Evaluation of the clinical efficacy of quantitative light-induced fluorescence technology in diagnosing cracked teeth.

BACKGROUND: This retrospective study evaluated the clinical efficacy of quantitative light-induced fluorescence (QLF) technology for crack detection and the diagnosis of cracked teeth and assessed the possibility of a quantitative evaluation of cracks using QLF technology. METHODS: Patients who were clinically diagnosed with cracked teeth over a 1-year period were included. The QLF images of the corresponding symptomatic cracked teeth and asymptomatic contralateral teeth with crack lines were taken with Qraypen C (AIOBIO, Seoul, Korea). Fluorescence loss (ΔF), maximum fluorescence loss (ΔFmax), red fluorescence (ΔR), and maximum red fluorescence (ΔRmax) of the crack line were analyzed. The correlation between these parameters and sex, age, tooth position (1st premolar, 2nd premolar, 1st molar, 2nd molar), spontaneous pain (+/-), percussion test (+/-), cold test (++/+/-), and bite test (+/-) were statistically analyzed. RESULTS: A total of 66 patients were included. Twenty-four patients had asymptomatic contralateral teeth with apparent crack lines; thus, 90 teeth were analyzed. The crack lines in 84 teeth observed as red fluorescent lines on the QLF images showed ΔR values higher than the cut-off value set by the analysis program used. The patient's age and the ∣ΔF∣ and ΔR values were positively correlated. However, there was no statistically significant difference in the QLF parameters between the same patient's symptomatic tooth and the contralateral tooth. CONCLUSIONS: QLF technology is a useful assistive diagnostic device for diagnosing cracked teeth.

Effectiveness of fluoride-containing toothpastes associated with different technologies to remineralize enamel after pH cycling: an in vitro study.

BACKGROUND: To evaluate the efficacy of fluoride-containing toothpastes with different technologies to remineralize artificial caries lesions in enamel. METHODS: Bovine enamel blocks were divided into three thirds: intact (untreated), demineralized (artificial caries lesion), and treated (caries lesion, pH cycling with dentifrices). Enamel blocks were randomly distributed into five groups (n = 12): Fluoride-free toothpaste, Colgate Oral Care (NC); Arginine-containing toothpaste, Colgate Total Daily Repair (PC); Silicate-based fluoride toothpaste: REFIX technology, regenerador + sensitive (RDC), NR-5 technology, Regenerate Enamel Science (RES), and NOVAMIN technology, Sensodyne Repair and Protect (SRP). The specimens were submitted to a pH cycling model for 6 days. The efficacy of the toothpastes was estimated by calculating the surface microhardness recovery (%SMHR) and the fluorescence recovery (ΔFRE) with quantitative light-induced fluorescence. The cross-sectional micromorphology of the enamel surface was also assessed using scanning electron microscopy. Elemental analyses (weight%) were determined with an energy-dispersive X-ray spectrometer (EDS). The results were compared to that of the control (NC). Data were statistically analyzed (5%). RESULTS: %SMHR could be ranked as follows: RDC = PC = RES = SRP > NC. Significantly higher %SMHR and ΔFRE means were observed after enamel treatment with RDC (22.7 and 46.9, respectively). PC (%SMHR = 18.8) was as efficacious as RDC to recover the surface microhardness with a significantly lower mean of ΔFRE (19.5). Only RDC was able to promote the formation of a mineralized layer on the surface of enamel enriched with silicon on the surface. CONCLUSIONS: The silicate-based fluoride toothpaste containing REFIX technology demonstrated greater efficacy in the remineralizing artificial caries than the other products.

Improving the competency of dental hygiene students in detecting dental restorations using quantitative light-induced fluorescence technology.

OBJECTIVES: The purpose of this study was to determine the usefulness of a quantitative light-induced fluorescence (QLF) technology in detecting dental restorations by comparing the detection ability of dental hygiene students between using conventional visual inspection alone and visual inspection combined with QLF technology. METHODS: The subjects of this study comprised 92 dental hygiene students. The students assigned to the control group only used white-light images to visually assess the mouth environment, while those in the experimental group additionally used fluorescence images. Using the test results of an experienced inspector as a reference value, the agreement between the reference value and the evaluation results of the students in the experimental and control groups was evaluated using Cohen's kappa and the percentage agreement. The subjects were then classified into groups covering three percentage ranges according to the score distribution and agreement values of the three groups were compared. The percentage agreement was calculated according to the type of dental restorations. RESULTS: The mean kappa value was significantly higher in the experimental group than the control group (0.70 vs 0.60, p<0.001), as was the percentage agreement (80.06% vs 72.64%, p<0.001). The agreement rate when using QLF technology increased by 8% more in the middle and bottom percentage groups than in the top percentage group (p<0.001). The agreement rate also varied with the type of restoration, being significantly higher for a sound tooth or tooth-colored restoration in the experimental group (p<0.001). CONCLUSIONS: Combining QLF technology with conventional visual inspections could improve the ability to detect dental restorations and distinguish sound teeth from aesthetic restorations.

Lethal photosensitization of Porphyromonas gingivalis by their endogenous porphyrins under anaerobic conditions: an in vitro study.

BACKGROUND: Lethal photosensitization has been previously demonstrated in Porphyromonas gingivalis, but oxygen is considered to be essential to this process. However, since P. gingivalis is a periodontal pathogen which grows in the low oxygen conditions found in the subgingival crevice, it was considered prudent to study its photosensitivity in anaerobic conditions. METHODS: A series of experiments were undertaken to attempt to induce lethal photosensitization in P. gingivalis (ATCC 33277) under strict anaerobic conditions using two different 405 nm light sources. Samples of P. gingivalis were grown on a blood-containing, solid growth medium before being suspended in saline and then exposed to 405 nm light delivered by either a hand-held light source (Toothcare™) (11.4 mW/cm(2)) or a laser pointer (328.5 mW/cm(2)). With the exception of the adjustment of the P. gingivalis suspensions to a fixed optical density, the experiments were carried out in their entirety within an anaerobic chamber. RESULTS: The lowest Toothcare light dose tested (0.34 J/cm(2); 30s) yielded a statically significant kill of 63.4% which increased to 94.1% kill at higher light doses (3.42 J/cm(2); 300 s). The laser pointer similarly achieved kills of 90.2% at the lower light dose tested (9.86 J/cm(2); 30s) and 94.5% kill at the highest light dose (98.55 J/cm(2); 300 s). CONCLUSIONS: Lethal photosensitization can be instigated in planktonic suspensions of P. gingivalis at 405 nm delivered by hand-held devices under anaerobic conditions. This suggests the possibility that lethal photosensitization occurred by the oxygen-independent type I pathway as oppose to the oxygen-dependent type II pathway.