Comparison of three-dimensional printed resin crowns and preformed stainless steel crowns for primary molar restorations: a randomized controlled trial.

The importance of aesthetics in children has increased over time. Therefore, this multicenter randomized clinical trial aimed to analyze and compare three-dimensional (3D)-printed resin crowns (RCs) as a potential alternative to stainless-steel crowns (SSCs) for restoring primary molars with extensive carious lesions. According to the null hypothesis, no statistically significant difference was observed in restoration failure between RC and SSC groups. A total of 56 primary molars after pulp treatment at two dental hospitals were included. After pulp treatment, the teeth were randomly divided into two groups: SSCs (n = 28) and RCs (n = 28). At 1 week and 3, 6 and 12 months, the Quigley-Hein plaque index (QHI), gingival index (GI), occlusal wear, and survival rate were assessed by examination, radiography and alginate impressions. No significant difference in QHI was observed between the two groups. However, the GI at 12 months and occlusal wear in the RC group were significantly higher than those in the SSC group (p < 0.05). The survival rates were 100% in the SSC group and 82.1% in the RC group (p = 0.047). Cracks and discoloration were also observed in the RCs. Within the limitations of this study, 3D-printed RCs are aesthetically superior to SSCs and clinically easy to repair. However, if clinical effectiveness and safety are improved, RCs could potentially become a viable aesthetic alternative in the future.

Transcriptome Profiling of a Soybean Mutant with Salt Tolerance Induced by Gamma-ray Irradiation.

Salt stress is a significant abiotic stress that reduces crop yield and quality globally. In this study, we utilized RNA sequencing (RNA-Seq) to identify differentially expressed genes (DEGs) in response to salt stress induced by gamma-ray irradiation in a salt-tolerant soybean mutant. The total RNA library samples were obtained from the salt-sensitive soybean cultivar Kwangan and the salt-tolerant mutant KA-1285. Samples were taken at three time points (0, 24, and 72 h) from two tissues (leaves and roots) under 200 mM NaCl. A total of 967,719,358 clean reads were generated using the Illumina NovaSeq 6000 platform, and 94.48% of these reads were mapped to 56,044 gene models of the soybean reference genome (Glycine_max_Wm82.a2.v1). The DEGs with expression values were compared at each time point within each tissue between the two soybeans. As a result, 296 DEGs were identified in the leaves, while 170 DEGs were identified in the roots. In the case of the leaves, eight DEGs were related to the phenylpropanoid biosynthesis pathway; however, in the roots, Glyma.03G171700 within GmSalt3, a major QTL associated with salt tolerance in soybean plants, was differentially expressed. Overall, these differences may explain the mechanisms through which mutants exhibit enhanced tolerance to salt stress, and they may provide a basic understanding of salt tolerance in soybean plants.

High-Performance Nitric Oxide Gas Sensors Based on an Ultrathin Nanoporous Poly(3-hexylthiophene) Film.

Conjugated polymer (CP)-based organic field-effect transistors (OFETs) have been considered a potential sensor platform for detecting gas molecules because they can amplify sensing signals by controlling the gate voltage. However, these sensors exhibit significantly poorer oxidizing gas sensing performance than their inorganic counterparts. This paper presents a high-performance nitric oxide (NO) OFET sensor consisting of a poly(3-hexylthiophene) (P3HT) film with an ultrathin nanoporous structure. The ultrathin nonporous structure of the P3HT film was created via deposition through the shear-coating-assisted phase separation of polymer blends and selective solvent etching. The ultrathin nonporous structure of the P3HT film enhanced NO gas diffusion, adsorption, and desorption, resulting in the ultrathin nanoporous P3HT-film-based OFET gas sensor exhibiting significantly better sensing performance than pristine P3HT-film-based OFET sensors. Additionally, upon exposure to 10 ppm NO at room temperature, the nanoporous P3HT-film-based OFET gas sensor exhibited significantly better sensing performance (i.e., responsivity ≈ 42%, sensitivity ≈ 4.7% ppm-1, limit of detection ≈ 0.5 ppm, and response/recovery times ≈ 6.6/8.0 min) than the pristine P3HT-film-based OFET sensors.

