Using two detectors concurrently to monitor ambient dose equivalent rates in vehicle surveys of radiocesium contaminated land.

In response to the accident at Tokyo Electric Power Company's Fukushima Dai-ichi Nuclear Power Plant (FDNPP), vehicle-borne monitoring was used to map radiation levels for radiological protection of the public. By convention measurements from vehicle-borne surveys are converted to the ambient dose equivalent rate at 1 m height in the absence of the vehicle. This allows for comparison with results from other types of survey, including surveys with hand-held or airborne instruments. To improve the accuracy of the converted results from vehicle-borne surveys, we investigated combining measurements from two detectors mounted on the vehicle at different heights above the ground. A dual-detector setup was added to a JAEA monitoring car and compared against hand-held survey meter measurements in Fukushima Prefecture. The results obtained by combining measurements from two detectors were within ±20% of the hand-held reference measurements. The mean absolute percentage deviation from the reference measurements was 7.2%. The combined results from the two detectors were more accurate than those from either the roof-mounted detector, or the detector inside the vehicle, taken alone. One issue with vehicle-borne surveys is that ambient dose equivalent rates above roads are not necessarily representative of adjacent areas. This is because radiocesium is often deficient on asphalt surfaces, as it is easily scrubbed off by rain, wind and vehicle tires. To tackle this issue, we investigated mounting heights for vehicle-borne detectors using Monte Carlo gamma-ray simulations. When radiocesium is deficient on a road compared to the adjacent land, mounting detectors high on vehicles yields results closer to the values adjacent to the road. The ratio of ambient dose equivalent rates reported by detectors mounted at different heights in a dual-detector setup indicates whether radiocesium is deficient on the road compared to the adjacent land.

Coupling the advection-dispersion equation with fully kinetic reversible/irreversible sorption terms to model radiocesium soil profiles in Fukushima Prefecture.

Radiocesium is an important environmental contaminant in fallout from nuclear reactor accidents and atomic weapons testing. A modified Diffusion-Sorption-Fixation (mDSF) model, based on the advection-dispersion equation, is proposed to describe the vertical migration of radiocesium in soils following fallout. The model introduces kinetics for the reversible binding of radiocesium. We test the model by comparing its results to depth profiles measured in Fukushima Prefecture, Japan, since 2011. The results from the mDSF model are a better fit to the measurement data (as quantified by R2) than results from a simple diffusion model and the original DSF model. The introduction of reversible sorption kinetics means that the exponential-shape depth distribution can be reproduced immediately following fallout. The initial relaxation mass depth of the distribution is determined by the diffusion length, which depends on the distribution coefficient, sorption rate and dispersion coefficient. The mDSF model captures the long tails of the radiocesium distribution at large depths, which are caused by different rates for kinetic sorption and desorption. The mDSF model indicates that depth distributions displaying a peak in activity below the surface are possible for soils with high organic matter content at the surface. The mDSF equations thus offers a physical basis for various types of radiocesium depth profiles observed in contaminated environments.