ABSTRACT
Renewable cooling via absorption chillers being supplied by various green heat technologies such as solar collectors has been widely studied in the literature, but it is still challenging to get positive economic outcomes from such systems due to the large expenses of solar thermal systems. This study offers the use of a new generation of solar collectors, so-called eccentric reflective solar collectors, for driving single-effect absorption chillers and thereby reducing the levelized cost of cooling. This article develops the most optimal design of this system (based on several different scenarios) using multi-objective optimization techniques and employs them for a case study in Brazil to assess its proficiency compared to conventional solar-driven cooling methods. For making the benchmarking analyses fair, the conventional system is also rigorously optimized in terms of design and operation features. The results show that the eccentric solar collector would enhance the cost-effectiveness by 29%. In addition, using optimally sized storage units would be necessary to get acceptable economic performance from the system, no matter which collector type is used. For the case study, at the optimal sizing and operating conditions, the levelized cost of cooling will be 124 USD/MWh and an emission level of 18.97 kgCO2/MWh.
Subject(s)
Solar Energy , Sunlight , Cold Temperature , Hot Temperature , Phase TransitionABSTRACT
The combination of various methods of increasing evaporation rate can highly impact the performance of solar desalination. This investigation aims to find the impact of using evacuated tubes solar collector, perforated fins, and pebbles on the performance enhancement of a solar still. Simultaneously six-evacuated-tube solar collector to raise the evaporation rate of the system, the perforated fins to increase the heat transfer surface between water and absorber, and the immersed pebbles stone in the water to keep the high water temperature at low solar radiation were considered. The hourly and cumulative distillate output (DO) values are presented separately for the daytime and nighttime to provide extensive insight. The results indicate that on a sample day from the six months of experiments, which was in February 2019, the time for DO peak shifts from 1 to 3 p.m. Moreover, the temperature values for MSS experience almost 43 â jumps on the peak and almost 19 â increase on average compared to CSS. Furthermore, the cumulative DO in the daytime reaches from 2.515 to 6.662 L, while during the nighttime, an increase from 0.057 to 0.872 L is observed. Additionally, during the six months, the average DO jumps from 2.88 to 7.03 L, which means a significant enhancement of 144.1%. Moreover, the costs per liter of MSS and CSS are 0.0051 and 0.0056 dollars per liter, respectively. The net amount of CO2 reduction of MSS was improved by about 2.44 times higher than CSS.
Subject(s)
Carbon Dioxide , Solar Energy , Animals , Animal Fins , Fever , WaterABSTRACT
Solar still, as one of the important devices for generating water using renewable energy, has been widely used in arid as well as coastal areas where access to fresh water is limited. This paper uses CFD simulation to compare double-slope solar still, hemispherical solar still, and tubular solar still using nanofluid film cooling. Al2O3-water nanofluids with a concentration of 0.1% are used due to facilitate sunlight penetration into the absorber plate inside the solar desalination. It is assumed the flow is steady, laminar, and air is an ideal and incompressible gas. The simple algorithm is considered to calculate the relationship between pressure and velocity and to separate the transfer and pressure interpolation terms from the appropriate upstream designs. Also, the economic, exergoeconomic, and CO2 mitigation parameters of various solar stills were investigated. The study revealed that the water productivity of double-slope solar desalination using nanofluids film cooling is improved by about 4.8% compared with tubular solar desalination with nanofluid film cooling. Also, the lowest CPL of 0.0362 $/L was obtained in the double-slope solar desalination using nanofluid film cooling. The net CO2 mitigation of 14.08 tons, 13.72 tons, and 13.44 tons was obtained for double-slope solar desalination, hemispherical solar desalination, and tubular solar desalination, respectively.