Skin decontamination procedures against potential hazards substances exposure.

Decontamination of unprotected skin areas is crucial to prevent excessive penetration of chemical contaminants after criminal or accidental release. A review of literature studies was performed to identify the available decontamination methods adopted to treat skin contamination after chemical, radiological and metal exposures. In this bibliographic review, an overview of the old and recent works on decontamination procedures followed in case of potential hazards substances contaminations with a comparison between these systems are provided. Almost all data from our 95 selected studies conducted in vitro and in vivo revealed that a rapid skin decontamination process is the most efficient way to reduce the risk of intoxication. The commonly-used or recommended conventional procedures are simple rinsing with water only or soapy water. However, this approach has some limitations because an easy removal by flushing may not be sufficient to decontaminate all chemical deposited on the skin, and skin absorption can be enhanced by the wash-in effect. Other liquid solutions or systems as adsorbent powders, mobilizing agents, chelation therapy are also applied as decontaminants, but till nowadays does not exist a decontamination method which can be adopted in all situations. Therefore, there is an urgent need to develop more efficient and successful decontaminating formulations.

Establishment of a Novel Oral Murine Model of Ricin Intoxication and Efficacy Assessment of Ovine Ricin Antitoxins.

Ricin, produced from the castor beans of Ricinus communis, is a cytotoxin that exerts its action by inactivating ribosomes and causing cell death. Accidental (e.g., ingestion of castor beans) and/or intentional (e.g., suicide) exposure to ricin through the oral route is an area of concern from a public health perspective and no current licensed medical interventions exist to protect from the action of the toxin. Therefore, we examined the oral toxicity of ricin in Balb/C mice and developed a robust food deprivation model of ricin oral intoxication that has enabled the assessment of potential antitoxin treatments. A lethal oral dose was identified and mice were found to succumb to the toxin within 48 h of exposure. We then examined whether a despeciated ovine F(ab')2 antibody fragment, that had previously been demonstrated to protect mice from exposure to aerosolised ricin, could also protect against oral intoxication. Mice were challenged orally with an LD99 of ricin, and 89 and 44% of mice exposed to this otherwise lethal exposure survived after receiving either the parent anti-ricin IgG or F(ab')2, respectively. Combined with our previous work, these results further highlight the benefit of ovine-derived polyclonal antibody antitoxin in providing post-exposure protection against ricin intoxication.

Metal-Organic Frameworks against Toxic Chemicals.

Materials capable of the safe and efficient capture or degradation of toxic chemicals, including chemical warfare agents (CWAs) and toxic industrial chemicals (TICs), are critically important in the modern age due to continuous threats of these chemicals to human life, both directly and indirectly. Metal-organic frameworks (MOFs), atomically precise hybrid materials that are synthesized via the self-assembly of metal cations or clusters and organic linkers, offer a unique solid adsorbent design platform due to their great synthetic versatility. This review will focus on recent advancements in MOF-based adsorbent design for protection against chemical warfare agents (organophosphorus nerve agents, blistering agents, and their simulants) and toxic industrial chemicals such as H2S, NH3, SO2, CO, NO2, and NO.

Comparative Study of Phosgene Gas Sensing Using Carbon and Boron Nitride Nanomaterials-A DFT Approach.

Phosgene (COCl2), a valuable industrial compound, maybe a public safety and health risk due to potential abuse and possible accidental spillage. Conventional techniques suffer from issues related to procedural complexity and sensitivity. Therefore, there is a need for the development of simple and highly sensitive techniques that overcome these challenges. Recent advances in nanomaterials science offer the opportunity for the development of such techniques by exploiting the unique properties of these nanostructures. In this study, we investigated the potential of six types of nanomaterials: three carbon-based ([5,0] CNT, C60, C70) and three boron nitride-based (BNNT, BN60, BN70) for the detection of COCl2. The local density approximation (LDA) approach of the density functional theory (DFT) was used to estimate the adsorption characteristics and conductivities of these materials. The results show that the COCl2 molecule adsorbed spontaneously on the Fullerene or nanocages and endothermically on the pristine zigzag nanotubes. Using the magnitude of the bandgap modulation, the order of suitability of the different nanomaterials was established as follows: PBN60 (0.19%) < PC70 (1.39%) < PC60 (1.77%) < PBNNT (27.64%) < PCNT (65.29%) < PBN70 (134.12%). Since the desired criterion for the design of an electronic device is increased conductivity after adsorption due to the resulting low power consumption, PC60 was found to be most suitable because of its power consumption as it had the largest decrease of 1.77% of the bandgap.

