The effect of trochleoplasty on patellar stability and kinematics: a biomechanical study in vitro.

Objective patellar instability has been correlated with dysplasia of the femoral trochlea. This in vitro study tested the hypothesis that trochleoplasty would increase patellar stability and normalise the kinematics of a knee with a dysplastic trochlea. Six fresh-frozen knees were loaded via the heads of the quadriceps. The patella was displaced 10 mm laterally and the displacing force was measured from 0 degrees to 90 degrees of flexion. Patellar tracking was measured from 0 degrees to 130 degrees of knee flexion using magnetic sensors. These tests were repeated after raising the central anterior trochlea to simulate dysplasia, and repeated again after performing a trochleoplasty on each specimen. The simulated dysplasia significantly reduced stability from that of the normal knee (p < 0.001). Trochleoplasty significantly increased the stability (p < 0.001), so that it did not then differ significantly from the normal knee (p = 0.244). There were small but statistically significant changes in patellar tracking (p< 0.001). This study has provided objective biomechanical data to support the use of trochleoplasty in the treatment of patellar instability associated with femoral trochlear dysplasia.

Effects of lateral retinacular release on the lateral stability of the patella.

The objective of this cadaveric study was to evaluate quantitatively the effects of lateral retinacular release on the lateral stability of the patella. A materials testing machine was used to displace the patella of seven cadaveric specimens 10 mm laterally while measuring the required force, with 175 N quadriceps tension. The patella was connected via a ball-bearing patellar mounting 10 mm deep to the anterior surface to allow rotations. Patellar force--displacement behaviour was tested from 0 degrees to 60 degrees knee flexion. At 0 degrees , 10 degrees and 20 degrees flexion the mean force required to displace the patella 10 mm laterally was reduced significantly due to lateral retinacular release, by 16-19%. The average force required to displace the patella was also reduced for larger flexion angles, although this was not statistically significant. These findings suggest that lateral retinacular release may not be appropriate in treatment of patellar lateral instability.

The effects of articular, retinacular, or muscular deficiencies on patellofemoral joint stability: a biomechanical study in vitro.

Normal function of the patellofemoral joint is maintained by a complex interaction between soft tissues and articular surfaces. No quantitative data have been found on the relative contributions of these structures to patellar stability. Eight knees were studied using a materials testing machine to displace the patella 10 mm laterally and medially and measure the force required. Patellar stability was tested from 0 degrees to 90 degrees knee flexion with the quadriceps tensed to 175 N. Four conditions were examined: intact, vastus medialis obliquus relaxed, flat lateral condyle, and ruptured medial retinaculae. Abnormal trochlear geometry reduced the lateral stability by 70% at 30 degrees flexion, while relaxation of vastus medialis obliquus caused a 30% reduction. Ruptured medial retinaculae had the largest effect at 0 degrees flexion with 49% reduction. There was no effect on medial stability. There is a complex interaction between these structures, with their contributions to loss of lateral patellar stability varying with knee flexion.

Tensile strength of the medial patellofemoral ligament before and after repair or reconstruction.

The tensile strength of the medial patellofemoral ligament (MPFL), and of surgical procedures which reconstitute it, are unknown. Ten fresh cadaver knees were prepared by isolating the patella, leaving only the MPFL as its attachment to the medial femoral condyle. The MPFL was either repaired by using a Kessler suture or reconstructed using either bone anchors or one of two tendon grafting techniques. The tensile strength and the displacement to peak force of the MPFL were then measured using an Instron materials-testing machine. The MPFL was found to have a mean tensile strength of 208 N (SD 90) at 26 mm (SD 7) of displacement. The strengths of the other techniques were: sutures alone, 37 N (SD 27); bone anchors plus sutures, 142 N (SD 39); blind-tunnel tendon graft, 126 N (SD 21); and through-tunnel tendon graft, 195 N (SD 66). The last was not significantly weaker than the MPFL itself.

Quantitative measurement of patellofemoral joint stability: force-displacement behavior of the human patella in vitro.

Patellofemoral joint instability is a common clinical problem. However, little quantitative data are available describing the stability characteristics of this joint. We measured the stability of the patella against both lateral and medial displacements across a range of knee flexion angles while the quadriceps were loaded physiologically. For eight fresh-frozen knee specimens a materials testing machine was used to displace the patella 10 mm laterally and 10 mm medially while measuring the required force, with 175 N quadriceps tension. The patella was connected via a ball-bearing patellar mounting 10 mm deep to the anterior surface to allow natural tilt and other rotations. Patellar force-displacement behavior was tested at flexion angles of 0 degrees, 10 degrees, 20 degrees, 30 degrees, 45 degrees, 60 degrees, and 90 degrees. Significant differences were found between the lateral and medial restraining forces at 10 mm displacement. For lateral displacement, the restraining force was least at 20 degrees of knee flexion (74 N at 10 mm displacement), rising to 125 N at 0 degrees and 90 degrees of knee flexion. The restraining force increased progressively with knee flexion for medial patellar displacement, from 147 N at 0 degrees to 238 N at 90 degrees. With quadriceps tension, the patella was more resistant to medial than lateral displacement. Our finding that lateral patellar displacement occurred at the lowest restraining force when the knee was flexed 20 degrees agrees with clinical experience of patellar instability.

Anatomy and biomechanics of the medial patellofemoral ligament.

The medial patellofemoral ligament (MPFL) is a band of retinacular tissue connecting the femoral medial epicondyle to the medial edge of the patella. The MPFL is approximately 55 mm long, and its width has been reported to range from 3 to 30 mm. The MPFL is overlaid by the distal part of vastus medialis obliquus to a variable extent, and fibres of MPFL merge into the deep aspect of the muscle. Despite the MPFL being very thin, it had a mean tensile strength of 208 N, and has been reported to be the primary passive restraint to patellar lateral displacement. Lateral patellar displacement tests in vitro showed that the patella subluxed most easily at 20 degrees knee flexion. The contribution of the MPFL to resisting patellar lateral subluxation was greatest in the extended knee. This finding was linked to the retinaculae being tightest in full knee extension, and slackening with flexion.

Quantitative study of the quadriceps muscles and trochlear groove geometry related to instability of the patellofemoral joint.

This was a quantitative study of the major anatomical structures associated with instability of the patellofemoral joint: the quadriceps muscles and the femoral trochlear groove. The attachments of the muscles to the patella, their lines of action, and their relative sizes (physiological cross-sectional areas) were found. On the basis of the physiological cross-sectional areas, it was estimated that the central muscles-the rectus femoris and vastus intermedius-contributed 35% of the quadriceps strength, with 40% from the vastus lateralis and 25% from the vastus medialis. The vastus lateralis had the most variable results, with the ratio of the lateralis to the medialis ranging from 0.90 to 2.18; this may be associated with patellar instability. Both the long and oblique parts of the vastus medialis were more oblique than the corresponding parts of the vastus lateralis. Photographic "skyline" views of the trochlear groove produced data on the sulcus angle and ratio of depth to width. The data showed that the trochlear groove did not deepen in the area contacted by the patella with progressive knee flexion (p > 0.53), contrary to popular belief. These data are useful for objective analysis of patellofemoral stability and related surgical interventions.