ABSTRACT
Microplastic (MP) environmental contamination has been widely studied in Mexico; however, the evaluation of the associated risk to MP in environmental compartments is scarce. Therefore, this study addresses this issue using diverse indicators such as the Pollution Load Index (PLI), the Polymer Risk Index (PRI), and the Potential Ecological Risk Index (PERI). The results of a meta-analysis revealed high MP contamination levels in most of the studied compartments, which included marine and estuarine waters, beach sand, freshwater, sediments, and biota. Regarding the risk assessment indicators, PLIs indicated low (56%), dangerous (22%), moderate (12%), and high (10%) levels across compartments. Meanwhile, PRIs displayed concerning values, with 36%, 35%, 20%, and 9% exhibiting dangerous, high, moderate, and low levels, respectively. Thus, high PRI values emphasized the significant rise in MP pollution, largely attributed to high-hazard polymer compositions. Otherwise, PERIs showed low (56%), very dangerous (29%), moderate (6%), high (5%), and dangerous (4%) levels. Thus, the ecological risk in Mexico is widespread and mainly linked to MP abundance, polymer type, environmental matrix, and organisms' characteristics. This study represents the first attempt at MP ecological risk assessment in Mexico, providing crucial insights for developing mitigation strategies to address concerns about MP contamination.
ABSTRACT
The present study focused on to determine the concentration and health risk of heavy metals (Cu, Pb, Zn, Cd, Hg, Cr) in e-waste contaminated soils collected from different provinces of Pakistan. Further, the impact of heavy metals on soil enzyme activities and microbial community was also investigated. The concentration (mg/kg) of Hg, Zn, Fe, Cu, Pb, Cd, and Cr ranged between 0-0.258, 2.284-6.587, 3.005-40.72, 8.67-36.88, 12.05-35.03, 1.03-2.43, and 33.13-60.05, respectively. The results revealed that Lahore site of Punjab province indicated more concentration of heavy metals as compared to other sites. The level of Cr at all sites whereas Hg at only two sites exceeds the World Health Organization standards (WHO) for soil. Soil enzyme activity exhibited dynamic trend among the sites. Maximum enzyme activity was observed for urease followed by phosphatase and catalase. Contamination factor (Cf), Pollution load index (PLI), and geo-accumulation index (Igeo) results showed that all the sites are highly contaminated with Cu, Cd, and Pb. Hazard index (HI) was less than 1 for children and adults suggesting non-carcinogenic health risk. Principle component analysis results depicted relation among Cr, Fr, catalase, and actinomycetes; Cd, OM, urease, and bacteria, and Pb, Cu, Zn, Hg, and phosphatase, suggesting soil enzymes and microbial community profiles were influenced by e-waste pollution. Therefore, there is a dire need to introduce sustainable e-waste recycling techniques as well as to make stringent e-waste management policies to reduce further environmental contamination.
Subject(s)
Electronic Waste , Metals, Heavy , Soil Microbiology , Soil Pollutants , Metals, Heavy/analysis , Pakistan , Soil Pollutants/analysis , Risk Assessment , Humans , Environmental Monitoring/methods , Waste Disposal Facilities , Soil/chemistryABSTRACT
A total of 21 surface sediment samples collected from Arasalar River are subjected to sediment texture (sand-silt-clay ratio), trace elements, organic matter, and CaCO3 studies to understand the accumulation dynamics of sediments. To assess the impact of metal pollution in estuarine sediments, the essential parameters should be done by checking the sediment characteristics, spatial distribution of heavy metal sources, sediment dynamics, and geochemical analysis. To evaluate the contamination level of metal pollution, a basic standard reference is required to decipher the values ranging from natural to anthropogenic contribution. From this research analysis, it is observed that the study area predominantly comprises silty sand and sand silty nature. The calcium carbonate content in the sediment is found to be proportional to the presence of shell fragments, whereas the organic matter (OM) is derived from riverine and coastal input which acts as a primary source. The obtained results confessed the average contents (mg/g) for the following selected eight elements in the order of Fe (35249-49068) > Mn (286-519) > Ni (107-279) > Cu (78.30-155.70) > Cr (50-99) > Zn (38.70-91.90) > Pb (39.90-62.40), and Co (12.6-29.1) by using an atomic absorption spectrophotometer (AAS) are utilized for this analysis. Multivariate analysis of heavy metals affirms geogenic sources (weathering of parent rocks) for Fe, Mn, Cr, Co, and Zn, whereas Cu, Ni, and Pb originated from anthropogenic activities (urban and industrial activities). The pollution load index, sediment pollution index, Igeo index, and PERI are categorized as under polluted, low to moderate polluted, and low potential environmental risk variety. Constant inspection and guidance are needed to prevent effluences from various agriculture and industrial activities in the nearby regions. The findings from this research may support and help the government to follow the suitable remediation on the better management of river and coastal areas.
