ABSTRACT
This paper presents a new approach to measure the force required to detach a water (a polar liquid) droplet from a hydrophobic surface. This is done by partially cloaking the droplet with a high-surface-tension oil-based ferrofluid and using a magnet to apply a controllable body force to the resulting compound droplet. Placing the assembly on a sensitive scale, the magnet can then be brought closer to the droplet to detach it from the surface while recording the forces applied to the droplet. The work presented here is novel as it uses the concept of partial cloaking in which the solid-droplet contact area is not contaminated by the ferrofluid (and the measured forces do not need postprocessing). Our study is accompanied by numerical simulations aimed at improving our understanding of the interplay between the interfacial forces in a two-phase droplet under the influence of a strong (detaching) body force and at providing additional data for in-depth analyses of these forces. In particular, the minimum ferrofluid volume required for successful water droplet detachment from hydrophobic surfaces is computed for ferrofluids of different surface tensions, and they are compared to experimental data obtained from detaching water droplets from electrospun polystyrene coatings. It is also shown that the detachment force measured via partial cloaking is independent of the volume of the ferrofluid used for the experiment.
ABSTRACT
Previous studies have demonstrated the capability of superhydrophobic surfaces to produce slip flow and drag reduction, which properties hold considerable promise for a broad range of applications. However, in order to implement such surfaces for practical utilizations, environmental factors such as water movement over the surface must be observed and understood. In this work, experiments were carried out to present a proof-of-concept study on the impact of flow on longevity of polystyrene fibrous coatings. The time-dependent hydrophobicity of a submerged coating in a pressure vessel was determined while exposing the coating to a rudimentary wall-jet flow. Rheological studies were also performed to determine the effect of the flow on drag reduction. The results show that the longevity of the surface deteriorates by increasing the flow rate. The flow appears to enhance the dissolution of air into water, which leads to a loss of drag reduction.
ABSTRACT
Light scattering was used to measure the time-dependent loss of air entrapped within a submerged microporous hydrophobic surface subjected to different environmental conditions. The loss of trapped air resulted in a measurable decrease in surface reflectivity and the kinetics of the process was determined in real time and compared to surface properties, such as porosity and morphology. The light-scattering results were compared with measurements of skin-friction drag, static contact angle, and contact-angle hysteresis. The in situ, noninvasive optical technique was shown to correlate well with the more conventional methods for quantifying surface hydrophobicity, such as flow slip and contact angle.