ABSTRACT
The crystal structures, lattice vibrations, and electronic band structures of PbCrO4, PbSeO4, SrCrO4, and SrSeO4 were studied by ab initio calculations, Raman spectroscopy, X-ray diffraction, and optical-absorption measurements. Calculations properly describe the crystal structures of the four compounds, which are isomorphic to the monazite structure and were confirmed by X-ray diffraction. Information is also obtained on the Raman- and IR-active phonons, with all of the vibrational modes assigned. In addition, the band structures and electronic densities of states of the four compounds were determined. All are indirect-gap semiconductors. In particular, chromates are found to have band gaps smaller than 2.5 eV and selenates higher than 4.3 eV. In the chromates (selenates), the upper part of the valence band is dominated by O 2p states and the lower part of the conduction band is composed primarily of electronic states associated with the Cr 3d and O 2p (Se 4s and O 2p) states. Calculations also show that the band gap of PbCrO4 (PbSeO4) is smaller than the band gap of SrCrO4 (SrSeO4). This phenomenon is caused by Pb states, which, to some extent, also contribute to the top of the valence band and the bottom of the conduction band. The agreement between experiments and calculations is quite good; however, the band gaps are underestimated by calculations, with the exception of the bang gap of SrCrO4, for which theory and calculations agree. Calculations also provide predictions of the bulk modulus of the studied compounds.
Subject(s)
Chromates/chemistry , Lead/chemistry , Metals, Rare Earth/chemistry , Models, Molecular , Selenic Acid/chemistry , Strontium/chemistry , Vibration , Crystallography, X-Ray , Electrons , Molecular Conformation , Quantum TheoryABSTRACT
The high-pressure structural behavior of 30 nm nanoparticles of anatase TiO2 was studied under hydrostatic and quasi-hydrostatic conditions up to 25 GPa. We found that the structural sequence is not sensitive to the use of different pressure transmitting media. Anatase-type nanoparticles exhibit a phase transition beyond 12 GPa toward a baddeleyite-type structure. Under decompression this phase transition is irreversible, and a metastable columbite-type structure is recovered at ambient conditions. The bulk modulus of anatase-type nanoparticles was determined confirming that nanoparticles of TiO2 are more compressible than bulk TiO2. Similar conclusions were obtained after the determination of the bulk modulus of baddeleyite-type nanoparticles. Furthermore, axial compressibilities and the effect of pressure in atomic positions, bond distances, and bond angles are determined. Finally, a possible physical explanation for the destabilization of anatase under pressure is proposed based upon this information.
ABSTRACT
A new carbonitride Ni2Mo3(CxNy) has been synthesized by temperature-programmed carburization of the Ni2Mo3N precursor with a CH4/H2/Ar gas mixture at 923 K. This compound has been characterized by X-ray diffraction, elemental analysis, Auger electron spectroscopy, laser Raman spectroscopy, thermogravimetric analysis and field-emission scanning electron microscopy. Ni2Mo3(CxNy) crystallizes in the cubic space group P4(1)32, with a lattice parameter of a=6.64575(3) A, corresponding to the unusual filled beta-Mn structure. Its formation occurs by partial substitution of N by C via a topotactic and pseudomorphic reaction and its stability in air is higher that of Ni2Mo3N. A two-phase mixture with a cubic structure has always been obtained by the same synthetic method applied to the V2Mo(OxNy) precursor. One of these would be of carbidic nature formed at 1153 K following a reaction similar to that proposed for Ni2Mo3(CxNy).
ABSTRACT
The molybdenum bimetallic interstitial carbides Fe(3)Mo(3)C and Co(3)Mo(3)C have been synthesized by temperature-programmed reaction (TPR) between the molybdenum bimetallic interstitial nitrides Fe(3)Mo(3)N and Co(3)Mo(3)N and a flowing mixture of CH(4) and H(2) diluted in Ar. These compounds have been characterized by X-ray diffraction, laser Raman spectroscopy, elemental analysis, energy dispersive analysis of X rays, thermal analysis (in air) and scanning electron microscopy (field emission). Their structures have been refined from X-ray powder diffraction data. These carbides crystallize in the cubic system, space group Fd3m[a= 11.11376(6) and 11.0697(3)[Angstrom] for Fe and Co compounds, respectively].