ABSTRACT
The need to generate internal revenue by most individuals and government in Nigeria has led to the establishment of quarries in different parts of Ebonyi state of Nigeria. This study was aimed at determining the risk associated with the heavy metal burden in the state. Soil samples from the quarrying environments designated as MS1, MS2, and MS3 were analyzed for the metal profile using inductively coupled plasma optical emission spectrometry (ICP-OES). The result showed that the mean concentration of metals which is a representation of the whole sites showed a higher concentration of Ca (40.065 ± 1.011 ppm), Mg (12.450 ± 8.815 ppm), K (16.631 ± 14.670 ppm), and Mn (19.539 ± 3.225 ppm) while Na (1.326 ± 0.117 ppm) was low. The heavy metal profile showed Pb (0.120 ± 0.027 ppm), Fe (27.718 ± 1.523 ppm), Zn (2.227 ± 0.570 ppm), Cu (6.267 ± 1.402 ppm), Ni (1.856 ± 0.472 ppm), Mo (1.758 ± 0.258 ppm), Cd (0.023 ± 0.006 ppm), Cr (0.037 ± 0.011 ppm), etc. Hg was found to be below detectable limit while the Cs was not radioactive. The mean values were found to be lower than the permissible limit of each metal. The pollution index (PI) was calculated for the different sites, and the result reveals that MS3 (0.0426) had a higher PI when compared to MS1 (0.0341) and MS2 (0.0317). Therefore, the PI of the sites showed MS3 > MS1 > MS2. These results showed that the environment is still as safe as PI < 1. The geoaccumulation index also showed a safe environment since its values were less than 0 which means that the environment is practically uncontaminated. Other risk determining parameters showed that the three locations were still within a safe level. Although the results of the study have shown a safe environment, it is still necessary to keep close monitoring of the heavy metal profile of the environment, since these metals can bioaccumulate in living tissues with time.
Subject(s)
Metals, Heavy , Soil Pollutants , Environmental Monitoring , Humans , Metals, Heavy/analysis , Nigeria , Risk Assessment , Soil , Soil Pollutants/analysisABSTRACT
The purpose of the present work was to combine several tools for assessing metal pollution in marine sediments from Cienfuegos Bay. Fourteen surface sediments collected in 2013 were evaluated. Concentrations of As, Cu, Ni, Zn and V decreased respect to those previous reported. The metal contamination was spatially distributed in the north and south parts of the bay. According to the contamination factor (CF) enrichment factor (EF) and index of geoaccumulation (Igeo), Cd and Cu were classified in that order as the most contaminated elements in most sediment. Comparison of the total metal concentrations with the threshold (TELs) and probable (PELs) effect levels in sediment quality guidelines suggested a more worrisome situation for Cu, of which concentrations were occasional associated with adverse biological effects in thirteen sediments, followed by Ni in nine sediments; while adverse effects were rarely associated with Cd. Probably, Cu could be considered as the most dangerous in the whole bay because it was classified in the high contamination levels by all indexes and, simultaneously, associated to occasional adverse effects in most samples. Despite the bioavailability was partially evaluated with the HCl method, the low extraction of Ni (<3% in all samples) and Cu (<55%, except sample 3) and the relative high extraction of Cd (50% or more, except sample 14) could be considered as an attenuating (Ni and Cu) or increasing (Cd) factor in the risk assessment of those element.