ABSTRACT
Water Hyacinth Leaf Protein Concentrate/Graphene Oxide (WHLPC/GO) hydrogel was synthesized for the removal of Cr(VI) from wastewater. About 90% of the prepared hydrogel constitutes WHLPC. The prepared material was characterized by FT-IR and XRD. The process variables such as pH, contact time, adsorbent dosage, initial Cr(VI) concentration, and temperature were optimized using a batch mode experiment. Kinetic studies were also conducted and it was observed that the chemosorptive pseudo-second-order best described the adsorption system with a correlation coefficient (R2) of 0.984. The highest adsorption capacity of 322.00 mg/g was achieved at pH 1.0, and equilibrium was achieved within 420 min. Various isotherm models were analyzed using non-linear fitting. It was found that the Sips model provides the best fit, indicating heterogeneous and uniform active site surface adsorption of Cr(VI) on the WHLPC/GO. The reuse efficiency of the synthesized material was also found to be greater than 84% for five consecutive cycles. Thermodynamic studies were conducted and results revealed that the adsorption was spontaneous and endothermic.
Subject(s)
Eichhornia , Water Pollutants, Chemical , Water Purification , Adsorption , Kinetics , Hydrogels , Spectroscopy, Fourier Transform Infrared , Water Pollutants, Chemical/analysis , Water Purification/methods , Environmental Monitoring , Chromium/analysis , Thermodynamics , Hydrogen-Ion ConcentrationABSTRACT
Different aminonaphetalenesulphonic acid derivatives like 5-aminonaphthalene-1-sulphonic acid (5AN1SA), 2-aminonaphthalene-1-sulphonic acid (2AN1SA), 8-aminonaphthalene-2-sulphonic acid (8AN2SA) and 4-amino-3-hydroxynaphthalene-1-sulphonic acid (4A3HN1SA) were used to construct polymer/bismuth film modified electrode for simultaneous determination of Pb(II) and Cd(II) ions with the aim of developing a cheaper and sensitive electrode that could possibly replace Nafion. Among the different modified electrodes, poly (8AN2SA)/bismuth film modified electrodes showed the highest electrochemical response for both ions. These electrochemical results were also supported by density functional theory (DFT) calculations. Based on these experimental and theoretical results, poly (8AN2SA)/bismuth film glassy carbon modified electrode was further investigated to develop a simple and sensitive electrochemical method for the simultaneous determination of Pb(II) and Cd(II) ions. After optimizing the different experimental parameters, the proposed method gave a linear range of 1-40 µg/L with the detection limit of 0.38 and 0.08 µg/L for the simultaneous determination of Pb(II) and Cd(II) ions, respectively.
