Two quantitative trait loci on Sus scrofa chromosomes 1 and 7 affecting the number of vertebrae.

The objective of the research was to identify QTL affecting the number of vertebrae in swine, one of the major determining factors of growth and body composition. Previously, we reported a QTL for the number of vertebrae located on SSC1qter (terminal band of the q arm of SSC 1) in an F2 family produced by crossing a Göttingen miniature male with two Meishan females. Eight other swine families were subsequently produced by crosses between different breeds of European, Asian, and miniature pigs. In these families, the QTL on SSC1qter for the number of vertebrae was detected. Unlike the Asian alleles, all European alleles in this study had the effect of increasing the number of vertebrae by 0.44 to 0.69 and acted additively without dominance. The Göttingen miniature sire, for which we previously reported a smaller additive effect, seemed to be heterozygous at the QTL. In the present study, another QTL was found for the number of vertebrae on SSC7. This QTL was not fixed in the European pigs used as parents in our experimental families, and some of the European alleles increased the number of vertebrae. A half-sib analysis confirmed that this QTL was segregating in a commercial Large White population. Analysis in an F2 family in which the parental pigs were fixed for alternative alleles revealed that the effects of the QTL on SSC1 and on SSC7 were additive and similar in size. The two QTL acted independently without epistatic effects and explained an increase of more than two vertebrae.

Comparative analysis and development of microsatellite markers on swine (Sus scrofa) chromosome 1qter.

Several quantitative trait loci (QTL) have been detected on SSC1qter (Sus scrofa chromosome 1qter), including QTL for the number of vertebrae, as reported in our previous study. To provide the tools for analysis of QTLs on SSC1qter, we constructed a comparative map of swine and human. In addition, we identified 26 swine STSs and mapped 16 of them on SSC1qter using the INRA - University of Minnesota porcine radiation hybrid (IMpRH) panel. We screened a BAC library using these swine STSs and developed 35 new polymorphic microsatellite markers from the BAC clones, of which 26 were informative in our reference family. We also mapped nine microsatellite markers we had isolated previously. Consequently a total of 44 new polymorphic microsatellite markers were located within a 60-cM region of SSC1qter, spanning from SW1092 to the telomere.

Construction and evaluation of a porcine bacterial artificial chromosome library.

A porcine bacterial artificial chromosome (BAC) library consisting of 103,488 clones has been constructed. The average insert size in the BAC vector was calculated to be 133 kb based on the examination of 189 randomly selected clones, indicating that the library contained 4.4 genome equivalents. The library can be screened by two-step PCR. The first screening step is performed on 22 superpools, each containing 4704 clones (49 x 96 well plates). In the second screening step, 49 plates comprising a superpool are arrayed in a 7 x 7 matrix and 4D-PCR is performed. Screening of the library superpools by PCR for 125 marker sequences selected from different regions of swine genome revealed 123 sequences, indicating that the library is not biased. Subsequent screenings (4D-PCR) were successfully applied for identification of clones containing each marker sequence. This porcine BAC library and the PCR screening system are useful for isolation of genomic DNA fragments containing desired sequences.

Quantitative trait loci (QTL) analysis in a Meishan x Göttingen cross population.

In order to locate the genetic regions in the swine genome that are responsible for economically important traits, a resource population has been constructed by mating two female Meishan pigs with a male Göttingen miniature pig. In subsequent generations, 265 F2 offspring were produced from two F1 males and 19 F1 females. The F2 offspring were scored for eight traits including growth rate, teat number, vertebra number and backfat thickness, and genotyped for 318 genetic markers spanning the swine genome. Least-square analysis revealed quantitative trait loci (QTL) effects for vertebra number on chromosomes 1 and 2; for teat number on chromosomes 1 and 7; for birth weight on chromosome 1; for average daily gain between 4 and 13 weeks of age on chromosomes 9 and 10; for backfat thickness on chromosome 7; and for backskin thickness on chromosome 3.

A linkage map of 243 DNA markers in an intercross of Göttingen miniature and Meishan pigs.

