ABSTRACT
INTRODUCTION: Clonidine is an α2 agonist agent that has been used as an adjuvant to local anaesthetics in regional anaesthesia. AIM: This study compared two combinations of bupivacaine and clonidine with bupivacaine alone for surgeries below the level of umbilicus in spinal anaesthesia. MATERIALS AND METHODS: We conducted a randomized double blind study on 90 patients of ASA I and ASA II aged 20-60 years, 30 in each group, undergoing surgery below the level of umbilicus in spinal anaesthesia. For intrathecal block, Group 1 received bupivacaine hydrochloride 12.5mg (2.5ml) in 8% dextrose (0.5% sensorcaine heavy) + 1ml (150µg) of preservative free clonidine. Group 2 received bupivacaine hydrochloride 12.5mg (2.5ml) in dextrose (0.5% sensorcaine heavy) + 0.5ml (75µg) of preservative free clonidine + 0.5ml of normal saline to make the volumes of all the groups same. Group 3 received bupivacaine hydrochloride 2.5ml in 8% dextrose (0.5% sensorcaine heavy) + 1ml of normal saline to make the volumes of all the groups same. Heart rate, NIBP, oxygen saturation and respiratory rate were monitored. The onset and duration of sensory block, the highest dermatomal level of sensory block, motor block, time to complete motor block recovery and duration of spinal anaesthesia were recorded. STATISTICAL ANALYSIS: The data of the study was recorded in the record chart and results were evaluated using statistical tests (ANOVA test, post-hoc turkey hsd test, paired t-test and chi-square test). RESULTS: Demographic data, the incidence and duration of bradycardia were comparable amongst the groups. The duration of sensory and motor block were greatest in group 1, followed by group 2 and group 3 (p <0.01). Decrease in the systolic blood pressure of group 2 and group 3 was noted as compared to group 1. No significant sedation or respiratory depression was observed in any group. CONCLUSION: Addition of clonidine to bupivacaine intrathecally is although a reliable method to prolong spinal anaesthesia but close monitoring for hypotension is desirable.
ABSTRACT
INTRODUCTION: Ground water is the ultimate and most suitable fresh water resource for human consumption in the urban areas of India. Studies regarding ground water quality have shown that the higher rate of exploration as compared to the rate of recharging, inappropriate dumping of solid, as well as liquid waste, lack of strict enforcement of law has led to the deterioration of ground water quality. The present study was thus, carried out to evaluate physicochemical, as well as a microbiological profile of tap water, and filtered water in urban areas of Patiala, Punjab. MATERIALS AND METHODS: The three zones under Municipal Corporation and two areas under Public Health Department were chosen according to the simple random sampling from Patiala city. From each area, 10 houses were chosen according to the systematic random sampling technique (n = 50). Water was taken from two sources, tap water, and from the water filter. Two samples were taken from each source one for the physicochemical analysis and another for bacteriological analysis. The samples which were sent for bacteriological assessment were collected in a sterile container. RESULTS: The number of water samples found to be within desirable limits with respect to physicochemical parameters were significantly more with the filter water sample than the tap water samples. Suspicious/unsatisfactory microbiological quality of water was observed in 28% and 4% of tap and filter water samples, respectively. CONCLUSION: The results indicate that certain chemical parameters such as hardness, chloride, and fluoride levels were beyond the permissible limits. Therefore, we recommend that home filters should be installed, serviced appropriately, and their water quality should be checked routinely. Also, any leak from sewage pipes should be promptly repaired to prevent contamination of drinking water.
