Anomalous size dependence of the coercivity of nanopatterned CrGeTe3.

The coercivity of single-domain magnetic nanoparticles typically decreases with the nanoparticle size and reaches zero when thermal fluctuations overcome the magnetic anisotropy. Here, we used SQUID-on-tip microscopy to investigate the coercivity of square-shaped CrGeTe3 nanoislands with a wide range of sizes and width-to-thickness aspect ratios. The results reveal an anomalous size-dependent coercivity, with smaller islands exhibiting higher coercivity. The nonconventional scaling of the coercivity in CrGeTe3 nanoislands was found to be inversely proportional to the island width and thickness (1/wd). This scaling implies that the nanoisland magnetic anisotropy is proportional to the perimeter rather than the volume, suggesting a magnetic edge state. In addition, we observe that 1600 nm wide islands display multi-domain structures with zero net remnant field, corresponding to the magnetic properties of pristine CrGeTe3 flakes. Our findings highlight the significant influence of edge states on the magnetic properties of CrGeTe3 and deepen our understanding of low-dimensional magnetic systems.

Magnetic Imaging and Domain Nucleation in CrSBr Down to the 2D Limit.

Recent advancements in 2D materials have revealed the potential of van der Waals magnets, and specifically of their magnetic anisotropy that allows applications down to the 2D limit. Among these materials, CrSBr has emerged as a promising candidate, because its intriguing magnetic and electronic properties have appeal for both fundamental and applied research in spintronics or magnonics. In this work, nano-SQUID-on-tip (SOT) microscopy is used to obtain direct magnetic imaging of CrSBr flakes with thicknesses ranging from monolayer (N = 1) to few-layer (N = 5). The ferromagnetic order is preserved down to the monolayer, while the antiferromagnetic coupling of the layers starts from the bilayer case. For odd layers, at zero applied magnetic field, the stray field resulting from the uncompensated layer is directly imaged. The progressive spin reorientation along the out-of-plane direction (hard axis) is also measured with a finite applied magnetic field, allowing evaluation of the anisotropy constant, which remains stable down to the monolayer and is close to the bulk value. Finally, by selecting the applied magnetic field protocol, the formation of Néel magnetic domain walls is observed down to the single-layer limit.

Nano-Patterned Magnetic Edges in CrGeTe3 for Quasi 1-D Spintronic Devices.

The synthesis of two-dimensional van der Waals magnets has paved the way for both technological applications and fundamental research on magnetism confined to ultra-small length scales. Edge magnetic moments in ferromagnets are expected to be less magnetized than in the sample interior because of the reduced amount of neighboring ferromagnetic spins at the sample edge. We recently demonstrated that CrGeTe3 (CGT) flakes thinner than 10 nm are hard ferromagnets; i.e., they exhibit an open hysteresis loop. In contrast, thicker flakes exhibit zero net remnant field in the interior, with hard ferromagnetism present only at the cleaved edges. This experimental observation suggests that a nontrivial interaction exists between the sample edge and the interior. Here, we demonstrate that artificial edges fabricated by focus ion beam etching also display hard ferromagnetism. This enables us to write magnetic nanowires in CGT directly and use this method to characterize the magnetic interaction between the interior and edge. The results indicate that the interior saturation and depolarization fields depend on the lateral dimensions of the sample. Most notably, the interior region between the edges of a sample narrower than 300 nm becomes a hard ferromagnet, suggesting an enhancement of the magnetic exchange induced by the proximity of the edges. Last, we find that the CGT regions amorphized by the gallium beam are nonmagnetic, which introduces a novel method to tune the local magnetic properties of CGT films, potentially enabling integration into spintronic devices.