Microkinetic Analysis of the Oxygen Evolution Performance at Different Stages of Iridium Oxide Degradation.

The microkinetics of the electrocatalytic oxygen evolution reaction substantially determines the performance in proton-exchange membrane water electrolysis. State-of-the-art nanoparticulated rutile IrO2 electrocatalysts present an excellent trade-off between activity and stability due to the efficient formation of intermediate surface species. To reveal and analyze the interaction of individual surface processes, a detailed dynamic microkinetic model approach is established and validated using cyclic voltammetry. We show that the interaction of three different processes, which are the adsorption of water, one potential-driven deprotonation step, and the detachment of oxygen, limits the overall reaction turnover. During the reaction, the active IrO2 surface is covered mainly by *O, *OOH, and *OO adsorbed species with a share dependent on the applied potential and of 44, 28, and 20% at an overpotential of 350 mV, respectively. In contrast to state-of-the-art calculations of ideal catalyst surfaces, this novel model-based methodology allows for experimental identification of the microkinetics as well as thermodynamic energy values of real pristine and degraded nanoparticles. We show that the loss in electrocatalytic activity during degradation is correlated to an increase in the activation energy of deprotonation processes, whereas reaction energies were marginally affected. As the effect of electrolyte-related parameters does not cause such a decrease, the model-based analysis demonstrates that material changes trigger the performance loss. These insights into the degradation of IrO2 and its effect on the surface processes provide the basis for a deeper understanding of degrading active sites for the optimization of the oxygen evolution performance.

Challenges of Green Production of 2,5-Furandicarboxylic Acid from Bio-Derived 5-Hydroxymethylfurfural: Overcoming Deactivation by Concomitant Amino Acids.

The oxidation of 5-hydroxymethylfurfural (HMF) to 2,5-furandicarboxylic acid (FDCA) is highly attractive as FDCA is considered as substitute for the petrochemically derived terephthalic acid. There are only few reports on the direct use of unrefined HMF solutions from biomass resources and the influence of remaining constituents on the catalytic processes. In this work, the oxidation of HMF in a solution as obtained from hydrolysis and dehydration of saccharides in chicory roots was investigated without intermediate purification steps. The amount of base added to the solution was critical to increase the FDCA yield. Catalyst deactivation occurred and was attributed to poisoning by amino acids from the bio-source. A strong influence of amino acids on the catalytic activity was found for all supported Au, Pt, Pd, and Ru catalysts. A supported AuPd(2 : 1)/C alloy catalyst exhibited both superior catalytic activity and higher stability against deactivation by the critical amino acids.

Identifying Performance Descriptors in CO2 Hydrogenation over Iron-Based Catalysts Promoted with Alkali Metals.

Alkali metal promoters have been widely employed for preparation of heterogeneous catalysts used in many industrially important reactions. However, the fundamentals of their effects are usually difficult to access. Herein, we unravel mechanistic and kinetic aspects of the role of alkali metals in CO2 hydrogenation over Fe-based catalysts through state-of-the-art characterization techniques, spatially resolved steady-state and transient kinetic analyses. The promoters affect electronic properties of iron in iron carbides. These carbide characteristics determine catalyst ability to activate H2 , CO and CO2 . The Allen scale electronegativity of alkali metal promoter was successfully correlated with the rates of CO2 hydrogenation to higher hydrocarbons and CH4 as well as with the rate constants of individual steps of CO or CO2 activation. The derived knowledge can be valuable for designing and preparing catalysts applied in other reactions where such promoters are also used.

Bioderived Muconates by Cross-Metathesis and Their Conversion into Terephthalates.

Polyethylene terephthalate that is 100 % bioderived is in high demand in the market guided by the ever-more exigent sustainability regulations with the challenge of producing renewable terephthalic acid remaining. Renewable terephthalic acid or its precursors can be obtained by Diels-Alder cycloaddition and further dehydrogenation of biomass-derived muconic acid. The cis,cis isomer of the dicarboxylic acid is typically synthesized by fermentation with genetically modified microorganisms, a process that requires complex separations to obtain a high yield of the pure product. Furthermore, the cis isomer has to be transformed into the trans,trans form and has to be esterified before it is suitable for terephthalate synthesis. To overcome these challenges, we investigated the synthesis of dialkyl muconates by cross-metathesis. The Ru-catalyzed cross-coupling of sorbates with acrylates, which can be bioderived, proceeded selectively to yield diester muconates in up to 41 % yield by using very low catalyst amounts (0.5-3.0 mol %) and no solvent. In the optimized procedure, the muconate precipitated as a solid and was easily recovered from the reaction medium. Analysis by GC-MS and NMR spectroscopy showed that this method delivered exclusively the trans,trans isomer of dimethyl muconate. The Diels-Alder reaction of dimethyl muconate with ethylene was studied in various solvents to obtain 1,4-bis(carbomethoxy)cyclohexene. The cycloaddition proceeded with very high conversions (77-100 %) and yields (70-98 %) in all of the solvents investigated, and methanol and tetrahydrofuran were the best choices. Next, the aromatization of 1,4-bis(carbomethoxy)cyclohexene to dimethyl terephthalate over a Pd/C catalyst resulted in up to 70 % yield in tetrahydrofuran under an air atmosphere. Owing to the high yield of the reaction of dimethyl muconate to 1,4-bis(carbomethoxy)cyclohexene, no separation step was needed before the aromatization. This is the first time that cross-metathesis is used to produce bioderived trans,trans-muconates as precursors to renewable terephthalates, important building blocks in the polymer industry.

Production of p-Methylstyrene and p-Divinylbenzene from Furanic Compounds.

A four-step catalytic process was developed to produce p-methylstyrene from methylfuran, a biomass-derived species. First, methylfuran was acylated over zeolite H-Beta with acetic anhydride. Second, the acetyl group was reduced to an ethyl group with hydrogen over copper chromite. Third, p-ethyltoluene was formed through Diels-Alder cycloaddition and dehydration of 2-ethyl-5-methyl-furan with ethylene over zeolite H-Beta. Dehydrogenation of p-ethyltoluene to yield p-methylstyrene completes the synthesis but was not investigated because it is a known process. The first two steps were accomplished in high yield (>88 %) and the Diels-Alder step resulted in a 67 % yield of p-ethyltoluene with a 99.5 % selectivity to the para isomer (final yield of 53.5 %). The methodology was also used for the preparation of p-divinylbenzene. It is shown that acylation of furans over H-Beta zeolites is a highly selective and high-yield reaction that could be used to produce other valuable molecules from biomass-derived furans.