ABSTRACT
Dermatomycoses are typical hair, skin, or nail infections caused mainly by dermatophytes and nondermatophytes: Trichophyton, Microsporum, Epidermophyton, and Candida. In addition to the esthetical impact, pain, and nail deformity, these mycoses can be a source of severe disease. The high cost of treatment, toxicity, and the emergence of resistant infectious agents justifies research into new drugs. This work evaluates the fungicidal activity of nanocomposites (NCs) based on reduced graphene oxide (rGO) loaded with silver (Ag) nanoparticles (rGO/Ag) against clinical isolates of dermatophytes and Candida species. This is an unprecedented study in which, for the first time, hybrid nanocompounds based on Ag/rGO were tested against Epidermophytom, Microsporum, and Trichophyton species (dermatophytes agents). In this paper, we synthesize rGO using different concentrations of Ag by hydrolysis of metal salt AgNO3 and follow the growth of nanocrystals on sheets of rGO provided by the NaBH4. The NCs were analyzed by X-ray diffraction analysis, and the NC morphology, silver distribution on the rGO surface, and crystalline information were investigated by transmission electron microscopy. Antifungal susceptibility assay was performed by the microdilution method based on modified Clinical and Laboratory Standards Institute (CLSI) protocol. Time-kill kinetics was conducted to monitor the effect of the composite to inhibit fungal cells or promote structural changes, avoiding germination. The toxicological evaluation of the NCs was born in an in vivo model based on Galleria mellonella (G. mellonella). Minimum inhibitory concentration (MIC) values of the rGO/Ag NCs ranged from 1.9 to 125 µg/mL. The best inhibitory activity was obtained for rGO/Ag12%, mainly against Candida spp. and Epidermophyton floccosum. In the presence of sorbitol, MIC values of rGO/Ag NCs were higher (ranging from 15.6 to 250 µg/mL), indicating the action mechanism on the cell wall. Both yeast and dermatophytes clinical isolates were inhibited at a minimum of 6 and 24 h, respectively, but after 2 and 12 h, they had initial antifungal interference. All hybrid formulations of rGO/Ag NCs were not toxic for G. mellonella. This study provides insights into an alternative therapeutic strategy for controlling dermatomycoses.
Subject(s)
Arthrodermataceae , Dermatomycoses , Nanocomposites , Antifungal Agents/pharmacology , Antifungal Agents/therapeutic use , Candida , Silver/pharmacology , Trichophyton , Dermatomycoses/drug therapyABSTRACT
Monitoring carbon dioxide (CO2) levels is extremely important in a wide range of applications. Although metal oxide-based chemoresistive sensors have emerged as a promising approach for CO2 detection, the development of efficient CO2 sensors at low temperature remains a challenge. Herein, we report a low-temperature hollow nanostructured CeO2-based sensor for CO2 detection. We monitor the changes in the electrical resistance after CO2 pulses in a relative humidity of 70% and show the high performance of the sensor at 100 °C. The yolk-shell nanospheres have not only 2 times higher sensitivity but also significantly increased stability and reversibility, faster response times, and greater CO2 adsorption capacity than commercial ceria nanoparticles. The improvements in the CO2 sensing performance are attributed to hollow and porous structure of the yolk-shell nanoparticles, allowing for enhanced gas diffusion and high specific surface area. We present an easy strategy to enhance the electrical and sensing properties of metal oxides at a low operating temperature that is desirable for practical applications of CO2 sensors.
ABSTRACT
Materials with high photoluminescence (PL) intensity can potentially be used in optical and electronic devices. Although the PL properties of bismuth(III) oxide with a monoclinic crystal structure (α-Bi2O3) have been explored in the past few years, methods of increasing PL emission intensity and information relating PL emission to structural defects are scarce. This research evaluated the effect of a pressure-assisted heat treatment (PAHT) on the PL properties of α-Bi2O3 with a needlelike morphology, which was synthesized via a microwave-assisted hydrothermal (MAH) method. PAHT caused an angular increase between the [BiO6]-[BiO6] clusters of α-Bi2O3, resulting in a significant increase in the PL emission intensity. The Raman and XPS spectra also showed that the α-Bi2O3 PL emissions in the low-energy region (below â¼2.1 eV) are attributed to oxygen vacancies that form defect donor states. The experimental results are in good agreement with first-principles total-energy calculations that were carried out within periodic density functional theory (DFT).
ABSTRACT
In this work, we utilise a combination of theory, computation and experiments to understand the early events related to the nucleation of Ag filaments on α-Ag2WO4 crystals, which is driven by an accelerated electron beam from an electron microscope under high vacuum. The growth process and the chemical composition and elemental distribution in these filaments were analysed in depth at the nanoscale level using TEM, HAADF, EDS and XPS; the structural and electronic aspects were systematically studied in using first-principles electronic structure theory within QTAIM framework. The Ag nucleation and formation on α-Ag2WO4 is a result of the order/disorder effects generated in the crystal by the electron-beam irradiation. Both experimental and theoretical results show that this behavior is associated with structural and electronic changes of the [AgO2] and [AgO4] clusters and, to a minor extent, to the [WO6] cluster; these clusters collectively represent the constituent building blocks of α-Ag2WO4.