Enhanced Nitric Oxide Sensing Performance of Conjugated Polymer Films through Incorporation of Graphitic Carbon Nitride.

Organic field-effect transistor (OFET) gas sensors based on conjugated polymer films have recently attracted considerable attention for use in environmental monitoring applications. However, the existing devices are limited by their poor sensing performance for gas analytes. This drawback is attributed to the low charge transport in and the limited charge-analyte interaction of the conjugated polymers. Herein, we demonstrate that the incorporation of graphitic carbon nitride (g-C3N4) into the conjugated polymer matrix can improve the sensing performance of OFET gas sensors. Moreover, the effect of graphitic carbon nitride (g-C3N4) on the gas sensing properties of OFET sensors based on poly(3-hexylthiophene) (P3HT), a conjugated polymer, was systematically investigated by changing the concentration of the g-C3N4 in the P3HT/g-C3N4 composite films. The obtained films were applied in OFET to detect NO gas at room temperature. In terms of the results, first, the P3HT/g-C3N4 composite films containing 10 wt.% g-C3N4 exhibited a maximum charge carrier mobility of ~1.1 × 10-1 cm2 V-1 S-1, which was approximately five times higher than that of pristine P3HT films. The fabricated P3HT/g-C3N4 composite film based OFET sensors presented significantly enhanced NO gas sensing characteristics compared to those of the bare P3HT sensor. In particular, the sensors based on the P3HT/g-C3N4 (90/10) composite films exhibited the best sensing performance relative to that of the bare P3HT sensor when exposed to 10 ppm NO gas: responsivity = 40.6 vs. 18.1%, response time = 129 vs. 142 s, and recovery time = 148 vs. 162 s. These results demonstrate the enormous promise of g-C3N4 as a gas sensing material that can be hybridized with conjugated polymers to efficiently detect gas analytes.

Microgels based on 0D-3D carbon materials: Synthetic techniques, properties, applications, and challenges.

Microgels are three-dimensional (3D) colloidal hydrogel particles with outstanding features such as biocompatibility, good mechanical properties, tunable sizes from submicrometer to tens of nanometers, and large surface areas. Because of these unique qualities, microgels have been widely used in various applications. Carbon-based materials (CMs) with various dimensions (0-3D) have recently been investigated as promising candidates for the design and fabrication of microgels because of their large surface area, excellent conductivity, unique chemical stability, and low cost. Here, we provide a critical review of the specific characteristics of CMs that are being incorporated into microgels, as well as the state-of-the art applications of CM-microgels in pollutant adsorption and photodegradation, H2 evoluation, CO2 capture, soil conditioners, water retention, drug delivery, cell encapsulation, and tissue engineering. Advanced preparation techniques for CM-microgel systems are also summarized and discussed. Finally, challenges related to the low colloidal stability of CM-microgels and development strategies are examined. This review shows that CM-microgels have the potential to be widely used in various practical applications.

Differential gene expression profiles of periodontal soft tissue from rat teeth after immediate and delayed replantation: a pilot study.

PURPOSE: In dental avulsion, delayed replantation usually has an uncertain prognosis. After tooth replantation, complex inflammatory responses promote a return to periodontal tissue homeostasis. Various types of cytokines are produced in the inflammatory microenvironment, and these cytokines determine the periodontal tissue response. This study aimed to identify the gene expression profiles of replanted teeth and evaluate the functional differences between immediate and delayed replantation. METHODS: Maxillary molars from Sprague-Dawley rats were extracted, exposed to a dry environment, and then replanted. The animals were divided into 2 groups according to the extra-oral time: immediate replantation (dry for 5 minutes) and delayed replantation (dry for 60 minutes). Either 3 or 7 days after replantation, the animals were sacrificed. Periodontal soft tissues were harvested for mRNA sequencing. Hallmark gene set enrichment analysis was performed to predict the function of gene-gene interactions. The normalized enrichment score (NES) was calculated to determine functional differences. RESULTS: The hallmark gene sets enriched in delayed replantation at 3 days were oxidative phosphorylation (NES=2.82, Q<0.001) and tumor necrosis factor-alpha (TNF-α) signaling via the nuclear factor kappa light chain enhancer of activated B cells (NF-κB) pathway (NES=1.52, Q=0.034). At 7 days after delayed replantation, TNF-α signaling via the NF-κB pathway (NES=-1.82, Q=0.002), angiogenesis (NES=-1.66, Q=0.01), and the transforming growth factor-beta signaling pathway (NES=-1.46, Q=0.051) were negatively highlighted. CONCLUSIONS: Differentially expressed gene profiles were significantly different between immediate and delayed replantation. TNF-α signaling via the NF-κB pathway was marked during the healing process. However, the enrichment score of this pathway changed in a time-dependent manner between immediate and delayed replantation.

