ABSTRACT
Ibuprofen (IBU) is one of the most-sold anti-inflammatory drugs in the world, and its residues can reach aquatic systems, causing serious health and environmental problems. Strategies are used to improve the photocatalytic activity of zinc oxide (ZnO), and thosethat involvethe inclusion of metalhave received special attention. The aim of this work was to investigate the influence of the parameters and toxicity of a photoproduct using zinc oxide that contains cerium (ZnO-Ce) for the photodegradation of ibuprofen. The parameters include the influence of the photocatalyst concentration (0.5, 0.5, and 1.5 g L-1) as well as the effects of pH (3, 7, and 10), the effect of H2O2, and radical scavengers. The photocatalyst was characterized by Scanning Electron Microscopy-Energy Dispersive Spectroscopy, Transmission electron microscopy, Raman, X-Ray Diffraction, surface area, and diffuse reflectance. The photocatalytic activity of ibuprofen was evaluated in an aqueous solution under UV light for 120 min. The structural characterization by XRD and SEM elucidated the fact that the nanoparticle ZnO contained cerium. The band gap value was 3.31 eV. The best experimental conditions for the photodegradation of IBU were 60% obtained in an acidic condition using 0.50 g L-1 of ZnO-Ce in a solution of 20 ppm of IBU. The presence of hydrogen peroxide favored the photocatalysis process. ZnO-Ce exhibited good IBU degradation activity even after three photocatalytic cycles under UV light. The hole plays akey role in the degradation process of ibuprofen. The toxicity of photolyzed products was monitored against Artemia salina (bioindicator) and did not generate toxic metabolites. Therefore, this work provides a strategic design to improve ZnO-Ce photocatalysts for environmental remediation.
ABSTRACT
Molybdates are biocidal materials that can be useful in coating surfaces that are susceptible to contamination and the spread of microorganisms. The aim of this work was to investigate the effects of copper doping of hydrated cobalt molybdate, synthesized by the co-precipitation method, on its antibacterial activity and to elucidate the structural and morphological changes caused by the dopant in the material. The synthesized materials were characterized by PXRD, Fourier Transformed Infrared (FTIR), thermogravimetric analysis/differential scanning calorimetry (TG/DSC), and SEM-Energy Dispersive Spectroscopy (SEM-EDS). The antibacterial response of the materials was verified using the Minimum Inhibitory Concentration (MIC) employing the broth microdilution method. The size of the CoMoO4·1.03H2O microparticles gradually increased as the percentage of copper increased, decreasing the energy that is needed to promote the transition from the hydrated to the beta phase and changing the color of material. CoMoO4·1.03H2O obtained better bactericidal performance against the tested strains of Staphylococcus aureus (gram-positive) than Escherichia coli (gram-negative). However, an interesting point was that the use of copper as a doping agent for hydrated cobalt molybdate caused an increase of MIC value in the presence of E. coli and S. aureus strains. The study demonstrates the need for caution in the use of copper as a doping material in biocidal matrices, such as cobalt molybdate.
Subject(s)
Anti-Infective Agents/chemistry , Cobalt/chemistry , Copper/chemistry , Molybdenum/chemistry , Anti-Infective Agents/pharmacology , Bacterial Infections/drug therapy , Coordination Complexes/chemistry , Escherichia coli/drug effects , Humans , Metal Nanoparticles/chemistry , Microbial Sensitivity Tests , Particle Size , Staphylococcus aureus/drug effectsABSTRACT
Fluorescent proteins from the green fluorescent protein family strongly interact with CdSe/ZnS and ZnSe/ZnS nanocrystals at neutral pH. Green emitting CdSe/ZnS nanocrystals and red emitting fluorescent protein dTomato constitute a 72% efficiency FRET system with the largest alteration of the overall photoluminescence profile, following complex formation, observed so far. The substitution of ZnSe/ZnS for CdSe/ZnS nanocrystals as energy donors enabled the use of a green fluorescent protein, GFP5, as energy acceptor. Violet emitting ZnSe/ZnS nanocrystals and green GFP5 constitute a system with 43% FRET efficiency and an unusually strong sensitized emission. ZnSe/ZnS-GFP5 provides a cadmium-free, high-contrast FRET system that covers only the high-energy part of the visible spectrum, leaving room for simultaneous use of the yellow and red color channels. Anisotropic fluorescence measurements confirmed the depolarization of GFP5 sensitized emission.
Subject(s)
Luminescent Proteins/chemistry , Nanoparticles/chemistry , Selenium Compounds/chemistry , Zinc Compounds/chemistry , Zinc Sulfate/chemistry , Color , Fluorescence Polarization , Fluorescence Resonance Energy Transfer , Luminescent Proteins/metabolism , Selenium Compounds/metabolism , Zinc Compounds/metabolism , Zinc Sulfate/metabolismABSTRACT
4-Methoxy-N-methyl-1,8-naphthalimide (1) exhibits considerable solvatochromism and its UV-vis spectral properties have been studied in several polar/non-polar and protic/aprotic solvents, as well as in ethanol-water mixtures. The results reveal a strong influence of the solvent's polarity and its hydrogen-bond donor (HBD) capability on the photophysical properties of 1. For binary ethanol/water mixtures, preferential solvation models describe the band shifts in the probe's visible absorption spectrum well, but they fail to describe the corresponding shifts of the emission maxima. Pseudolinear approximations between solvent composition and molecule's transition energies, E(T), can be used to study the composition of ethanol-water mixtures, simplifying the mathematical treatment for eventual analytical applications.