CFD-PBM Simulation of Sauter Mean Diameter in a Stirred Sieve-Plate Extraction Column.

A computational fluid dynamics-population balance model (CFD-PBM)-coupled simulation method was established to simulate the Sauter mean diameter (d32) in a stirred sieve-plate extraction column with Ansys Fluent 19.2. The droplet breakage and coalescence were considered, and the kernel functions were loaded into Fluent as a user-defined function (UDF). The simulated d32 by different kernels was compared with the experimental values, and the results showed that the modified model considering the dispersed phase viscosity has better simulation accuracy and good applicability. In addition, the effects of different operating conditions on d32 were investigated. When the stirring speed is increased, d32 decreases. As the dispersed phase flow rate increases, d32 increases, while the change in the continuous phase flow rate does not have a significant impact on d32.

Reactivity of Formaldehyde during 4-Hydroxy-2-butanone Synthesis in Supercritical State.

4-Hydroxy-2-butanone, an important intermediate for vitamin A and fragrances, is usually produced by aldol condensation of acetone and formaldehyde. Noncatalytic synthesis of 4-hydroxy-2-butanone in supercritical state, which was fast and had high production yield, was widely applied. Previous research on 4-hydroxy-2-butanone synthesis in the supercritical state focused on the formation and dehydration of 4-hydroxy-2-butanone while ignoring side reactions involving formaldehyde, which were studied in this paper. A reaction pathway of 4-hydroxy-2-butanone supercritical synthesis containing formaldehyde side reactions was proposed. The cross-disproportionation of formaldehyde and formic acid was found to be the main consumption of formic acid. The effects of initial formaldehyde and formic acid mass fractions in the feed on side reactions were studied. Based on the experiments conducted from 523.15 K to 563.15 K and 17 MPa, a kinetic model was suggested. The relative deviations between experimental and simulated data were less than 10%.

Virtual screening of mandelate racemase mutants with enhanced activity based on binding energy in the transition state.

Mandelate racemase (MR) is a promising candidate for the dynamic kinetic resolution of racemates. However, the poor activity of MR towards most of its non-natural substrates limits its widespread application. In this work, a virtual screening method based on the binding energy in the transition state was established to assist in the screening of MR mutants with enhanced catalytic efficiency. Using R-3-chloromandelic acid as a model substrate, a total of 53 mutants were constructed based on rational design in the two rounds of screening. The number of mutants for experimental validation was brought down to 17 by the virtual screening method, among which 14 variants turned out to possess improved catalytic efficiency. The variant V26I/Y54V showed 5.2-fold higher catalytic efficiency (k(cat)/K(m)) towards R-3-chloromandelic acid than that observed for the wild-type enzyme. Using this strategy, mutants were successfully obtained for two other substrates, R-mandelamide and R-2-naphthylglycolate (V26I and V29L, respectively), both with a 2-fold improvement in catalytic efficiency. These results demonstrated that this method could effectively predict the trend of mutational effects on catalysis. Analysis from the energetic and structural assays indicated that the enhanced interactions between the active sites and the substrate in the transition state led to improved catalytic efficiency. It was concluded that this virtual screening method based on the binding energy in the transition state was beneficial in enzyme rational redesign and helped to better understand the catalytic properties of the enzyme.

Study on the prediction of visible absorption maxima of azobenzene compounds.

The geometries of azobenzene compounds are optimized with B3LYP/6-311G* method, and analyzed with nature bond orbital, then their visible absorption maxima are calculated with TD-DFT method and ZINDO/S method respectively. The results agree well with the observed values. It was found that for the calculation of visible absorption using ZINDO/S method could rapidly yield better results by adjusting OWF(pi-pi) (the relationship between pi-pi overlap weighting factor) value than by the TD-DFT method. The method of regression showing the linear relationship between OWF(pi-pi) and BL(N-N) (nitrogen-nitrogen bond lengths) as OWF(pi-pi)=-8.1537+6.5638BL(N-N), can be explained in terms of quantum theory, and also be used for prediction of visible absorption maxima of other azobenzne dyes in the same series. This study on molecules' orbital geometry indicates that their visible absorption maxima correspond to the electron transition from HOMO (the highest occupied molecular orbital) to LUMO (the lowest unoccupied molecular orbital).