Synthesis of aminoalkyl-substituted aurone derivatives as acetylcholinesterase inhibitors.

Alzheimer's disease (AD), a progressive and neurodegenerative disorder of the brain, is the most common cause of dementia among elderly people. To date, the successful therapeutic strategy to treat AD is maintaining the levels of acetylcholine by inhibiting acetylcholinesterase (AChE). In the present study, aurone derivatives were designed and synthesized as AChE inhibitors based on the lead structure of sulfuretin. Of those synthesized, compound 10d showed ca. 1700-fold and 6-fold higher AChE inhibitory activity than sulfuretin and galantamine, respectively. This compound also ameliorated scopolamine-induced memory deficit in mice when administered orally at the dose of 1 and 2mg/kg.

SIRT1 activation by methylene blue, a repurposed drug, leads to AMPK-mediated inhibition of steatosis and steatohepatitis.

Sirtuins maintain energy balance. Particularly, sirtuin 1 (SIRT1) activation mimics calorie restriction and nutrient utilization. However, no medications are available for the up-regulation of SIRT1. Methylene blue (MB) had been in clinical trials for the treatment of neurological diseases. This study investigated the effect of MB on sirtuin expression in association with the treatment of steatosis and steatohepatitis, and explored the underlying basis. The effects of MB on mitochondrial function, molecular markers, pharmacokinetics, and histopathology were assessed using hepatocyte and/or mouse models. Immunoblotting, PCR and reporter assays were done for molecular experiments. After oral administration, MB was well distributed in the liver. MB treatment increased NAD(+)/NADH ratio in hepatocytes. Of the major forms, MB treatment up-regulated SIRT1, and thereby decreased PGC-1α acetylation. Consistently, hepatic mitochondrial DNA contents and oxygen consumption rates were enhanced. MB treatment also notably activated AMPK, CPT-1 and PPARα: the AMPK activation relied on SIRT1. Activation of LXRα and the induction of SREBP-1c and its target genes by T0901317 were diminished by MB. In addition, MB treatment antagonized the ability of palmitate to acetylate PGC-1α, and increase SERBP-1c, FAS, and ACC levels. In mice fed on a high-fat diet for 8 weeks, MB treatment inhibited excessive hepatic fat accumulation and steatohepatitis. The ability of MB to activate SIRT1 promotes mitochondrial biogenesis and oxygen consumption and activates AMPK, contributing to anti-lipogenesis in the liver. Our results provide new information on the potential use of MB for the treatment of steatosis and steatohepatitis.

Synthesis of aurones and their inhibitory effects on nitric oxide and PGE2 productions in LPS-induced RAW 264.7 cells.

Sulfuretin is one of major constituents of Rhus verniciflua that exerts anti-inflammatory activities. Some of aurones were synthesized as sulfuretin derivatives and evaluated for their abilities to inhibit NO and PGE(2) production in LPS-induced RAW 264.7 cells in order to reveal the relationship. Of the aurones synthesized in the present study, 2h and 2i, which possess C-6 hydroxyl group in A-ring and methoxy substituents in B-ring, more potently inhibited NO and PGE(2) production and were less cytotoxic than sulfuretin.