Synergistic control potential of flue gas pollutants under Ultra-Low emission standards in waste incineration plants.

As the dominant waste disposal process, incineration is regarded as the main incentive for the "not-in-my-backyard" syndrome, and faces an inescapable pressures of ultra-low emissions (ULE). Establishing precise response relationships between emission factors (EFs) and full-process influencing factors can provide guidance for the synergistic mitigation of flue gas pollutants (FGPs). In this work, the multi-dimensional EFs of FGPs were identified by initially integrating FGPs concentration monitoring data of existing 1,226 processing lines in China, technologies applied and operational experience (OE), local economic and political characteristics. Significant regional imbalance performance was observed, which EFs in the coastal regions were 3.55-92.39 % lower than those of the inland areas. NOx, SO2, HCl were identified as critical components requiring further reduction under the ULE standards, with exceedance rates recorded at 73.07 %, 38.90 %, and 56.69 %, respectively. An indicative value of 20 mg/m3 for PM is recommended for the control of heavy metals of Cd + Tl and Sb + As + Pb + Cr + Co + Cu + Mn + Ni based on the correlation coefficients of r = 0.28 (p < 0.001) and r = 0.20 (p = 0.002), respectively. Waste composition and OE were quantified as the main contributors of EFs' disparities by the tree-branching controlled variable approach established in this study. Predictive models for FGPs control process and corresponding EFs were constructed. EFs of nine FGPs in 2030 would decrease by 0.97-65.42 %, due to more complex purification processes employed to meet ULE's limitations, such as the application of five-stage processes growing from 45.60 % to 58.28 %. While regional imbalance in EFs-SO2 and EFs-HCl were extended with increases from 25.83 % to 33.07 % and 9.91 % to 32.32 %, respectively, due to the consistent disparities of OE and growing heterogeneity of control policies. Enhancing interregional empirical exchanges, reducing the regional market monopolies, and formulating technical guidelines would be beneficial to synergize the reduction of FGPs emissions and alleviate regional imbalance.

Origin of colossal dielectric response in (In + Nb) co-doped TiO2 rutile ceramics: a potential electrothermal material.

(In + Nb) co-doped TiO2 (TINO) rutile is an emerging material with a colossal dielectric permittivity (CP) and a low dielectric loss over wide temperature and frequency ranges. The electrical inhomogeneous nature of TINO ceramics is demonstrated by direct local current probing with high-resolution conductive atomic force microscopy (cAFM). The CP response in TINO is found to originate from the electron-pinned defect dipole induced conductive cluster effect and the electrode effect. Two types of dielectric relaxations are simultaneously observed due to these two effects. With the given synthesis condition, we found TINO shows a highly leaky feature that impairs its application as a dielectric material. However, the fast-temperature-rising phenomenon found in this work may open a new door for TINO to be applied as a potential electrothermal material with high efficiency, oxidation-proof, high temperature stability, and energy saving.

Transparent Indium Tin Oxide Electrodes on Muscovite Mica for High-Temperature-Processed Flexible Optoelectronic Devices.

Sn-doped In2O3 (ITO) electrodes were deposited on transparent and flexible muscovite mica. The use of mica substrate makes a high-temperature annealing process (up to 500 °C) possible. ITO/mica retains its low electric resistivity even after continuous bending of 1000 times on account of the unique layered structure of mica. When used as a transparent flexible heater, ITO/mica shows an extremely fast ramping (<15 s) up to a high temperature of over 438 °C. When used as a transparent electrode, ITO/mica permits a high-temperature annealing (450 °C) approach to fabricate flexible perovskite solar cells (PSCs) with high efficiency.

Distribution pattern and the risks of OPCs, PHAs and PCBs in aged refuses from landfill.

Persistent organic pollutants (POPs) are the urgent risk for landfill, and should be considered before the landfill reclamation and resource. In this work, the distribution pattern of selected POPs in landfill and their ecological risks were investigated and assessed. The Σ20OCPs, Σ16PAHs and Σ19PCBs were around 157.4-329.2, 4103-19,190, and 79.1-340.3µgkg(-1) in aged refuses, with the mean value of 206.6, 8645.4, and 155.1µgkg(-1). While those in soil covers were only 6.3-75.4, 125.5-515.3 and 2.6-43.4µgkg(-1), with the mean value of 33.7, 257.7, and 24.0µgkg(-1), respectively. The maximum OPCs, PHAs and PCBs were in aged refuse with 13, 7, 10 disposal years. Whereas, the corresponding top content in soil covers were in 10, 13 and 16years, meaning that aged refuses were not the direct source for soil covers. Among 20 OCPs measured, α-HCH, δ-HCH, Dieldrin, and Endrin were presented in all aged refuses, with the mean concentration of 93.6, 52.1, 3.9 and 4.7µgkg(-1), respectively. For PAHs, PHE, FLU and PYR were the main composition, and reached to 1535, 1224, 1187µgkg(-1). The Σ7CarPAHs occupied around 33.3-49.9% of total Σ16PAHs tested, and could be used as the indictor for PAHs pollutant in landfill. PCB-5 content was around 40.7-263.3µgkg(-1) in aged refuses, and occupied around 51.5-81.8% of Σ19PCBs measured. The HCHs and DDTs in aged refuses were below the national standard GB15618-1995, and the corresponding Σ19PCBs concentrations met the standard of GB 13015-91, suggesting that aged refuse are accepted for the further utilization process.

[Odor emission rate of municipal solid waste from landfill working area].

Emission rates of volatile organic compounds (VOCs), H2S and odor unit from the surface of a municipal solid waste (MSW) landfill working area were measured with a wind tunnel sampler. The results show that the emission rate of odor from the non-point source of landfill is the function of environmental temperature and surface sweeping velocity. The emission rate measured in the high temperature season can be 6 times higher of that in the low temperature season. Within the experimental range of 0.6-4 m x s(-1) wind sweeping velocity, the emission rate shows a linear relationship with wind sweeping velocity. In summer, the emission rates of VOCs (measured by PID as isobutylene), H2S and odor unit are 385-680 microg x (m(2) x s)(-1), 4-7 microg x (m(2) x s)(-1), and 46.5-136 OU x (m(2) x s)(-1) respectively. The continuous sweeping experiment shows that the emission rate measured with clean air sweeping is the maximum possible emission rate, which needs to be adjusted when it is used to estimate the odor concentration of more than 10 min sample time or an area emission load.

Performance enhancement of ZnO UV photodetectors by surface plasmons.

Surface plasmons, a unique property of metal nanoparticles, have been widely applied to enhance the performance of optical and electrical devices. In this study, a high quality zinc oxide (ZnO) thin film was grown on a quartz substrate by a radio frequency magnetron sputtering technique, and a metal-semiconductor-metal structured ultraviolet detector was prepared on the ZnO film. The responsivity of the photodetector was enhanced from 0.836 to 1.306 A/W by sputtering metal (Pt) nanoparticles on the surface of the device. In addition, the absorption of the ZnO thin film was enhanced partly in the ultraviolet band. It is revealed that Pt nanoparticles play a key role in enhancing the performance of the photodetectors, where surface plasma resonance occurs.