[Analysis of Countermeasures against Chemical Terrorism].

As a countermeasure against terrorism involving highly toxic chemical warfare agents, the rapid identification of the causative toxic substances is extremely important. This symposium review describes analytical methods the author's group has developed for detecting nerve gases after either high level or low level exposure. As a method for assessing human exposure to high levels of nerve gases, a technology that detects nerve gas hydrolysis products, i.e., strong anion exchange extraction-tert-butyldimethylsilyl derivatization-selectable one-dimensional or two-dimensional GC-MS, is explained. As a method for assessing human exposure to low levels of nerve gases, two technologies that detect adducts of nerve gas with blood cholinesterase, i.e., adduct purification-enzymatic digestion-LC/MS and fluoride-mediated regeneration-solid phase extraction-large volume introduction GC-MS, are explained.

Rapid quantification of two chemical nerve agent metabolites in serum.

Organophosphorus compounds (OPs) continue to represent a significant chemical threat to humans due to exposures from their use as weapons, their potential storage hazards, and from their continued use agriculturally. Existing methods for detection include ELISA and mass spectrometry. The new approach presented here provides an innovative first step toward a portable OP quantification method that surmounts conventional limitations involving sensitivity, selectivity, complexity, and portability. DNA affinity probes, or aptamers, represent an emerging technology that, when combined with a mix-and-read, free-solution assay (FSA) and a compensated interferometer (CI) can provide a novel alternative to existing OP nerve agent (OPNA) quantification methods. Here it is shown that FSA can be used to rapidly screen prospective aptamers in the biological matrix of interest, allowing the identification of a 'best-in-class' probe. It is also shown that combining aptamers with FSA-CI enables quantification of the OPNA metabolites, Sarin (NATO designation "G-series, B", or GB) and Venomous Agent X (VX) acids, rapidly with high selectivity at detection limits of sub-10 pg/mL in 25% serum (by volume in PBS). These results suggest there is potential to directly impact diagnostic specificity and sensitivity of emergency response testing methods by both simplifying sample preparation procedures and making a benchtop reader available for OPNA metabolite quantification.

Trace Level Analysis of Sarin and VX in Food Using Normal Phase Silica Gel and Ultra-Performance Liquid Chromatography-Time-of-Flight Mass Spectrometry (UPLC-TOF-MS).

Ultra-Performance Liquid Chromatography/electrospray ionization mass spectrometry was used for the trace level determination of isopropyl methylphosphonofluoridate (Sarin, GB) and ( O-ethyl S-[2-(diisopropylamino)ethyl] methylphosphonothioate (VX) after extraction from various foods. A method utilizing normal phase silica gel was developed for the sample preparation and extraction of VX and GB from food. The extraction efficiencies of the normal phase silica gel method for VX was compared to those of other commercial solid phase extraction media and was found to be comparable. Sarin was found to be incompatible with both the mixed mode cation exchange (MCX) sorbents and QuEChERS methods that are commercially available but was successful with the normal phase silica gel method. The linear range of quantitation for VX was 0.1-330 ng/mL and for GB was 20-1200 ng/mL. The average recoveries of VX and GB from the various food matrices along with the corresponding relative standard deviations (RSDs) are reported.

Part 3: Solid phase extraction of Russian VX and its chemical attribution signatures in food matrices and their detection by GC-MS and LC-MS.

