Facile formulation and fabrication of the cathode using a self-lithiated carbon for all-solid-state batteries.

We propose a innovative concept to boost the electrochemical performance of cathode composite electrodes using surface-modified carbons with hydrophilic moieties to increase their dispersion in a Lithium Nickel Manganese Cobalt Oxide (NMC) cathode and in-situ generate Li-rich carbon surfaces. Using a rapid aqueous process, the hydrophilic carbon is effectively dispersed in NMC particles followed by the conversion of its acid surface groups (e.g. -COOH), which interact with the NMC particles due to their basicity, into grafted Li salt (-COO-Li+). The solid-state batteries prepared using the cathode composites with surface-modified carbon exhibit better electrochemical performance. Such modified carbons led to a better electronic conduction path as well as facilitating Li+ ions transfer at the carbon/NMC interface due to the presence of lithiated carboxylate groups on their surface.

Development and application of a dry ultramicrotomy technique for the preparation of galvanneal sheet coatings.

The formability of galvanneal steel sheets used in the automotive industry is influenced by the presence and distribution of brittle and difficult to distinguish Zn-Fe intermetallics in the coating. Characterization of these intermetallics requires a high spatial resolution technique such as analytical transmission electron microscopy (ATEM). Sample preparation by ion milling is impossible due to iron redeposition, and traditional ultramicrotomy using water affects the coating chemistry. A technique based on dry ultramicrotomy has therefore been developed. To optimize the technique, different parameters (knife angle, cutting medium, thickness setting on the ultramicrotome, cutting speed) have been investigated for the preparation of galvanneal coatings and pure A1 sections. Results show that dry cutting does not affect the coating chemistry but shortens the life of the knife. Knife quality (cleanliness, sharpness and absence of defects) is a major factor to obtain good dry sections. The best results for the more ductile pure A1 are obtained with a 35 degrees knife whilst for the harder galvanneal coating it is recommended to use a 55 degrees knife. These results suggest that the sectioning mechanism for the harder material involves more a cleavage-fracture mechanism whilst a greater amount of shear is involved when sectioning relatively ductile A1. The optimum parameters for sectioning galvanneal coatings are established and results obtained by parallel electron energy loss spectrum imaging and energy dispersive X-ray spectrometry in the TEM are given. This study shows that with a good control of all the sectioning parameters it is possible to obtain good sections repeatedly and rapidly.