Evolution of point defects in pulsed-laser-melted Ge1-xSnxprobed by positron annihilation lifetime spectroscopy.

Direct-band-gap Germanium-Tin alloys (Ge1-xSnx) with high carrier mobilities are promising materials for nano- and optoelectronics. The concentration of open volume defects in the alloy, such as Sn and Ge vacancies, influences the final device performance. In this article, we present an evaluation of the point defects in molecular-beam-epitaxy grown Ge1-xSnxfilms treated by post-growth nanosecond-range pulsed laser melting (PLM). Doppler broadening - variable energy positron annihilation spectroscopy and variable energy positron annihilation lifetime spectroscopy are used to investigate the defect nanostructure in the Ge1-xSnxfilms exposed to increasing laser energy density. The experimental results, supported with ATomic SUPerposition calculations, evidence that after PLM, the average size of the open volume defects increases, which represents a raise in concentration of vacancy agglomerations, but the overall defect density is reduced as a function of the PLM fluence. At the same time, the positron annihilation spectroscopy analysis provides information about dislocations and Ge vacancies decorated by Sn atoms. Moreover, it is shown that the PLM reduces the strain in the layer, while dislocations are responsible for trapping of Sn and formation of small Sn-rich-clusters.

Band-gap and strain engineering in GeSn alloys using post-growth pulsed laser melting.

The pseudomorphic growth of Ge1-xSnxon Ge causes in-plane compressive strain, which degrades the superior properties of the Ge1-xSnxalloys. Therefore, efficient strain engineering is required. In this article, we present strain and band-gap engineering in Ge1-xSnxalloys grown on Ge a virtual substrate using post-growth nanosecond pulsed laser melting (PLM). Micro-Raman and x-ray diffraction (XRD) show that the initial in-plane compressive strain is removed. Moreover, for PLM energy densities higher than 0.5 J cm-2, the Ge0.89Sn0.11layer becomes tensile strained. Simultaneously, as revealed by Rutherford Backscattering spectrometry, cross-sectional transmission electron microscopy investigations and XRD the crystalline quality and Sn-distribution in PLM-treated Ge0.89Sn0.11layers are only slightly affected. Additionally, the change of the band structure after PLM is confirmed by low-temperature photoreflectance measurements. The presented results prove that post-growth ns-range PLM is an effective way for band-gap and strain engineering in highly-mismatched alloys.