Sublimed C60 for efficient and repeatable perovskite-based solar cells.

Thermally evaporated C60 is a near-ubiquitous electron transport layer in state-of-the-art p-i-n perovskite-based solar cells. As perovskite photovoltaic technologies are moving toward industrialization, batch-to-batch reproducibility of device performances becomes crucial. Here, we show that commercial as-received (99.75% pure) C60 source materials may coalesce during repeated thermal evaporation processes, jeopardizing such reproducibility. We find that the coalescence is due to oxygen present in the initial source powder and leads to the formation of deep states within the perovskite bandgap, resulting in a systematic decrease in solar cell performance. However, further purification (through sublimation) of the C60 to 99.95% before evaporation is found to hinder coalescence, with the associated solar cell performances being fully reproducible after repeated processing. We verify the universality of this behavior on perovskite/silicon tandem solar cells by demonstrating their open-circuit voltages and fill factors to remain at 1950 mV and 81% respectively, over eight repeated processes using the same sublimed C60 source material. Notably, one of these cells achieved a certified power conversion efficiency of 30.9%. These findings provide insights crucial for the advancement of perovskite photovoltaic technologies towards scaled production with high process yield.

A comparative study on the rheological properties of upper convected Maxwell fluid along a permeable stretched sheet.

The objective of this paper is to examine the flow of a non-Newtonian Maxwell fluid induced by a permeable stretching sheet in motion within a porous medium. The research incorporates the Cattaneo-Christov heat flux model to study the heat transfer process. The utilization of the Cattaneo-Christov heat flux approach becomes relevant in scenarios involving materials with high thermal conductivity or during short time intervals. Consequently, the current investigation holds significant importance. It is assumed that the viscosity of the Maxwell fluid changes exponentially as the temperature changes. The modeling of the physical phenomena being investigated takes into account the effects of a magnetic field, thermal radiation, velocity, and thermal slip conditions. In this study, the viscous dissipation phenomenon is taken into account because it can have notable impacts on the temperature and viscosity of the fluid, and is known to play a crucial role in fluid flow phenomena. The equations developed to model fluid flow are transformed into nonlinear ordinary differential equations through the use of appropriate similarity transformations. The focus of the research revolves around investigating the numerical solution of ordinary differential equations accompanied by boundary conditions using the shooting technique. The findings are then showcased via tables and graphs and scrutinized in order to arrive at conclusions. Furthermore, the precision of the present findings was evaluated by contrasting the heat transfer rate with outcomes that were previously published. Based on the obtained outcomes, it can be concluded that both the Eckert number and thermal radiation have a comparable enhancing influence, whereas the thermal relaxation parameter and thermal slip parameter exhibit opposing effects.

Enhanced optoelectronic coupling for perovskite/silicon tandem solar cells.

Monolithic perovskite/silicon tandem solar cells are of great appeal as they promise high power conversion efficiencies (PCEs) at affordable cost. In state-of-the-art tandems, the perovskite top cell is electrically coupled to a silicon heterojunction bottom cell by means of a self-assembled monolayer (SAM), anchored on a transparent conductive oxide (TCO), which enables efficient charge transfer between the subcells1-3. Yet reproducible, high-performance tandem solar cells require energetically homogeneous SAM coverage, which remains challenging, especially on textured silicon bottom cells. Here, we resolve this issue by using ultrathin (5-nm) amorphous indium zinc oxide (IZO) as the interconnecting TCO, exploiting its high surface-potential homogeneity resulting from the absence of crystal grains and higher density of SAM anchoring sites when compared with commonly used crystalline TCOs. Combined with optical enhancements through equally thin IZO rear electrodes and improved front contact stacks, an independently certified PCE of 32.5% was obtained, which ranks among the highest for perovskite/silicon tandems. Our ultrathin transparent contact approach reduces indium consumption by approximately 80%, which is of importance to sustainable photovoltaics manufacturing4.

Evaluation of cefquinome's efficacy in controlling avian colibacillosis and detection of its residues using high performance liquid chromatography (HPLC).

This study aimed to evaluate the efficacy of cefquinome in treatment and controlling of Escherichia coli experimentally infected broiler chickens, in addition of detection of its residues using High performance liquid chromatography (HPLC). In this study, 150 one-day old Cobb broiler chicks were used. On the 14th day chicks experimentally infected and divided into 3 equal groups (50 each); control group (G1) non-infected, non-treated, (G2) infected with E. coli O78 non treated, (G3) infected with E. coli O78 , cefquinome treated. Cefquinome was administrated 5th day post infection, intramuscularly by a dose of (2 mg/ kg b w.t) for 3 consecutive days. Experimental E. coli infection in broilers induced weakness, loss of appetite, depression, cough and watery diarrhea in addition to a recorded mortality (30%) with reduction in growth performance, erythrogram, total proteins, albumin, antioxidants and haemagglutination inhibition (HI) titers. In addition, a significant increase in feed conversion rate (FCR), leukocytic count, liver enzymes, kidney functions, total globulins, malondialdehyde, nitric oxide and lysozyme activity. Treatment with cefquinome led to decreased mortality rate, improvement in clinical signs, growth performance and modulated most of these altered parameters. Cefquinome's residues was not detected in breast muscles 3rd day and liver and kidneys 7th days post treatment. Therefore, it's recommended that cefquinome is a good choice for controlling of colibacillosis in broilers and its withdrawal time 3 days in breast muscles and 7 days in liver and kidney post treatment.