ABSTRACT
BACKGROUND: Limited data is available regarding the prevalence of dental caries as a chronic disease among adolescents using different caries assessment indices. The aim of this study was to compare and describe the prevalence of dental caries among group of Egyptian students using two caries assessment indices; DMFS and ICDAS II. METHODS: This descriptive, cross-sectional epidemiological study included 2760 public secondary school students with age range from 15 to 18 years with permanent dentition and good general health. Presence of; retained teeth, congenital or developmental anomalies in the permanent dentition, orthodontic treatments, systematic conditions, smoking and general health problems were considered the exclusion criteria in this study. Participants were selected randomly from 8 public secondary schools in the Great Cairo, Egypt. The examination was achieved by 6 trained and previously calibrated examiners using sets of diagnostic mirrors, compressed air, a WHO probe and cotton rolls. DMFS index and ICDAS II system were used as caries detection methods. In DMFS index; the number of decayed (D), missing (M) and filled (F) surfaces was recorded, while in the ICDAS II index, the assessment of both cavitated and non-cavitated carious, missed and filled teeth with restorations /sealants was recorded. The examiners performed the oral examination using both scoring systems in an alternating manner. The collected data were explored for normality using Kolmogorov-Smirnov and Shapiro-Wilk tests. Chi square test was used to analyze the frequencies. RESULTS: There was a statistical significant difference between the DMFS and ICDAS II methods results regarding the recorded number of caries affected teeth and cavitated teeth surfaces. The prevalence of dental caries among the investigated secondary school students was (69.56%) and (78.29%) for DMFS and ICDAS II, respectively. CONCLUSIONS: The prevalence of dental caries among Egyptian adolescent is high. ICDAS scoring system revealed higher caries prevalence values than DMFS method. ICDAS method is the best choice for the preventive goals, while DMFS is sufficient for clinical purposes.
Subject(s)
Dental Caries , Humans , Adolescent , Dental Caries/epidemiology , Dental Caries/diagnosis , Cross-Sectional Studies , Egypt/epidemiology , Prevalence , Dental Caries SusceptibilityABSTRACT
AIM: To compare the efficacy of two naturally based commercially available whitening toothpastes charcoal and sea salt-lemon on stain removal of teeth in terms of color change and surface roughness. MATERIALS AND METHODS: Twenty-seven intact bovine incisors were selected and randomly allocated into three main groups (n = 9) according to the tested toothpaste [I: Signal Complete 8 Charcoal; II: sea salt-lemon essence Closeup natural smile; and III: Signal Complete 8 Original (control)]. Following 4 successive days of staining protocol, each specimen in its corresponding group was brushed with the toothpaste using toothbrush simulator apparatus for three brushing cycles. Color assessment using Vita Easyshade spectrophotometer and surface roughness (Ra) measurement using contact type profilometer were performed for each specimen at baseline, after staining, and after each tooth brushing cycle. RESULTS: Nonparametric color data and parametric surface roughness data were analyzed. The color difference (ΔE) from after-staining protocol to different tooth brushing cycles (1,2,3) showed no significant difference on each cycle between the tested groups (p >0.05). While for color difference (ΔE) from baseline to the last tooth brushing cycle 3, the difference between groups was statistically significant where group II, sea salt-lemon-based toothpaste, had a significantly lowest (ΔE 00) value (p <0.001) indicating more whitening effect in relation to others. However, a significant increase in surface roughness was present in all tested groups (p <0.001); meanwhile, there was no significant difference between tested groups (p >0.05). CONCLUSION: After three tooth brushing cycles, none of the natural whitening toothpastes or conventional toothpastes produced had effective whitening results nor completely removed the stains back to the initial baseline tooth color. Sea salt-lemon-based whitening toothpaste had a whitening effect better than the charcoal-based toothpaste. All of the tested toothpastes increased the degree of surface roughness. CLINICAL RELEVANCE: Charcoal and sea salt-lemon-based whitening toothpastes do not guarantee to whiten nor completely remove the stains back to normal and their effects on enamel surface roughness should be highly clinically considered and managed.
