Double-Layer Electronegative Structure-Based Triboelectric Nanogenerator for Enhanced Performance Using Combined Effect of Enhanced Charge Generation and Improved Charge Trapping.

The performance of a triboelectric nanogenerator (TENG) device depends on the amount of generated surface charges during triboelectrification and the retention of surface charges. Here, we present the fabrication of a double-layer nanocomposite structure for the electronegative layer in a TENG, which resulted in the enhanced generation of surface charges and retention of generated charges. The double-layer structure is a stack of two different nanocomposite layers, in which the top layer is a nanocomposite of PVDF and MXene and the bottom layer is a nanocomposite layer of PDMS and NaNbO3 nanoparticles. The use of the double-layer structure for the electronegative layer enhanced the generated voltage to 150 V and the current to 4.3 µA, resulting in an output power density of 134 µW/cm2, which is ∼5.8 times higher compared to the performance of a TENG with a single PVDF electronegative layer. Through systematic Kelvin probe force microscopy measurements, it is shown that the introduction of a highly electronegative MXene in the PVDF matrix improved the electron affinity of the friction layer, resulting in enhanced charge generation during contact electrification. The introduction of NaNbO3 ferroelectric nanoparticles in the PDMS matrix is shown to result in enhanced internal polarization and increased trap sites, resulting in the retention of generated surface charges for longer durations. The combined effect of the two layers resulted in a substantial improvement in TENG performance. The application of the TENG device in wireless communication for signal transfer is also presented.

Synergy of Oxygen Octahedra Distortion and Polar Nanodomains Induced Emergent Electrocaloric Effect in NaNbO3-Based Ceramics.

High-performance electrocaloric materials are essential for the development of solid-state cooling technologies; however, the contradiction of the electrocaloric effect (ECE) and temperature span in ferroelectrics frustrates practical applications. In this work, through modulating oxygen octahedra distortion and short-range polar nanodomains with moderate coupling strength, an EC value of ΔT ∼ 0.30 K with an ultrawide temperature span of 85 K is obtained in the x = 0.04 composition [(0.88 - x)NaNbO3-0.12BaTiO3-xLiSbO3 (x = 0-0.06)]. The LiSbO3 dopant induces a P4bm-to-R3cH phase transition and intensifies the oxygen octahedra distortion degree, accompanied by the ferroelectric domain smashing into polar nanodomains. Also, LiSbO3 addition enhances the relaxation degree with a downshift of Tfd (ferroelectric-to-diffuse phase transition temperature) and TJ (temperature of the maximal current density value), and Tfd is shifted to near room temperature with an absence of TJ in x = 0.04. Local energy barriers induced by oxygen octahedra distortion inhibit the phase transition in conjunction with activation of short-range polar order switching under thermal stimuli, which is the underlying mechanism for an excellent EC performance for x = 0.04. This work not only clarifies that ferroelectrics with oxygen octahedra distortion and short-range polar order are expected to achieve remarkable EC performances but also provides a design strategy to seek emergent EC behaviors in complex oxygen-octahedra-distortion materials.

Physical Properties of CaTiO3-Modified NaNbO3 Thin Films.

NaNbO3(NN)-based lead-free materials are attracting widespread attention due to their environment-friendly and complex phase transitions, which can satisfy the miniaturization and integration for future electronic components. However, NN materials usually have large remanent polarization and obvious hysteresis, which are not conducive to energy storage. In this work, we investigated the effect of introducing CaTiO3((1-x)NaNbO3-xCaTiO3) on the physical properties of NN. The results indicated that as x increased, the surface topography, oxygen vacancy and dielectric loss of the thin films were significantly improved when optimal value was achieved at x = 0.1. Moreover, the 0.9NN-0.1CT thin film shows reversible polarization domain structures and well-established piezoresponse hysteresis loops. These results indicate that our thin films have potential application in future advanced pulsed power electronics.

Local Isomeric Polar Nanoclusters Enabled Superior Capacitive Energy Storage Under Moderate Fields in NaNbO3-Based Lead-Free Ceramics.

