Study on the secondary oxidation behavior and microscopic characteristics of oxidized coal gangue.

Spontaneous combustion of coal gangue (CG) hills has caused varieties of secondary disasters that seriously endanger the ecological environment of the world. The emission law of index gases and their oxidation kinetics during the secondary oxidation process of CG with different ranks of oxidation were studied by using the temperature programmed device and online mass spectrometer (MS). Fourier transform infrared spectroscopy (FTIR) was used to reveal the changes of the CG internal active functional groups. The results showed that the energy required for the combustion of CG with low rank of pre-oxidation was significantly lower than that of the raw sample. However, as the oxidation rank increased, due to amounts of volatile components were released in the process of oxidation reaction, the CG in the combustion process of the emission of index gases and its oxygen consumption rate gradually reduced; the rapid oxidation stage shifted to the direction of the high temperature. In this study, the risk of spontaneous combustion of CG after oxidation at 80 â„ƒ under 3% oxygen concentration was the strongest. The results of this paper are of great guiding significance for exploring the spontaneous combustion characteristics of CG hills and their prevention by traditional covering method.

Piezoelectric Effect and Ignition Characteristics of Coal Mine Gob Roof Collapse.

Existing studies of coal self-ignition and impact frictional sparks do not provide valid support for the analysis of ignition sources in all cases of methane explosions in the gob. In this paper, the explosion in the gob of the Renlou coal mine is used to investigate the piezoelectric effect and ignition characteristics of roof collapse in identifying a new ignition source of gas explosion. Experimental and theoretical analyses conclude that the piezoelectric effect is produced by quartz, which is the main constituent of the roof sandstone. During the loading process, the piezoelectric effect and compressive strength are key factors in the gathering of free charges on rock tips. During rupture, the rock tip retains a large number of charges, forming a ″point-surface″ effect, which triggers an electron avalanche accompanied by an orange-yellow spark lasting over 22 ms, far exceeding the ionization energy and ignition induction period of methane-air mixtures. The piezoelectric effect and compressive strength of the rock cause the generation of electrical sparks, which is the ignition source of the explosion in the gob of Renlou mine II7322.

Pyrolysis Characteristics of Jet Coal and Oxidation of Residues in Zhundong Coalfield Fires.

Coalfield fire area reburning is one of the serious disasters in fire prevention and safety production. In this study, a synchronous thermal analyzer was used to conduct isothermal pyrolysis of jet coal at different temperatures, and the reaction characteristic parameters of different pyrolysis residual structures were analyzed. FTIR was used to measure group contents in raw coal and different pyrolysis residues. Programmed oxidation thermogravimetric experiments were carried out on the residues to obtain their oxidation characteristic parameters. The results demonstrated that the reaction characteristic parameters of the residual structures changed at 450 °C. The pyrolysis reaction mainly affected the variation of hydroxyl, aliphatic hydrocarbon, and aromatic hydrocarbon groups. The increase in pyrolysis temperature resulted in the decline in hydroxyl and aliphatic hydrocarbon groups as well as the increase in the aromatic hydrocarbon group. After pyrolysis, the ignition point temperature of the coal sample decreased, which causes the coal more likely to spontaneously ignite. It indicated that the pyrolysis residue at 450 °C is most likely to reburn. Compared with raw coal, the maximum combustion intensity of the pyrolysis residue was greatly increased, which reached the peak at 500 °C.

Coupling Relation between the Location of Cross-Cut Negative Pressure and Injecting Nitrogen into Coal Mine Goaf.

Injecting nitrogen into goaf has been widely adopted for preventing fire hazards in coal mines. In this paper, the coupling relation between different locations of negative pressure of cross-cut drainage and nitrogen injection was investigated. The minefield data collection was carried out by an in situ beam tube system on the intake airway and return airway of the mine goaf. The validated Computational Fluid Dynamics (CFD) model that was secondarily modified by on-site collected data was applied for further research. It is demonstrated that the area of the spontaneous combustion zone generally shows a sharp decline first, then tends to stabilize, and finally has a slight drop and rise with the increasing nitrogen injection time. It is obvious that the location of the negative pressure of cross-cut exerts a significant influence on the optimal nitrogen injection location and time. When the cross-cut is located in the center of the air leakage zone, spontaneous combustion zone, and asphyxiation zone of goaf, the optimal nitrogen injection location and time correspond to the P2 (25 m, 1200 min), P3 (30 m, 120 min), and P4 (35m, 1800 min), respectively. According to the simulation result, the specific relation between the optimal nitrogen injection point N(x) and the distance from the working distance of the cross-cut (x) by Newton interpolation polynomial analysis was figured out and verified that N(x) = 24.70808 + 0.293356x - 0.001436x 2. It is hoped that the result can provide scientific guidance for coal mine fire prevention and control with nitrogen injection.

Reaction Mechanism of Aldehyde Groups during Coal Self-Heating.

In order to further understand the mechanism of coal self-heating in the initial stage, the aldehyde group was analyzed by using the quantum chemistry methods. The charge distribution, structural parameters, and molecular orbital were analyzed to determine the active sites existing in the structure of aldehyde group. Then, a chemical reaction model including five elementary reaction sequences was established. In elementary reaction E1, the hydrogen of the aldehyde group is captured by hydroxyl to form the aldehyde radical, which provides the reactant and accumulates heat for the subsequent reaction. In elementary reaction E2, the aldehyde radical further reacts to form a carbon-free radical (R·) and CO, which is the main source for CO generation during coal spontaneous combustion. In elementary reaction E3, the aldehyde radical is oxidized to a carboxyl radical, providing the reactant for elementary reaction E4, which is directly related to CO2 generation during coal spontaneous combustion. The thermodynamic parameters of the elementary reactions were further analyzed and confirmed by quantum chemistry methods. The results are helpful for further understanding the pathways of CO generation in the initial stage of coal spontaneous combustion, which provides theoretical support for prediction of coal spontaneous combustion.