Anatomical and physical changes in leaves during the production of tamales.

PREMISE OF THE STUDY: Tamale preparation has a long tradition in Mexico. To understand which material properties have been considered important for this purpose throughout the years, a study was conducted of the anatomical, chemical, and mechanical properties of the leaves of four plant species used in tamale preparation in Veracruz, Mexico: Calathea misantlensis, Canna indica, Musa paradisiaca, and Oreopanax capitatus. METHODS: Four cooking treatments were considered: fresh (F), roasted (soasado, R), steamed (S), and roasted plus steamed (R/S). Chemical, anatomical, and mechanical analyses were conducted before and after each treatment. Leaf samples were tested for tensile strength at both parallel and perpendicular orientation relative to the fibers. KEY RESULTS: Musa paradisiaca had the highest proportion of cellulose, while the remaining species shared similar lower proportions. Leaves were stronger and stiffer in the longitudinal direction of the fibers. Musa paradisiaca leaves had higher values of mechanical strength than the other species. The cooking process that most affected the mechanical properties was steaming. CONCLUSIONS: The chemical constituents of the leaves are closely correlated with their physical properties. The treatment that caused the greatest decrease in leaf physical integrity was steaming, while the combination of roasting and steaming showed similar results to those of steaming alone. No evident anatomical changes are produced by any of the treatments. This is one of the few studies comparing physical, chemical, and anatomical characteristics of leaves used for human consumption, before and after cooking.

The extremely long-tongued neotropical butterfly Eurybia lycisca (Riodinidae): proboscis morphology and flower handling.

Few species of true butterflies (Lepidoptera: Papilionoidea) have evolved a proboscis that greatly exceeds the length of the body. This study is the first to examine the morphology of an extremely long butterfly proboscis and to describe how it is used to obtain nectar from flowers with very deep corolla tubes. The proboscis of Eurybia lycisca (Riodinidae) is approximately twice as long as the body. It has a maximal length of 45.6 mm (mean length 36.5 mm ± 4.1 S.D., N = 20) and is extremely thin, measuring only about 0.26 mm at its maximum diameter. The proboscis has a unique arrangement of short sensilla at the tip, and its musculature arrangement is derived. The flower handling times on the preferred nectar plant, Calathea crotalifera (Marantaceae), were exceptionally long (mean 54.5 sec ± 28.5 S.D., N = 26). When feeding on the deep flowers remarkably few proboscis movements occur. The relationship between Eurybia lycisca and its preferred nectar plant and larval host plant, Calathea crotalifera, is not mutualistic since the butterfly exploits the flowers without contributing to their pollination. We hypothesize that the extraordinarily long proboscis of Eurybia lycisca is an adaptation for capitalizing on the pre-existing mutualistic interaction of the host plant with its pollinating long-tongued nectar feeding insects.

Pollination syndromes in African Marantaceae.

BACKGROUND AND AIMS: The Marantaceae (550 spp.) is the most derived family in the order Zingiberales and exhibits a complex explosive pollination mechanism. To understand the evolutionary significance of this unique process of pollen transfer, comparative morphological and ecological studies were conducted in Gabon. METHODS: During a total stay of 11 months, 31 species of Marantaceae were investigated at different sites in Gabon. The study included analyses of floral diversity, observations on the pollinator spectrum as well as ecological measurements (e.g. nectar sugar concentration and volume). KEY RESULTS: Analyses reveal five flower types based on flower size and pigmentation, spatial arrangement of the floral tube and presence/absence of nectar guides and conspicuous outer staminodes. Each type is associated with a specific functional pollinator group leading to the description of distinct pollination syndromes. The 'small (horizontal)' flowers are predominantly pollinated by small bees (Thrinchostoma spp., Allodapula ornaticeps), the 'large (horizontal)' and 'medium-sized (horizontal)' flowers by medium-sized bees (Amegilla vivida, Thrinchostoma bicometes), the 'locked (horizontal)' flowers by large bees (Xylocopa nigrita, X. varipes) and the '(large) vertical' flowers by sunbirds. CONCLUSIONS: The longevity of Marantaceae individuals and the omnipresence of their pollinators allowed the specialization to a given functional pollinator group. Intermediate ecological values, however, make occasional pollinator overlaps possible, indicating potential pathways of pollinator shifts. Similar radiation tendencies observed on other continents hint at similar selective pressures and evolutionary constraints.

