ABSTRACT
Photons during the dark period delay flowering in short-day plants (SDP). Red photons applied at night convert phytochromes to the active far-red absorbing form (Pfr), leading to inhibition of flowering. Far-red photons (greater than 700 nm) re-induce flowering when applied after a pulse of red photons during the dark period. However, far-red photons at sufficiently high intensity and duration delay flowering in sensitive species. Mechanistically, this response occurs because phytochrome-red (Pr) absorbance is not zero beyond 700 nm. We applied nighttime photons from near infrared (NIR) LEDs (peak 850 nm) over a 12 h dark period. Flowering was delayed in Glycine max and Cannabis sativa (two photosensitive species) by 3 and 12 days, respectively, as the flux of photons from NIR LEDs was increased up to 83 and 116 µmol m-2 s-1. This suggests that long wavelength photons from NIR LEDs can activate phytochromes (convert Pr to Pfr) and thus alter plant development.
Subject(s)
Cannabis/growth & development , Glycine max/growth & development , Infrared Rays , Phytochrome/metabolism , Cannabis/metabolism , Cannabis/radiation effects , Flowers/growth & development , Flowers/metabolism , Flowers/radiation effects , Photons , Plant Stems/growth & development , Plant Stems/metabolism , Plant Stems/radiation effects , Glycine max/metabolism , Glycine max/radiation effectsABSTRACT
UV-C radiation is known to induce metabolic modifications in plants, particularly to secondary metabolite biosynthesis. To assess these modifications from a global and untargeted perspective, the effects of the UV-C radiation of the leaves of three different model plant species, Cissus antarctica Vent. (Vitaceae), Vitis vinifera L. (Vitaceae) and Cannabis sativa L. (Cannabaceae), were evaluated by an LC-HRMS-based metabolomic approach. The approach enabled the detection of significant metabolite modifications in the three species studied. For all species, clear modifications of phenylpropanoid metabolism were detected that led to an increased level of stilbene derivatives. Interestingly, resveratrol and piceid levels were strongly induced by the UV-C treatment of C. antarctica leaves. In contrast, both flavonoids and stilbene polymers were upregulated in UV-C-treated Vitis leaves. In Cannabis, important changes in cinnamic acid amides and stilbene-related compounds were also detected. Overall, our results highlighted phytoalexin induction upon UV-C radiation. To evaluate whether UV-C stress radiation could enhance the biosynthesis of bioactive compounds, the antioxidant activity of extracts from control and UV-C-treated leaves was measured. The results showed increased antioxidant activity in UV-C-treated V. vinifera extracts.
Subject(s)
Cannabis/metabolism , Cissus/metabolism , Plant Leaves/metabolism , Vitis/metabolism , Benzothiazoles/chemistry , Biphenyl Compounds/chemistry , Cannabis/radiation effects , Cissus/radiation effects , Free Radical Scavengers/chemistry , Free Radical Scavengers/isolation & purification , Free Radicals/chemistry , Metabolome/radiation effects , Picrates/chemistry , Plant Extracts/chemistry , Plant Extracts/isolation & purification , Plant Leaves/radiation effects , Spectrometry, Mass, Electrospray Ionization , Sulfonic Acids/chemistry , Ultraviolet Rays , Vitis/radiation effectsABSTRACT
A new polymeric composite based on natural rubber reinforced with hemp has been processed by electron beam irradiation and characterized by several methods. The mechanical characteristics: gel fraction, crosslink density, water uptake, swelling parameters, and FTIR of natural rubber/hemp fiber composites have been investigated as a function of the hemp content and absorbed dose. Physical and mechanical properties present a significant improvement as a result of adding hemp fibres in blends. Our experiments showed that the hemp fibers have a reinforcing effect on natural rubber similar to mineral fillers (chalk, carbon black, silica). The crosslinking rates of samples, measured using the Flory-Rehner equation, increase as a result of the amount of hemp in blends and the electron beam irradiation dose increasing. The swelling parameters of samples significantly depend on the amount of hemp in blends, because the latter have hydrophilic characteristics.
Subject(s)
Cannabis/chemistry , Electrons , Rubber/chemistry , Cannabis/radiation effects , Elasticity , Rubber/radiation effects , Tensile StrengthABSTRACT
The safest protection from UV radiation (UVR) exposure is offered by clothing and its protectiveness depends on fabric composition (natural, artificial or synthetic fibers), fabric parameters (porosity, weight and thickness) and dyeing (natural or synthetic dyes, dye concentration, UV absorbing properties, etc.). In this study the UV protection properties of two fabrics made of natural fibers (flax and hemp) dyed with some of the most common natural dyes were investigated. UVR transmittance of fabrics was measured by two methods: one based on the utilization of a spectrophotometer equipped with an integrating sphere (in vitro test), and the other based on outdoor measurements taken by a spectroradiometer. Transmittance measurements were used to calculate the ultraviolet protection factor (UPF). Experimental results revealed that natural dyes could confer good UV protection, depending mainly on their different UVR-absorbing properties, provided that the fabric construction already guaranteed good cover. An increase in cover factor caused by the dyeing process was also detected. Weld-dyed fabrics gave the highest protection level. The comparison between the two methods applied to measure fabric transmittance pointed out that the UPFs calculated by in vitro measurements were generally lower than those based on outdoor data, indicating an underestimation of the actual protection level of tested fabrics assessed by the in vitro test.
