Focused microwave assistance for extracting some pesticide residues from strawberries into water before their determination by SPME/HPLC/DAD.

A novel and simple method for the determination of some pesticide residues in strawberries using both focused microwave-assisted extraction (FMAE) and solid-phase micro extraction (SPME), coupled with high-performance liquid chromatography (HPLC), has been developed. The pesticides were first extracted from strawberries with water and the assistance of focused microwaves at 30 W for 7 min. Then, an aliquot of the resulting aqueous extract was subjected to SPME with a 60-microm thick poly(dimethylsiloxane)/divinylbenzene (PDMS/DVB) fiber for 45 min at room temperature, with the solution being stirred at 1000 rpm. The extracted pesticides on the SPME fiber were desorbed into the SPME/HPLC interface for quantitative analysis with a diode array detector (DAD). The whole sample pretreatment procedure before chromatographic analysis did not use any organic solvents or involve any blending or centrifugation steps. The five compounds (carbendazim, diethofencarb, azoxystrobine, napropamide, and bupirimate) were chosen because they cannot be analyzed easily by GC. The efficiency of this relatively fast procedure was comparable to that of previously reported methods, with detection limits at low microg/kg levels and linear responses in the range from 0.05 to 1 mg/kg of pesticide in strawberries, with RSDs between 3 and 7.3%, depending on the analyte. In all but one case results obtained by this method for field-incurred samples were comparable to those obtained with traditional methods.

Solid-phase microextraction coupled with high performance liquid chromatography: a complementary technique to solid-phase microextraction-gas chromatography for the analysis of pesticide residues in strawberries.

Solid-phase microextraction coupled with high performance liquid chromatography has been studied for the analysis of methiocarb, napropamide, fenoxycarb and bupirimate in strawberries. The strawberries were blended and centrifuged. Then, an aliquot of the resulting extracting solution was subjected to solid-phase microextraction (SPME) on a 60 microns polydimethylsiloxane/divinylbenzene (PDMS/DVB) fibre for 45 min at room temperature. The extracted pesticides on the SPME fibre were desorbed into SPME/high performance liquid chromatography (HPLC) interface for HPLC analysis with diode-array detection (DAD). The method is organic solvent-free for the whole extraction process and is simple and easy to manipulate. The detection limits were shown to be at low microgram kg-1 level and the linear response covered the range from 0.05 to 2 mg kg-1 of pesticides in strawberries with a regression coefficient larger than 0.99. A good repeatability with RSDs between 2.92 and 9.25% was obtained, depending on compounds.

Solid phase microextraction of pesticide residues from strawberries.

A new solid phase microextraction method for the determination of pesticide residues in strawberries for 16 commonly used compounds was described. The strawberries were crushed and centrifuged. An aliquot of the well agitated aqueous supernatant (4 ml) was extracted with a fibre coated with polydimethylsiloxane (PDMS, 100 microns) for 45 min at room temperature. Identification and quantification were achieved using a gas chromatography-mass spectrometry (GC-MS) system and selective ion monitoring (SIM). The method was tested for the following pesticides: carbofuran, diethofencarb, penconazole, hexaconazole, metalaxyl, folpet, bromopropylate, dichlofluanid, alpha-endosulfan, beta-endosulfan, parathion ethyl, procymidone, iprodione, vinclozolin, myclobutanil and chlorothalonil. Limits of detection, repeatability and linearity for standard calibration in strawberries were obtained. Positive and negative effects of the matrix between the extracting solution of strawberries and water were observed. Stabilities of these compounds in the extracting solution of strawberries were determined. The solvent-free SPME procedure was found to be quicker and more cost effective than the solvent extraction methods commonly used.