ABSTRACT
[This corrects the article DOI: 10.3389/fpls.2023.1076704.].
ABSTRACT
[This corrects the article DOI: 10.3389/fpls.2021.680859.].
ABSTRACT
The wild species field cress (Lepidium campestre) has the potential to become a novel cover and oilseed crop for the Nordic climate. Its seed oil is however currently unsuitable for most food, feed, and industrial applications, due to the high contents of polyunsaturated fatty acids (PUFAs) and erucic acid (C22:1). As the biosynthesis of these undesirable fatty acids is controlled by a few well-known major dominant genes, knockout of these genes using CRISPR/Cas9 would thus be more effective in improving the seed oil quality. In order to increase the level of the desirable oleic acid (C18:1), and reduce the contents of PUFAs and C22:1, we targeted three important genes FATTY ACID ELONGASE1 (FAE1), FATTY ACID DESATURASE2 (FAD2), and REDUCED OLEATE DESATURASE1 (ROD1) using a protoplast-based CRISPR/Cas9 gene knockout system. By knocking out FAE1, we obtained a mutated line with almost no C22:1, but an increase in C18:1 to 30% compared with 13% in the wild type. Knocking out ROD1 resulted in an increase of C18:1 to 23%, and a moderate, but significant, reduction of PUFAs. Knockout of FAD2, in combination with heterozygous FAE1fae1 genotype, resulted in mutated lines with up to 66% C18:1, very low contents of PUFAs, and a significant reduction of C22:1. Our results clearly show the potential of CRISPR/Cas9 for rapid trait improvement of field cress which would speed up its domestication process. The mutated lines produced in this study can be used for further breeding to develop field cress into a viable crop.
ABSTRACT
Difficulty in protoplast regeneration is a major obstacle to apply the CRISPR/Cas9 gene editing technique effectively in research and breeding of rapeseed (Brassica napus L.). The present study describes for the first time a rapid and efficient protocol for the isolation, regeneration and transfection of protoplasts of rapeseed cv. Kumily, and its application in gene editing. Protoplasts isolated from leaves of 3-4 weeks old were cultured in MI and MII liquid media for cell wall formation and cell division, followed by subculture on shoot induction medium and shoot regeneration medium for shoot production. Different basal media, types and combinations of plant growth regulators, and protoplast culture duration on each type of media were investigated in relation to protoplast regeneration. The results showed that relatively high concentrations of NAA (0.5 mg l-1) and 2,4-D (0.5 mg l-1) in the MI medium were essential for protoplasts to form cell walls and maintain cell divisions, and thereafter auxin should be reduced for callus formation and shoot induction. For shoot regeneration, relatively high concentrations of cytokinin were required, and among all the combinations tested, 2.2 mg l-1 TDZ in combination with auxin 0.5 mg l-1 NAA gave the best result with up to 45% shoot regeneration. Our results also showed the duration of protoplast culture on different media was critical, as longer culture durations would significantly reduce the shoot regeneration frequency. In addition, we have optimized the transfection protocol for rapeseed. Using this optimized protocol, we have successfully edited the BnGTR genes controlling glucosinolate transport in rapeseed with a high mutation frequency.
ABSTRACT
The use of pathogen-resistant cultivars is expected to increase yield and decrease fungicide use in agriculture. However, in potato breeding, increased resistance obtained via resistance genes (R-genes) is hampered because R-gene(s) are often specific for a pathogen race and can be quickly overcome by the evolution of the pathogen. In parallel, susceptibility genes (S-genes) are important for pathogenesis, and loss of S-gene function confers increased resistance in several plants, such as rice, wheat, citrus and tomatoes. In this article, we present the mutation and screening of seven putative S-genes in potatoes, including two DMR6 potato homologues. Using a CRISPR/Cas9 system, which conferred co-expression of two guide RNAs, tetra-allelic deletion mutants were generated and resistance against late blight was assayed in the plants. Functional knockouts of StDND1, StCHL1, and DMG400000582 (StDMR6-1) generated potatoes with increased resistance against late blight. Plants mutated in StDND1 showed pleiotropic effects, whereas StDMR6-1 and StCHL1 mutated plants did not exhibit any growth phenotype, making them good candidates for further agricultural studies. Additionally, we showed that DMG401026923 (here denoted StDMR6-2) knockout mutants did not demonstrate any increased late blight resistance, but exhibited a growth phenotype, indicating that StDMR6-1 and StDMR6-2 have different functions. To the best of our knowledge, this is the first report on the mutation and screening of putative S-genes in potatoes, including two DMR6 potato homologues.
Subject(s)
CRISPR-Cas Systems/genetics , Disease Resistance/genetics , Mutation/genetics , Solanum tuberosum/genetics , Citrus/genetics , Gene Editing/methods , Solanum lycopersicum/genetics , Oryza/genetics , Phenotype , Plant Breeding/methods , Plant Diseases/genetics , Plant Proteins/genetics , Plants, Genetically Modified/geneticsABSTRACT
Potato (Solanum tuberosum) is among the best producers of edible biomass in terms of yield per hectare and a variety of different regional cultivars are used as a staple commodity in many countries. However, this crop is attacked by several diseases, with the worst being the late blight disease caused by Phytophthora infestans. Stacking of resistance (R) genes from wild Solanum relatives are interesting prospects for the sustainable control of late blight. Therefore, we optimized methods for the efficient generation and screening of R-gene-containing transformants in tetraploid and diploid hybrid potato genotypes. Using these methods, a high transformation efficiency was achieved for the transformation of tetraploid and diploid potato lines with a triple resistance (3R) gene construct. Transformation efficiencies were improved by optimizing several factors affecting regeneration, including the quality of the starting plant material, and the composition of the plant growth regulators used during selective regeneration. A refreshment protocol was designed to alleviate in vitro related stress in stock plants, which significantly improved the growth vigor and resulted in a 4- to 10-fold increase in transformation efficiency. Furthermore, long-term exposure to exogenous Indole-3-butyric acid that is usually used for the initiation of roots in vitro, was found to cause aberrant morphological phenotypes in potato.
