Analysis of anticaries potential of pit and fissures sealants containing amorphous calcium phosphate using synchrotron microtomography.

The aim of this study was to analyze the anticaries potential of pit and fissure sealants containing amorphous calcium phosphate (ACP) by synchrotron microtomography. Bovine enamel blocks (4×4 mm; n=50) were selected through surface hardness (Knoop) analysis. Slabs were obtained through cross-sections taken 1 mm from the border of the enamel. Five indentations, spaced 100 µm apart, were made 300 µm from the border. Ten specimens were prepared for each tested material (Ultraseal XT plus TM, Aegis, Embrace, Vitremer and Experimental Sealant). The materials were randomly attached to the sectioned surfaces of the enamel blocks and fixed with sticky wax. The specimens were submitted to pH cycling. After that, the surface hardness (SH1) was determined, and the blocks were submitted to synchrotron microcomputed tomography analysis to calculate the mineral concentration (ΔgHAp cm(-3)) at different areas of the enamel. The comparison between the SH1 and ΔgHAp cm(-3) showed a correlation for all groups (r=0.840; p<0.001). The fluoride groups presented positive values of ΔgHAp cm(-3), indicating a mineral gain that was observed mainly in the outer part of the enamel. The ACP showed mineral loss in the outer enamel compared with fluoride groups, although it inhibited the demineralization in the deeper areas of enamel. The combination of two remineralizing agents (fluoride and ACP) was highly effective in preventing demineralization.

In vitro evaluation of the effect of mouth rinse with trimetaphosphate on enamel demineralization.

OBJECTIVE: The aim of this study was to investigate the effectiveness of sodium trimetaphosphate (TMP) addition to mouth rinses to inhibit enamel demineralization. DESIGN: Bovine enamel blocks (n = 88) were selected by surface hardness and divided into eight treatment groups (n = 11 per group): placebo, 100 or 225 µg F/ml; the rinses with 100 µg F/ml had differing TMP concentrations (range 0-0.6%). The blocks were subjected to pH cycling for 5 days and treated twice a day with mouth rinses. After that, surface and cross-sectional hardness as well as fluoride in enamel were measured. RESULTS: The groups containing both 100 µg F/ml and 0.4% TMP inhibited demineralization most effectively (p < 0.001). This formulation yielded lower values of lesion areas than the formulations containing 100 or 225 µg F/ml but no TMP. The addition of 0.4% TMP increased the fluoride in enamel. CONCLUSION: It is possible to improve the effectiveness of a mouth rinse with 100 µg F/ml by addition of TMP, this being superior in inhibiting enamel demineralization compared with mouth rinses containing 225 µg F/ml.

Effect of mouth rinses with fluoride and trimetaphosphate on enamel erosion: an in vitro study.

The effect of mouth rinses containing fluoride (100 µg/ml) and sodium trimetaphosphate (TMP) on enamel erosion was evaluated in vitro. Bovine enamel blocks were subjected to erosive challenges 4 times per day for 5 min, followed by treatment with placebo, 225 µg F/ml, 100 µg F/ml, 100 µg F/ml and TMP (0.2, 0.4 and 0.6%) solutions (30 s) and storage in artificial saliva, over a duration of 5 days. TMP groups showed lower enamel wear than fluoride-only and placebo groups (p < 0.05). Addition of TMP at a TMP:NaF molar proportion between 1.24:1 and 3.72:1 to a solution containing 100 µg F/ml presented a greater protective effect under erosive conditions than a solution containing 225 µg F/ml, in the absence of TMP.

Effect of rinsing with water immediately after neutral gel and foam fluoride topical application on enamel remineralization: An in situ study.