Chemical attribution signatures indicative of O-isobutyl S-(2-diethylaminoethyl) methylphosphonothioate (Russian VX) synthetic routes were investigated in spiked food samples. Attribution signatures were identified using a multifaceted approach: Russian VX was synthesized using six synthetic routes and the chemical attribution signatures identified by GC-MS and LC-MS. Three synthetic routes were then down selected and spiked into complex matrices: bottled water, baby food, milk, liquid eggs, and hot dogs. Sampling and extraction methodologies were developed for these materials and used to isolate the attribution signatures and Russian VX from each matrix. Recoveries greater than 60% were achieved for most signatures in all matrices; some signatures provided recoveries greater than 100%, indicating some degradation during sample preparation. A chemometric model was then developed and validated with the concatenated data from GC-MS and LC-MS analyses of the signatures; the classification results of the model were > 75% for all samples. This work is part three of a three-part series in this issue of the United States-Sweden collaborative efforts towards the understanding of the chemical attribution signatures of Russian VX in crude materials and in food matrices.

Sensing and capture of toxic and hazardous gases and vapors by metal-organic frameworks.

Toxic and hazardous chemical species are ubiquitous, predominantly emitted by anthropogenic activities, and pose serious risks to human health and the environment. Thus, the sensing and subsequent capture of these chemicals, especially in the gas or vapor phase, are of extreme importance. To this end, metal-organic frameworks have attracted significant interest, as their high porosity and wide tunability make them ideal for both applications. These tailorable framework materials are particularly promising for the specific sensing and capture of targeted chemicals, as they can be designed to fit a diverse range of required conditions. This review will discuss the advantages of metal-organic frameworks in the sensing and capture of harmful gases and vapors, as well as principles and strategies guiding the design of these materials. Recent progress in the luminescent detection of aromatic and aliphatic volatile organic compounds, toxic gases, and chemical warfare agents will be summarized, and the adsorptive removal of fluorocarbons/chlorofluorocarbons, volatile radioactive species, toxic industrial gases and chemical warfare agents will be discussed.

Simultaneous quantification of four metabolites of sulfur mustard in urine samples by ultra-high performance liquid chromatography-tandem mass spectrometry after solid phase extraction.

Four HD urinary metabolites including hydrolysis metabolite thiodiglycol (TDG), glutathione-derived metabolite 1,1'-sulfonylbis[2-S-(N-acetylcysteinyl)ethane] (SBSNAE), as well as the ß-lyase metabolites 1,1'-sulfonylbis[2-(methylsulfinyl)ethane] (SBMSE) and 1-methylsulfinyl-2-[2-(methylthio) ethylsulfonyl]ethane (MSMTESE) are considered as important biomarkers for short-term retrospective detection of HD exposure. In this study, a single method for simultaneous quantification of the four HD metabolites in urine samples was developed using ultra high performance liquid chromatography-tandem mass spectrometry (UHPLC-MS/MS). The four urinary metabolites were simultaneously extracted from urinary samples using a solid phase extraction (SPE) method with high extraction recoveries for all four metabolites varied in the range of 71.1-103% followed by UHPLC-MS/MS analysis. The SPE is simple and high effective only requiring 0.1mL of urinary samples and 0.5h time consuming. The problem of previous co-elution of TDG and SBSNAE in UHPLC was well solved, and complete separation of TDG, SBSNAE, SBMSE and MSMTESE from SPE-processed urine matrix was obtained to increase specificity and sensitivity. A full method validation was performed for each analyte in urine matrix. The linear range of calibration curves for the four analytes were respectively from 0.50-500ngmL-1 for TDG and SBSNAE, 0.05-500ngmL-1 for SBMSE and MSMTESE with coefficient of determination value (R2) ≥0.990. The limit of detection was 0.25ngmL-1 for TDG and SBSNAE, 0.01ngmL-1 for SBMSE and MSMTESE spiked in normal urine. The intra/inter-day precision for each analyte at three QC levels had relative standard deviation (%RSD) of ≤10.3%, and the intra/inter-day accuracy ranged between 88.0-108%. This developed method allows for simultaneous and trace measurement of four HD urinary metabolites within one single determination with the lowest usage amount of urine samples over all previous methods This study provides a useful tool for early diagnosis and monitoring of HD poisoning for medical treatment with high confidence, avoiding the need for application of several analysis methods.