Behavior of Embedded Cation-Exchange Particles in a DC Electric Field.

Electrodialysis and electrodeionization are separation processes whose performance depends on the quality and properties of ion-exchange membranes. One of the features that largely affects these properties is heterogeneity of the membranes both on the macroscopic and microscopic level. Macroscopic heterogeneity is an intrinsic property of heterogeneous ion-exchange membranes. In these membranes, the functional ion-exchange component is dispersed in a non-conductive binder. The functional component is finely ground ion-exchange resin particles. The understanding of the effect of structure on the heterogeneous membrane properties and behavior is thus of utmost importance since it does not only affect the actual performance but also the cost and therefore competitiveness of the aforementioned separation processes. Here we study the electrokinetic behavior of cation-exchange resin particle systems with well-defined geometrical structure. This approach can be understood as a bottom up approach regarding the membrane preparation. We prepare a structured cation-exchange membrane by using its fundamental component, which is the ion exchange resin. We then perform an experimental study with four different experimental systems in which the number of used cation-exchange particles changes from 1 to 4. These systems are studied by means of basic electrochemical characterization measurements, such as measurement of current-voltage curves and direct optical observation of phenomena that occur at the interface between the ion-exchange system and the adjacent electrolyte. Our work aims at better understanding of the relation between the structure and the membrane properties and of how structure affects electrokinetic behavior of these systems.

Optimization of aqueous two-phase systems for the production of 6-aminopenicillanic acid in integrated microfluidic reactors-separators.

Aqueous two-phase systems (ATPSs) were screened for the production of 6-aminopenicillanic acid (6-APA) catalyzed by penicillin acylase, followed by the extractive separation of 6-APA from the reaction mixture. The key point of this study was to find an ATPS exhibiting a large difference in the partition coefficients of the biocatalyst and reaction products. Several ATPSs based on polyethylene glycol (PEG)/phosphate, PEG/citrate, and PEG/dextran were tested. We found that an ATPS consisting of 15 wt% of PEG 4000, 10 wt% of phosphates, 75 wt% of water (pH value 8.0 after dissolution) provided optimal separation of 6-APA from the enzyme. While the 6-APA was mainly found in the top PEG phase, the free enzyme favored the bottom salt-rich phase. This ATPS also fulfils other important requirements: (i) high buffering capacity, reducing an undesirable pH decrease due to the dissociation of phenylacetic acid (the side product of the reaction), (ii) a relatively low cost of the ATPS components, (iii) the possibility of electrophoretic transport of fine droplets as well as the reaction products for both the acceleration of phase separation and the enhancement of 6-APA concentration in the product stream. Extraction experiments in microcapillary and batch systems showed that the transport of 6-APA formed in the salt-rich phase to the corresponding PEG phase could occur within 30 s. The experimental results described form a base of knowledge for the development of continuously operating integrated microfluidic reactors-separators driven by an electric field for the efficient production of 6-APA.