ABSTRACT
In this study, we deposit a Ge-rich Ge-Sb-Te alloy by physical vapor deposition (PVD) in the amorphous phase on silicon substrates. We study in-situ, by X-ray and ultraviolet photoemission spectroscopies (XPS and UPS), the electronic properties and carefully ascertain the alloy composition to be GST 29 20 28. Subsequently, Raman spectroscopy is employed to corroborate the results from the photoemission study. X-ray diffraction is used upon annealing to study the crystallization of such an alloy and identify the effects of phase separation and segregation of crystalline Ge with the formation of grains along the [111] direction, as expected for such Ge-rich Ge-Sb-Te alloys. In addition, we report on the electrical characterization of single memory cells containing the Ge-rich Ge-Sb-Te alloy, including I-V characteristic curves, programming curves, and SET and RESET operation performance, as well as upon annealing temperature. A fair alignment of the electrical parameters with the current state-of-the-art of conventional (GeTe)n-(Sb2Te3)m alloys, deposited by PVD, is found, but with enhanced thermal stability, which allows for data retention up to 230 °C.
ABSTRACT
In this study, 4H-SiC p-n junctions were irradiated with 700 keV He+ ions in the fluence range 1.0 × 1012 to 1.0 × 1015 ions/cm2. The effects of irradiation were investigated by current-voltage (I-V) and capacitance-voltage (C-V) measurements, while deep-level transient spectroscopy (DLTS) was used to study the traps introduced by irradiation defects. Modifications of the device's electrical performances were observed after irradiation, and two fluence regimes were identified. In the low fluence range (≤1013 ions/cm2), I-V characteristics evidenced an increase in series resistance, which can be associated with the decrease in the dopant concentration, as also denoted by C-V measurements. In addition, the pre-exponential parameter of junction generation current increased with fluence due to the increase in point defect concentration. The main produced defect states were the Z1/2, RD1/2, and EH6/7 centers, whose concentrations increased with fluence. At high fluence (>1013 ions/cm2), I-V curves showed a strong decrease in the generation current, while DLTS evidenced a rearrangement of defects. The detailed electrical characterization of the p-n junction performed at different temperatures highlights the existence of conduction paths with peculiar electrical properties introduced by high fluence irradiation. The results suggest the formation of localized highly resistive regions (realized by agglomeration of point defects) in parallel with the main junction.
ABSTRACT
4H-SiC based p-n junction UV photo-detectors were irradiated with 600 keV He+ in the fluence range of 5 × 1011 ÷ 5 × 1014 ion/cm2 in order to investigate their radiation hardness. The effects of irradiation on the electro-optical performance were monitored in dark condition and in the UV (200 ÷ 400 nm) range, as well as in the visible region confirming the typical visible blindness of unirradiated and irradiated SiC photo-sensors. A decrease of UV optical responsivity occurred after irradiation and two fluence regimes were identified. At low fluence (<1013 ions/cm2), a considerable reduction of optical responsivity (of about 50%) was measured despite the absence of relevant dark current changes. The presence of irradiation induced point defects and then the reduction of photo-generated charge lifetime are responsible for a reduction of the charge collection efficiency and then of the relevant optical response reduction: point defects act as recombination centers for the photo-generated charges, which recombine during the drift/diffusion toward the electrodes. At higher irradiation fluence, the optical responsivity is strongly reduced due to the formation of complex defects. The threshold between low and high fluence is about 100 kGy, confirming the radiation hardness of SiC photo-sensors.
ABSTRACT
Multi-walled carbon nanotubes (CNTs) decorated with zinc oxide nanoparticles (ZnO NPs) were prepared in isopropanol solution by a simple, room-temperature process and characterized from structural, morphological, electronic, and optical points of view. A strong interaction between ZnO and CNTs is fully confirmed by all the characterization techniques. ZnO-CNTs nanocomposites, with different weight ratios, were deposited as a dense layer between two electrodes, in order to investigate the electrical behaviour. In particular, the electrical response of the nanocomposite layers to UV light irradiation was recorded for a fixed voltage: As the device is exposed to the UV lamp, a sharp current drop takes place and then an increase is observed as the irradiation is stopped. The effect can be explained by adsorption and desorption phenomena taking place on the ZnO nanoparticle surface under irradiation and by charge transfer between ZnO and CNTs, thanks to the strong interaction between the two nanomaterials. The nanocomposite material shows good sensitivity and fast response to UV irradiation. Room temperature and low-cost processes used for the device preparation combined with room temperature and low voltage operational conditions make this methodology very promising for large scale UV detectors applications.