ABSTRACT
The objective of this study was to examine the effect of different treatments on the physicochemical, antioxidant, and antibacterial properties of honeydew honey. Honeydew honey was subjected to heat treatment and 9 different ultrasound treatments. Our results showed that the following parameters were significantly changed: water content, pH, electrical conductivity, diastase activity, HMF content and water activity. The ultrasound resulted in an increase in the total phenol content and the antioxidant capacity (DPPH, FRAP, and ABTS tests) in comparison with the conventional thermal technique. In most cases, the samples subjected to ultrasound improved the antibacterial activity; the heat treatment resulted in a significant reduction of the antibacterial activity, and sample 4 (ultrasound 30 °C, 5 min) showed the best antibacterial activity. The ultrasound treatment, especially at lower temperatures, represents a technique that enables the preservation and improvement of the biological properties of honeydew honey.
ABSTRACT
The estimation of growth or inactivation of bacterial population in fruits during preservation and storage provides useful information for the improvement of the safety of fresh-cut fruits and vegetables. This paper addressed the attachment to the surface and the growth in the flesh of apple fruits of four bacterial cultures (Escherichia coli, Bacillus cereus, Staphylococcus aureus and Pseudomonas aeruginosa). The growth of the bacterial cultures in apple flesh was monitored at particular time intervals, and Gompertz parameters, i.e. maximum number of bacteria (Pm), the maximum growth rate of bacteria rp,m, and lag time tl, were used to determine the growth kinetics. After the immersion, the highest number of P. aeruginosa and the lowest number of B. cereus adhered to the apples. After washing and swabbing, E. coli was reduced from the surface of apples to the highest extent (by 3.34 log cfu g-1), while the number of B. cereus was reduced to the lowest extent (1.66 log cfu g-1). Fitted curves of the Gompertz model corresponded quite well to the measured values of the number of microorganisms with R2 = 0.92-0.98. The values of the standard error (0.17-0.37) and extremely low p values of the Fischer test (p < 0.0001) indicated strict dependence between the model predicted and the maximum population density. The predicted values of the maximum number of microorganisms (Pm) correspond almost exactly to the actual values. A similar conclusion can be drawn for the maximum growth rate of microorganisms (rp,m), with the measured value being slightly higher than predicted values.