Subject(s)
Tooth Bleaching , Tooth Discoloration , Animals , Cattle , Charcoal , Color , Coloring Agents , Tooth Bleaching/methods , Toothbrushing , ToothpastesABSTRACT
Objective: To compare the effect of three surface treatment protocols and two intermediate agents on repairing aged composite, regarding microtensile bond strength (µTBS) and mode of fracture, at two time intervals. Material and methods: Six-monthaged microhybrid composite blocks, were randomly distributed into three groups, subjected to; Fine, Super Fine grit diamond burs or Erbium- Yag Laser surface treatment. Each block had both One Coat bond SL (Bond) and Brilliant Flow flowable composite (Flow) intermediate agents, alongside. Blocks were incrementally repaired using nanohybrid composite, cut into beams, then randomly subjected either immediately (IM) to µTBS test or after thermocycling (TC) for 5000 cycle. Mode of failure was determined using stereomicroscope. Data were analyzed through three-way ANOVA followed by pairwise comparison with Bonferroni correction. Kruskal Wallis test compared groups for failure mode analysis (α=0.05) Results: Super Fine grit showed the highest mean µTBScompared to control for both intermediate agents, IM and after TC at P<0.05. No difference between Fine grit and Laser application for all groups (P>0.05). IM, Bond showed the highest µTBS compared to TC, Flow for all tested groups. Beams roughened with Fine and Super Fine burs showed significantly lower adhesive failures than those roughened with Laser. Flow suffers significantly higher adhesive failure than those with Bond. For TC tested groups; beams with Super Fine bur and Bond showed significantly lower adhesive failure at P=0.029. Conclusion: Super Fine grit and Bond provide the highest µTBS and the least adhesive failure; moreover TC resulted in significant decrease in µTBS (AU)
Objetivo: Comparar o efeito de três protocolos de tratamento de superfície e dois agentes intermediários no reparo de compósito envelhecido, quanto à resistência à microtração (µTBS) e modo de fratura, em dois intervalos de tempo. Material e métodos: Blocos de compósito microhíbrido envelhecidos por seis meses, foram distribuídos aleatoriamente em três grupos, submetidos a; Pontas diamantadas de granulação Fina, Superfina ou tratamento de superfície com laser de Erbio-Yag. Cada bloco tinha ambos os agentes intermediários One Coat bond SL (Adesivo) ao lado de Brilliant Flow (Resina Fluida). Os blocos foram reparados de forma incremental usando compósito nanohíbrido, cortados em palitose, em seguida, submetidos aleatoriamente imediatamente (IM) ao teste de µTBS ou após termociclagem (TC) por 5000 ciclos. O modo de falha foi determinado usando estereomicroscópio. Os dados foram analisados por meio de ANOVA de três fatores, seguida de comparação pareada com correção de Bonferroni. O teste de Kruskal Wallis comparou os grupos para análise do modo de falha (α = 0,05). Resultados: a granulação Super fina apresentou a maior média de µTBS em comparação com o controle para ambos os agentes intermediários, IM e após TC (P <0,05). Não houve diferença entre granulação fina e aplicação de laser para todos os grupos (P> 0,05). IM, Adesivo apresentou a µTBS mais alta em comparação com TC, Resina Fluida para todos os grupos testados. Os palitos asperizados com pontas de granulações Fina e Superfina apresentaram falhas adesivas significativamente menores do que as asperizadas com Laser. Resina Fluida sofreu falhas adesivas significativamente maiores do que aquelas com Adesivo. Para grupos testados TC; palitos tratados com ponta Superfina e Adesivo apresentaram falha adesiva significativamente menor com P = 0,029. Conclusão: a granulação Superfina e o Adesivo fornecem a maior µTBS e o mínimo de falha adesiva; além disso, o TC resultou em uma diminuição significativa da µTBS. (AU)