Cu 2p3/2 states under light, supporting an active role of Cu+ in photocatalytic ROS generation. Detection of ROS and Cu species using methanol, EDTA, pCBA, and benzoic acid probes provided strong evidence for degradation via a charge transfer mechanism. Findings demonstrate the potential of the RS-TONR/TNT composite for simultaneous removal of heavy metals and degradation of organic pollutants.