Porous Polylactide Microparticles as Effective Fillers for Hydrogels.

High-strength composite hydrogels based on collagen or chitosan-genipin were obtained via mixing using highly porous polylactide (PLA) microparticles with diameters of 50-75 µm and porosity values of over 98%. The elastic modulus of hydrogels depended on the filler concentration. The modulus increased from 80 kPa to 400-600 kPa at a concentration of porous particles of 12-15 wt.% and up to 1.8 MPa at a filling of 20-25 wt.% for collagen hydrogels. The elastic modulus of the chitosan-genipin hydrogel increases from 75 kPa to 900 kPa at a fraction of particles of 20 wt.%. These elastic modulus values cover a range of strength properties from connective tissue to cartilage tissue. It is important to note that the increase in strength in this case is accompanied by a decrease in the density of the material, that is, an increase in porosity. PLA particles were loaded with C-phycocyanin and showed an advanced release profile up to 48 h. Thus, composite hydrogels mimic the structure, biomechanics and release of biomolecules in the tissues of a living organism.

Chitosan Sponges for Efficient Accumulation and Controlled Release of C-Phycocyanin.

The paper proposed a new porous material for wound healing based on chitosan and C-phycocyanin (C-PC). In this work, C-PC was extracted from the cyanobacteria Arthrospira platensis biomass and purified through ammonium sulfate precipitation. The obtained C-PC with a purity index (PI) of 3.36 ± 0.24 was loaded into a chitosan sponge from aqueous solutions of various concentrations (250, 500, and 1000 mg/L). According to the FTIR study, chitosan did not form new bonds with C-PC, but acted as a carrier. The encapsulation efficiency value exceeded 90%, and the maximum loading capacity was 172.67 ± 0.47 mg/g. The release of C-PC from the polymer matrix into the saline medium was estimated, and it was found 50% of C-PC was released in the first hour and the maximum concentration was reached in 5-7 h after the sponge immersion. The PI of the released C-PC was 3.79 and 4.43 depending on the concentration of the initial solution.

Methods coagulation/flocculation and flocculation with ballast agent for effective harvesting of microalgae.

The effects of coagulant (FeCl3·6H2O), various flocculants based on polyacrylamide (PAA), polyethylenoxide (PEO) and flocculated biomass as ballast agent, dosage and sedimental time on flocculation efficiency of harvesting Chlorella vulgaris GKV1 cultivated in a laboratory were investigated. The results of this work indicated that the flocculation efficiency achieved about 90% after 5 min of sedimentation when adding of coagulant and flocculant mixture (FeCl3 50 mg/l+PEO based Sibfloc-718 7.5 mg/l) or flocculant with ballast agent (Sibfloc-718 7.5 mg/l+10% flocculated biomass). PAA and PEO showed good flocculation efficiency at dosage of 0.025 and 0.015 g/l, respectively without pH adjustment. Finally, the most suitable flocculation method was discussed in this paper.

Lipids of the zygomycete Absidia corymbifera F-965.

The cell lipids of the zygomycete Absidia corymbifera F-965 extracted with isopropanol and CHCl3-MeOH mixtures at the exponential growth phase comprise 20+/-2% of mycelium dry wt. The lipids consist of: triacylglycerols (51% of the total lipids extracted), diacylglycerols (9%), monoacylglycerols (3%), ergosterol (5%), ergosterol peroxide (5alpha,8alpha-epidioxyergosta-6,22-diene-3beta-ol) (3%), fatty-acid esters of ergosterol (less than 0.5%), free fatty acids (4%), glucocerebroside (3%), and glycerophospholipids (22%). The main phospholipids are phosphatidylethanolamine (39% of the total phospholipids), phosphatidyl-myo-inositol (17%), diphosphatidylglycerol (12%), phosphatidic acid (7%), phosphatidylcholine (6%), phosphatidylglycerol (3%), and two unusual phospholipids reported earlier, N-acetylphosphatidylethanolamine (7%) and N-ethoxycarbonyl phosphatidylethanolamine (9%). In addition, two unknown acidic phospholipids are present in traces. Saturated fatty acids of the lipids are dominated by n-hexadecanoic acid and unsaturated ones by octadecenoic acid; octadecadienoic and octadecatrienoic acids are present in lesser amounts. Ergosterol peroxide as well as the above glucocerebroside which contains 9-methylsphinga-4(E),9(E)-dienine have first been revealed in zygomycetes.