A resource family of pigs has been constructed by using a boar of Göttingen miniature pig and two sows of Meishan pig as parents. In the construction of the family, two F1 males and 18 F1 females were intercrossed to generate 143 F2 offspring. The members of the family were genotyped using 243 genetic markers including 26 markers developed in our laboratory in order to generate a linkage map of markers for use in detecting quantitative trait loci (QTLs) in the family. The markers consisted of 237 microsatellites, five PRE-1 markers, and one RFLP marker. The linkage map was revealed to cover all 18 autosomes and the X chromosome; and the total length of the sex-averaged linkage map was calculated to be 2561.9 CM. Four out of the 26 markers developed in our laboratory exended the current linkage map at the termini of chromosomes 1p, 5p, 11p, and Xq. The linkage maps of all the chromosomes except for chromosome 1 were found to be longer in females than in males. Concerning chromosome 1, the length of the linkage map showed no difference between females and males, which was attributed to low recombination rates between markers localized in the centromeric region in females. The average ratio of female-to-male recombination was calculated to be 1.55.

Forty-channel phased array ultrasonic probe using 0.91Pb(Zn(1/3 )Nb(2/3))O(3)-0.09PbTiO(3) single crystal.

A 0.91Pb(Zn(1/3)Nb(2/3))O(3)-0.09PbTiO (3) (PZN-PT) single crystal with high electromechanical coupling factor (k(33))>90% has been used to fabricate a 40-channel phased array ultrasonic probe with greater sensitivity and broader bandwidth than conventional probes. This probe has a center frequency of 3.5 MHz and an aperture of about 6.0x7.5 mm. The standard probe fabrication process was modified for PZN-PT. The dispersion of echo signals was within +/-20% of the mean value. After recovery poling, the echo amplitude of the PZN-PT single-crystal probe is 8 and 5 dB higher than that of one- and two-matching-layer PZT probes, respectively. Moreover, the fractional bandwidth of the single-matching-layer PZN-PT probe is broader than that of the two-matching-layer PZT probes. The PZN-PT single crystals provide great improvements in the sensitivity and bandwidth of phased array probes.

A 3.7 MHz phased array probe using 0.91Pb(Zn(1/3)Nb(2/3))O(3)-0.09PbTiO(3 ).

A novel 128-channel phased array probe for echocardiography with a center frequency of 3.7 MHz using 0.91Pb(Zn(1/3)Nb(2/3))O(3)-0.09PbTiO(3 ) (PZN-9%PT) single crystal has been fabricated to realize greater sensitivity and broader bandwidth properties. The echo amplitude of the PZN-9%PT single-crystal probe is about 5 dB higher than that of the conventional lead airconate titanate (PZT) ceramic probe, and the fractional bandwidth is about 25 percentage points broader. The quality of B mode images obtained by the PZN-9%PT probe satisfies the performance of the two types of conventional PZT ceramic probes that have center frequencies of 2.5 and 3.75 MHz. At the reference frequency of 3 MHz, the Doppler sensitivity of the PZN-9%PT probe is about 5 dB higher than that of the 3.75 MHz PZT probe; the blood flow of a pulmonary vein in a hard-to-image patient is much more clearly imaged than in the case of using the PZT probe. These superior images are attributable to the use of sufficiently large PZN-9%PT single crystals obtained by the self-flux method.

A 20 MHz single-element ultrasonic probe using 0.91Pb(Zn(1/3 )Nb(2/3))O(3)-0.09PbTiO(3) single crystal.

A 20 MHz single-element ultrasonic probe using 0.91Pb(Zn(1/3 )Nb(2/3))O(3)-0.09PbTiO(3) (PZN-PT 91/9) single crystal has been fabricated. The single crystal of PZN-PT 91/9 orientated to the (001) plane has longitudinal coupling factor of k(33)>90%, which is much larger than the k(33)=70 to 80% of conventional Pb(Zr(1-x),Ti(x))O(3) (PZT) based ceramics. A single crystal of PZN-PT 91/9 without inclusion or crack has been grown with dimensions of about 25x15x5 mm by the self-flux method. Because mechanical strength in the fabrication of disk transducers orientated to the (001) plane was sufficiently strong, under the same conditions as are applied to conventional PZT ceramics, a piston single-element probe with a diameter of 2.0 mm and a frequency of 20 MHz was successfully fabricated. The bandwidth of the PZN-PT 91/9 probe was 13-26 MHz, which was 4 MHz broader than that of the conventional PZT probe.

Proso millet protein elevates plasma level of high-density lipoprotein: a new food function of proso millet.

We examined the effects of dietary proso-millet protein on plasma levels of high-density lipoprotein (HDL) cholesterol in different rats from animals reported in our previous studies. The results showed also, in this animal, that the ingestion of the millet protein elevates plasma levels of HDL-cholesterol like our earlier works. Taking into account the anti-atherogenic function of HDL, therefore, the millet protein would be useful as a new food ingredient which has the function that regulates cholesterol metabolism.