The high-field energy-storage performance of dielectric capacitors has been significantly improved in recent years, yet the high voltage risks of device failure and large cost of insulation technology increase the demand for high-performance dielectric capacitors at finite electric fields. Herein, a unique superparaelectric state filled with polar nanoclusters with various local symmetries for lead-free relaxor ferroelectric capacitors is subtly designed through a simple chemical modification method, successfully realizing a collaborative improvement of polarization hysteresis, maximum polarization, and polarization saturation at moderate electric fields of 20-30 kV mm-1. Therefore, a giant recoverable energy density of ≈5.0 J cm-3 and a high efficiency of ≈82.1% are simultaneously achieved at 30 kV mm-1 in (0.9-x)NaNbO3-0.1BaTiO3-xBiFeO3 lead-free ceramics, showing a breakthrough progress in moderate-field comprehensive energy-storage performances. Moreover, superior charge-discharge performances of high-power density ≈182 MW cm-3, high discharge energy density ≈4.3 J cm-3 and ultra-short discharge time <70 ns as well as excellent temperature stability demonstrate great application potentials for dielectric energy-storage capacitors in pulsed power devices. This work provides an effective and paradigmatic strategy for developing novel lead-free dielectrics with high energy-storage performance under finite electric fields.

Core-shell engineered g-C3N4@ NaNbO3for enhancing photocatalytic reduction of CO2.

Photocatalytic reduction of carbon dioxide is a technology that effectively utilizes CO2and solar energy. Sodium niobate (NaNbO3) has received much attention in the field of photocatalysis due to its excellent photocatalytic properties. However, the application of NaNbO3in the field of photocatalysis is still limited by poor reaction to visible light and easy recombination of photo-generated carriers. Heterojunction with g-C3N4to construct core-shell structure can effectively improve the above problems. Combining the two can design a core-shell composite material that is beneficial for photocatalytic reduction of CO2. Herein, we prepared a core-shell heterojunction g-C3N4/NaNbO3by uniformly impregnating urea on the surface of NaNbO3chromium nanofibers with NaNbO3nanofibers prepared by electrospinning as a catalyst carrier, and urea as a precursor of g-C3N4. The core-shell structure of g-C3N4/NaNbO3was verified by a series of characterization methods such as XPS, XRD, and TEM. It was found that under the same conditions, the methanol yield of core-shell g-C3N4/NaNbO3was 12.86µmol·g-1·h-1, which is twice that of pure NaNbO3(6.67µmol·g-1·h-1). This article highlights an impregnation method to build core-shell structures for improved photocatalytic reduction of CO2.

Dielectric Filler-Induced Hybrid Interphase Enabling Robust Solid-State Li Metal Batteries at High Areal Capacity.

The fillers in composite solid-state electrolyte are mainly responsible for the enhancement of the conduction of Li ions but barely regulate the formation of solid electrolyte interphase (SEI). Herein, a unique filler of dielectric NaNbO3 for the poly(vinylidene fluoride) (PVDF)-based polymer electrolyte, which is subjected to the exchange of Li+ and Na+ during cycling, is reported and the substituted Na+ is engaged in the construction of a fluorinated Li/Na hybrid SEI with high Young's modulus, facilitating the fast transport of Li+ at the interface at a high areal capacity and suppressing the Li dendrite growth. The dielectric NaNbO3 also induces the generation of high-dielectric ß phase of PVDF to promote the dissociation of Li salt. The Li/Li symmetrical cell exhibits a long-term dendrite-free cycling over 600 h at a high areal capacity of 3 mA h cm-2. The LiNi0.8Mn0.1Co0.1O2/Li solid-state cells with NaNbO3 stably cycle 2200 times at 2 C and that paired with high-loading cathode (10 mg cm-2) can stably cycle for 150 times and exhibit excellent performances at -20 °C. This work provides a novel design principle of fillers undertaking interfacial engineering in composite solid-state electrolytes for developing the safe and stable solid-state lithium metal battery.