OBJECTIVE: The aim of this study was to evaluate, in situ, the effect of rinsing with water immediately after neutral fluoride foam application (Foam) or fluoride gel application (Gel). DESIGN: Ten volunteers wore acrylic palatal appliances containing 4 enamel blocks selected by surface hardness with artificial caries. Five experimental regimes of 3 days each were set according to treatment: placebo; Gel and Foam followed by no rinsing or consuming of liquids or solids for the next 30min; Gel and Foam followed by immediately washing with water jet. After each phase, surface hardness was again measured for analysis of mineral gain, evaluated through percentage of surface hardness recovery (%SHR) and integrated loss of subsurface hardness (ΔKHN). The concentration of loosely bound fluoride (CaF2) and firmly bound fluoride (FA-like) formed and retained were also determined. RESULTS: Fluoride treatments produced greater remineralization (%SHR and ΔKHN) compared to placebo group (p<0.05). There was no difference in the ability to promote remineralization and in the concentration of fluoride formed and retained, in each analysis, between Gel and Foam (p>0.05). CONCLUSION: The data suggest that rinsing with water immediately after topical application does not seem to have an influence on the ability of fluoride to promote remineralization.

Comparison of methods for evaluating mineral loss: hardness versus synchrotron microcomputed tomography.

This study analyzed degrees of demineralization in bovine enamel using synchrotron microcomputed tomography (SMCT) and hardness measurements (Knoop hardness number, KHN). For 5 days, 40 bovine enamel blocks were individually subjected to a pH cycling model and treatment with fluoride dentifrices (placebo, 275, 550 and 1,100 microg F/g) diluted in deionized water twice a day. Surface hardness number and cross-sectional profiles of hardness and mineral concentration (by SMCT) were determined. Integrated hardness (KHN x microm) for sound and demineralized specimens was calculated and subtracted to give the integrated loss of hardness (DeltaKHN) for the lesions. Increasing fluoride concentration in the dentifrices led to higher values for surface hardness after pH cycling and mineral concentration (g(HAp) cm(-3)), and lower values for DeltaKHN (p < 0.05). From the present results, it may be concluded that hardness measurements revealed demineralization in all groups, which was lower in groups treated with dentifrice with a higher F concentration. SMCT and hardness measurements gave similar results in areas with higher demineralization, but diverged in areas with lower demineralization.

Synchrotron microComputed Tomography of the mature bovine dentinoenamel junction.

The mature dentinoenamel junction (DEJ) is viewed by some investigators and the current authors, not as a fossilized, sharp transition between enamel and dentin, but as a relatively broad structural transition zone including the mantle dentin and the inner aprismatic enamel. In this study, the DEJ structure in bovine incisors was studied with synchrotron microComputed Tomography (microCT) using small cubes cut parallel to the tooth surface. The reconstructions revealed a zone of highly variable punctate contrast between bulk dentin and enamel; the mean linear attenuation coefficients and their standard deviations demonstrated that this zone averaged less mineral than dentin or enamel but had more highly variable structure than either. The region with the punctuate contrast is, therefore, the mantle dentin. The thickness of the mantle dentin seen in a typical data set was about 30 microm, and the mantle dentin-enamel interface deviated +/-15 microm from the average plane over a distance of 520 microm. In the highest resolution data ( approximately 1.5 microm isotropic voxels, volume elements), tubules in the dentin could be discerned in the vicinity of the DEJ. Contrast sensitivity was high enough to detect differences in mineral content between near-surface and near-DEJ volumes of the enamel. Reconstructions before and after two cubes were compressed to failure revealed cracks formed only in the enamel and did not propagate across the mantle dentin, regardless of whether loading was parallel to or perpendicular to the DEJ.

Conservative treatment of a radicular cyst in a 5-year-old child: a case report.

The present report describes the management of a radicular cyst in a 5-year-old child. The treatment comprised extraction of the primary teeth involved followed by marsupialization. A removable appliance with a resin extension penetrating into the cystic cavity was used to help decompress the lesion. This treatment allowed rapid healing of the lesion and eruption of the permanent incisors without the need for orthodontic treatment.