Accessible interferometric autocorrelator for noise-like pulses based on a Fabry-Perot cavity.

In this work, we develop experimentally a Fabry-Perot fiber optic interferometer applied to the measurement of autocorrelation of complex dynamic pulses generated by a figure-eight fiber laser. The principle is based in the superposition of multiple pulses, which requires two partially reflecting flat surfaces in parallel, resulting in a simple and compact autocorrelator design. The autocorrelation trace obtained exhibits a typical double-scaled structure for noise-like pulses (NLPs), with an ultrashort coherence spur on the order of 100 fs riding upon a broad pedestal of 120 ps. Finally, we show experimentally that the developed Fabry-Perot device is able to measure accurately the autocorrelation of NLPs, as confirmed by comparing the measurement with that of a conventional autocorrelator scheme based on a Michelson interferometer, with the additional advantages of a more compact setup and a much easier alignment procedure compared to the latter.

Low-pressure and liquid level fiber-optic sensor based on polymeric Fabry-Perot cavity.

An experimental study of the interaction between a Mylar® polymer film and a multimode fiber-optic is presented for the simultaneous fiber-optic detection of low-pressure and liquid levels. The junction between the polymer and optical fiber produces an interference spectrum with maximal visibility and free spectral range around 9 dB and 31 nm, respectively. Water pressure, which is controlled by the liquid level, stresses the polymer. As a result, the spectrum wavelength shifts to the blue region, achieving high sensitivities around 2.49 nm/kPa and 24.5 nm/m. The polymeric membrane was analyzed using a finite element model; according to the results, the polymer shows linear stress response. Furthermore, the membrane material is operated below the yielding point. Moreover, the finite analysis provides information about the stress effect over the thickness and the birefringence changes. This sensor exhibits a quadratic polynomial fitting with an adjusted R-squared of 0.9539. The proposed sensing setup offers a cost-effective alternative for liquid level and low-pressure detection.