Accelerated nonlinear interactions in graded-index multimode fibers.

Multimode optical fibers have recently reemerged as a viable platform for addressing a number of long-standing issues associated with information bandwidth requirements and power-handling capabilities. As shown in recent studies, the complex nature of such heavily multimoded systems can be effectively exploited to observe altogether novel physical effects arising from spatiotemporal and intermodal linear and nonlinear processes. Here, we study for the first time, accelerated nonlinear intermodal interactions in core-diameter decreasing multimode fibers. We demonstrate that in the anomalous dispersion region, this spatiotemporal acceleration can lead to relatively blue-shifted multimode solitons and blue-drifting dispersive wave combs, while in the normal domain, to a notably flat and uniform supercontinuum, extending over 2.5 octaves. Our results pave the way towards a deeper understanding of the physics and complexity of nonlinear, heavily multimoded optical systems, and could lead to highly tunable optical sources with very high spectral densities.

Instant and efficient second-harmonic generation and downconversion in unprepared graded-index multimode fibers.

We show that germanium-doped graded-index multimode silica fibers can exhibit relatively high conversion efficiencies (∼6.5%) for second-harmonic generation when excited at 1064 nm. This frequency-doubling behavior is also found to be accompanied by an effective downconversion. As opposed to previous experiments carried out in single- and few-mode fibers where hours of preparation were required, in our system, these χ(2) related processes occur almost instantaneously. The efficiencies observed in our experiments are, to the best of our knowledge, among the highest ever reported in unprepared fibers.

Reduced-symmetry LMA rod-type fiber for enhanced higher-order mode delocalization.

We present a novel design of a micro-structured large-pitch, large-mode-area (LMA) asymmetric rod-type fiber. By reducing the cladding symmetry through six high-refractive index germanium-doped silica inclusions, the fiber features strong higher-order mode (HOM) delocalization, leading to a potentially enhanced preferential gain for the fundamental mode in active fibers. In addition, high resolution spatially and spectrally (S2) resolved mode analysis measurements confirm HOM contributions below 1% and LP1m-like HOM contributions below the detection limit. This proposed fiber design enables single-mode operation, with near-diffraction-limited beam quality of M2=1.3 and an effective mode area of 2560 µm2 at 1064 nm. This design opens new insights into improving the threshold-like onset of modal instabilities in high-power fiber lasers and fiber amplifiers by efficiently suppressing LP11 modes.

Tailoring frequency generation in uniform and concatenated multimode fibers.

We demonstrate that frequency generation in multimode parabolic-index fibers can be precisely engineered through appropriate fiber design. This is accomplished by exploiting the onset of a geometric parametric instability that arises from resonant spatiotemporal compression. By launching the output of an amplified Q-switched microchip laser delivering 400 ps pulses at 1064 nm, we observe a series of intense frequency sidebands that strongly depend on the fiber core size. The nonlinear frequency generation is analyzed in three fiber samples with 50 µm, 60 µm, and 80 µm core diameters. We further demonstrate that by cascading fibers of different core sizes, a desired frequency band can be generated from the frequency lines parametrically produced in each section. The observed frequency shifts are in good agreement with analytical predictions and numerical simulations. Our results suggest that core scaling and fiber concatenation can provide a viable avenue in designing optical sources with tailored output frequencies.

Visible supercontinuum generation in a graded index multimode fiber pumped at 1064 nm.

We observe efficient supercontinuum generation that extends into the visible spectral range by pumping a low differential mode group delay graded index multimode fiber in the normal dispersion regime. For a 28.5 m long fiber, the generated spectrum spans more than two octaves, starting from below 450 nm and extending beyond 2400 nm. The main nonlinear mechanisms contributing to the visible spectrum generation are attributed to multipath four-wave mixing processes and periodic spatio-temporal breathing dynamics. Moreover, by exploiting the highly multimodal nature of this system, we demonstrate versatile generation of visible spectral peaks in shorter fiber spans by altering the launching conditions. A nonlinearly induced mode cleanup was also observed at the pump wavelength. Our results could pave the way for high brightness, high power, and compact, multi-octave continuum sources.

Few-mode erbium-doped fiber amplifier with photonic lantern for pump spatial mode control.

We demonstrate a few-mode erbium-doped fiber amplifier employing a mode-selective photonic lantern for controlling the modal content of the pump light. Amplification of six spatial modes in a 5 m long erbium-doped fiber to ∼6.2 dBm average power is obtained while maintaining high modal fidelity. Through mode-selective forward pumping of the two degenerate LP21 modes operating at 976 nm, differential modal gains of <1 dB between all modes and signal gains of ∼16 dB at 1550 nm are achieved. In addition, low differential modal gain for near-full C-band operation is demonstrated.

Mode-selective amplification in a large mode area Yb-doped fiber using a photonic lantern.

We demonstrate selective spatial mode amplification in a few mode, double-clad Yb-doped large mode area (LMA) fiber, utilizing an all-fiber photonic lantern. Amplification to multi-watt output power is achieved while preserving high spatial mode selectivity. We observe gain values of over 12 dB for all modes: LP01, LP11a, and LP11b, when amplified individually. Additionally, we investigate the simultaneous amplification of LP01+LP11a and LP11a+LP11b, and the resultant mode competition. The proposed architecture allows for the reconfigurable excitation of spatial modes in the LMA fiber amplifiers, and represents a promising method that could enable dynamic spatial mode control in high power fiber lasers.