Addition of genes for cellobiase and pectinolytic activity in Escherichia coli for fuel ethanol production from pectin-rich lignocellulosic biomass.

Ethanologenic Escherichia coli strain KO11 was sequentially engineered to contain the Klebsiella oxytoca cellobiose phosphotransferase genes (casAB) as well as a pectate lyase (pelE) from Erwinia chrysanthemi, yielding strains LY40A (casAB) and JP07 (casAB pelE), respectively. To obtain an effective secretion of PelE, the Sec-dependent pathway out genes from E. chrysanthemi were provided on a cosmid to strain JP07 to construct strain JP07C. Finally, oligogalacturonide lyase (ogl) from E. chrysanthemi was added to produce strain JP08C. E. coli strains LY40A, JP07, JP07C, and JP08C possessed significant cellobiase activity in cell lysates, while only strains JP07C and JP08C demonstrated extracellular pectate lyase activity. Fermentations conducted by using a mixture of pure sugars representative of the composition of sugar beet pulp (SBP) showed that strains LY40A, JP07, JP07C, and JP08C were able to ferment cellobiose, resulting in increased ethanol production from 15 to 45% in comparison to that of KO11. Fermentations with SBP at very low fungal enzyme loads during saccharification revealed significantly higher levels of ethanol production for LY40A, JP07C, and JP08C than for KO11. JP07C ethanol yields were not considerably higher than those of LY40A; however, oligogalacturonide polymerization studies showed an increased breakdown of biomass to small-chain (degree of polymerization, ≤6) oligogalacturonides. JP08C achieved a further breakdown of polygalacturonate to monomeric sugars, resulting in a 164% increase in ethanol yields compared to those of KO11. The addition of commercial pectin methylesterase (PME) further increased JP08C ethanol production compared to that of LY40A by demethylating the pectin for enzymatic attack by pectin-degrading enzymes.

Multifaceted characterization of cell wall decomposition products formed during ammonia fiber expansion (AFEX) and dilute acid based pretreatments.

Decomposition products formed/released during ammonia fiber expansion (AFEX) and dilute acid (DA) pretreatment of corn stover (CS) were quantified using robust mass spectrometry based analytical platforms. Ammonolytic cleavage of cell wall ester linkages during AFEX resulted in the formation of acetamide (25mg/g AFEX CS) and various phenolic amides (15mg/g AFEX CS) that are effective nutrients for downstream fermentation. After ammonolysis, Maillard reactions with carbonyl-containing intermediates represent the second largest sink for ammonia during AFEX. On the other hand, several carboxylic acids were formed (e.g. 35mg acetic acid/g DA CS) during DA pretreatment. Formation of furans was 36-fold lower for AFEX compared to DA treatment; while carboxylic acids (e.g. lactic and succinic acids) yield was 100-1000-fold lower during AFEX compared to previous reports using sodium hydroxide as pretreatment reagent.

Effect of varying feedstock-pretreatment chemistry combinations on the formation and accumulation of potentially inhibitory degradation products in biomass hydrolysates.

A variety of potentially inhibitory degradation products are produced during pretreatment of lignocellulosic biomass. Qualitative and quantitative interrogation of pretreatment hydrolysates is paramount to identifying potential correlations between pretreatment chemistries and microbial inhibition in downstream bioconversion processes. In the present study, corn stover, poplar, and pine feedstocks were pretreated under eight different chemical conditions, which are representative of leading pretreatment processes. Pretreatment processes included: 0.7% H(2)SO(4), 0.07% H(2)SO(4), liquid hot water, neutral buffer solution, aqueous ammonia, lime, lime with oxygen pressurization, and wet oxidation. Forty lignocellulosic degradation products resulting from pretreatment were analyzed using high performance liquid chromatography in combination with UV spectroscopy or tandem mass spectrometry detection (HPLC-PDA-MS/MS) and ion chromatography (IC). Of these compounds, several have been reported to be inhibitory, including furfural, hydroxymethyl furfural, ferulic acid, 3,4-dihydroxybenzaldehyde, syringic acid among others. Formation and accumulation of monitored compounds in hydrolysates is demonstrated to be a function of both the feedstock and pretreatment conditions utilized.

Analytical characterization of fermentation inhibitors in biomass pretreatment samples using liquid chromatography, UV-visible spectroscopy, and tandem mass spectrometry.

A variety of chemicals are produced upon pretreatment of lignocellulosic biomass. Aliphatic acids, aromatic acids, aldehydes, and phenolic compounds are of particular interest due to their presumed inhibitory influence on downstream enzymatic or microbial steps in biomass-to-ethanol conversion. Herein, we describe a series of analytical protocols that collectively enable quantitative monitoring of 40 potential fermentation inhibitors in biomass pretreatment samples. Solid samples are accommodated by first employing pressurized fluid extraction to generate an aqueous "wash stream." Sample preparation for liquids involves an initial precipitation-filtration step, followed by liquid-liquid extraction and reconstitution of extracts in water. Samples are analyzed using high-performance liquid chromatography (HPLC) in combination with ultraviolet (UV) absorbance and tandem mass spectrometry (MS/MS) detection. A standard addition approach is utilized for quantitation to alleviate complications arising from co-extracted sample matrix.

Enzymatic digestibility and pretreatment degradation products of AFEX-treated hardwoods (Populus nigra).

There is a growing need to find alternatives to crude oil as the primary feed stock for the chemicals and fuel industry and ethanol has been demonstrated to be a viable alternative. Among the various feed stocks for producing ethanol, poplar (Populus nigra x Populus maximowiczii) is considered to have great potential as a biorefinery feedstock in the United States, due to their widespread availability and good productivity in several parts of the country. We have optimized AFEX pretreatment conditions (180 degrees C, 2:1 ammonia to biomass loading, 233% moisture, 30 minutes residence time) and by using various combinations of enzymes (commercical celluloses and xylanases) to achieve high glucan and xylan conversion (93 and 65%, respectively). We have also identified and quantified several important degradation products formed during AFEX using liquid chromatography followed by mass spectrometry (LC-MS/MS). As a part of degradation product analysis, we have also quantified oligosaccharides in the AFEX water wash extracts by acid hydrolysis. It is interesting to note that corn stover (C4 grass) can be pretreated effectively using mild AFEX pretreatment conditions, while on the other hand hardwood poplar requires much harsher AFEX conditions to obtain equivalent sugar yields upon enzymatic hydrolysis. Comparing corn stover and poplar, we conclude that pretreatment severity and enzymatic hydrolysis efficiency are dictated to a large extent by lignin carbohydrate complexes and arabinoxylan cross-linkages for AFEX.