Setting-up tension in the style of Marantaceae.

The Marantaceae stand out from other plant families through their unique style movement which is combined with a highly derived form of secondary pollen presentation. Although known for a long time, the mechanism underlying the movement is not yet understood. In this paper, we report an investigation into the biomechanical principles of this movement. For the first time we experimentally confirm that, in Maranta noctiflora, longitudinal growth of the maturing style within the 'straitjacket' of the hooded staminode involves both arresting of the style before tripping and building up of potential for the movement. The longer the style grows in relation to the enclosing hooded staminode, the more does its capacity for curling increase. We distinguish between the basic tension that a growing style builds up normally, even when the hooded staminode is removed beforehand, and the induced tension which comes about only under the pressure of a too short hooded staminode and which enables the movement. The results of our investigations are discussed in relation to previous interpretations, ranging from biomechanical to electrophysiological mechanisms.

Insights on the development, kinetics, and variation of photoinhibition using chlorophyll fluorescence imaging of a chilled, variegated leaf.

The effect of chilling on photosystem II (PSII) efficiency was studied in the variegated leaves of Calathea makoyana, in order to gain insight into the causes of chilling-induced photoinhibition. Additionally, a relationship was revealed between (chilling) stress and variation in photosynthesis. Chilling treatments (5 degrees C and 10 degrees C) were performed for different durations (1-7 d) under a moderate irradiance (120 micromol m-2 s-1). The individual leaves were divided into a shaded zone and two illuminated, chilled zones. The leaf tip and sometimes the leaf base were not chilled. Measurements of the dark-adapted Fv/Fm were made on the different leaf zones at the end of the chilling treatment, and then for several days thereafter to monitor recovery. Chilling up to 7 d in the dark did not affect PSII efficiency and visual appearance, whereas chilling in the light caused severe photoinhibition, sometimes followed by leaf necrosis. Photoinhibition increased with the duration of the chilling period, whereas, remarkably, chilling temperature had no effect. In the unchilled leaf tip, photoinhibition also occurred, whereas in the unchilled leaf base it did not. Whatever the leaf zone, photoinhibition became permanent if the mean value dropped below 0.4, although chlorosis and necrosis were associated solely with chilled illuminated tissue. Starch accumulated in the unchilled leaf tip, in contrast to the adjacent chilled irradiated zone. This suggests that photoinhibition was due to a secondary effect in the unchilled leaf tip (sink limitation), whereas it was a direct effect of chilling and irradiance in the chilled illuminated zones. The PSII efficiency and its coefficient of variation showed a unique negative linearity across all leaf zones and different tissue types. The slope of this curve was steeper for chilled leaves than it was for healthy, non-stressed leaves, suggesting that the coefficient of variation may be an important tool for assessing stress in leaves.

Anodic asymmetry of leaves and flowers and its relationship to phyllotaxis.

BACKGROUND AND AIMS: New approaches are needed to evaluate the various hypotheses of phyllotaxis, and an examination of anodic leaf asymmetry may be one such approach. METHODS: Data were collected on the direction of midrib curvature and leaf coil in Syngonium podophyllum, the location of floral buds in Acalypha virginica, the position of secondary leaves of Croton variegatus 'Banana' and the relative size of half-lamina in Aglaonema crispum and Calathea ornata. KEY RESULTS: All five features were exclusively anodic with respect to the direction of the genetic spiral regardless of whether the spiral was clockwise or counterclockwise. CONCLUSIONS: Any phyllotactic mechanism must include some asymmetric component which cannot be explained by the prevalent hypotheses of contact parastichies, inhibitory fields, available space, pressure waves and auxin transport. The most favourable hypothesis is the primary vasculature explanation as it includes an asymmetric feature.