Investigation of the relevance between biomass pyrolysis polygeneration and washing pretreatment under different severities: Water, dilute acid solution and aqueous phase bio-oil.

Washing pretreatments of rice straw were performed using three different solutions, namely water, dilute hydrochloric acid solution (HCl solution, pH = 2.9), and aqueous phase bio-oil (APBO, pH = 2.9). The raw and pretreated samples were pyrolyzed at 550 °C in a fixed bed reactor. Results showed that among the three pretreatments, washing with APBO had the highest removal efficiency of alkali metal and alkaline earth metals (AAEMs). Among the pyrolysis products, bio-oil from APBO washed sample had the highest mass, energy, and carbon yields, lowest water content of 36.9%, highest HHV of 17.2 MJ/kg, and highest relative content of anhydrosugars of 31.2%. Its biochar had the lowest ash content of 27.3% and highest specific surface area of 98.6 m2/g, and its non-condensable gases had the highest HHV of 11.9 MJ/m3. Therefore, APBO washing was effective in improving the quality of biomass and its subsequent pyrolysis products.

The role of metal ion-ligand interactions during divalent metal ion adsorption.

A suite of seven different divalent metal ions (Ca(II), Cd(II), Cu(II), Mg(II), Ni(II), Pb(II), Zn(II)) was adsorbed from solution onto two Fe2O3 samples, quartz SiO2 and three different amphoteric polystyrene latices (containing amine and carboxyl functional groups). For the metal oxides, a high correlation was observed between the pH at which 50% of the metal was removed from solution (pH50) and the first hydrolysis constant for the metal ion (pK1). For the polystyrene latices, a much higher correlation was observed between the pH50 and pKc (equilibrium constant describing metal-carboxyl affinity) as opposed to pK1. These observations provide evidence of a strong relationship that exists between a metal's affinity for a particular ligand in solution and for that metal ion's affinity for the same ligand present as part of an adsorbing surface. The isoelectric point of the amphoteric latex surface can be increased by decreasing the carboxyl content of the latex surface. For all 7 metal ions, this resulted in a substantial decrease, for any given pH, in adsorption. We suggest that this may be partly due to the decreased carboxyl content, but is dominantly attributable to the presence of less favorable electrostatic conditions. This, in turn, demonstrates that electrostatics play a controlling role in metal ion adsorption onto amphoteric latex surfaces and, in addition to the nature of the metal ion, also controls the pH at which adsorption takes place.

Sediment porewater extraction and analysis combining filter tube samplers and capillary electrophoresis.

Careful extraction and analysis of porewater from sediment cores are critical for the investigation of small-scale biogeochemical processes. Firstly, small sample volumes and high spatial resolution are required. Secondly, several chemical species in the anaerobic porewater are sensitive to oxidation when brought in contact with ambient air. Here we present the combination of a special sampling technique and an analytical method for the porewater extraction of a varved sediment core from Lake Baldegg in central Switzerland, using MicroRhizon samplers and a portable capillary electrophoresis (CE) instrument. MicroRhizon filter tubes of 1 mm diameter and 20 mm length are suitable for fast retrieval of particle-free porewater samples directly from the sediment core. Since the time-span between sampling and analysis is less than 20 seconds, oxygen-sensitive Fe(ii) can be analyzed in one go together with Na(+), K(+), Ca(2+), Mg(2+), NH4(+), and Mn(ii) without splitting, acidification or dilution of the sample. The major inorganic cations and anions of the sediment porewater can be determined in less than 15 minutes. Detection limits are in the sub-micromolar concentration range. The capillary electrophoresis instrument used in this study requires sample volumes of only 20 µL. These remarkable small sample volumes allow the minimization of disturbance of the sediment cores and a high spatial resolution of the sediment profile, even in sediments with low water content. The equipment is inexpensive, easy to handle, fully portable and therefore suitable for environmental on-site applications.

Separation, preconcentration and inductively coupled plasma-mass spectrometric (ICP-MS) determination of thorium(IV), titanium(IV), iron(III), lead(II) and chromium(III) on 2-nitroso-1-naphthol impregnated MCI GEL CHP20P resin.

A simple and effective method is presented for the separation and preconcentration of Th(IV), Ti(IV), Fe(III), Pb(II) and Cr(III) by solid phase extraction on 2-nitroso-1-naphthol impregnated MCI GEL CHP20P resin prior to their inductively coupled plasma-mass spectrometric determinations. The influence of analytical parameters including pH of the aqueous solution, flow rates of sample and eluent solutions and sample volume on the quantitative recoveries of analyte ions was investigated. Matrix effects caused by the presence of alkali, earth alkali and some metal ions in the analyzed solutions were investigated. The presented solid phase extraction method was applied to BCR-144R Sewage Sludge (domestic origin), BCR-141R Calcareous Loam Soil, NIST 1568a Rice Flour and NIST 1577b Bovine Liver certified reference materials (CRMs) for the determination of analyte ions and the results were in good agreement with the certified values. The separation procedure presented was also applied to the various natural water samples collected from Turkey with satisfactory results.

Simultaneous separation of inorganic anions and metal-citrate complexes on a zwitterionic stationary phase with on-column complexation.

The retention and separation selectivity of inorganic anions and on-column derivatised negatively charged citrate or oxalate metal complexes on reversed-phase stationary phases dynamically coated with N-(dodecyl-N,N-dimethylammonio)undecanoate (DDMAU) has been investigated. The retention mechanism for the metal-citrate complexes was predominantly anion exchange, although the amphoteric/zwitterionic nature of the stationary phase coating undoubtedly also contributed to the unusual separation selectivity shown. A mixture of 10 inorganic anions and metal cations was achieved using a 20 cm monolithic DDMAU modified column and a 1 mM citrate eluent, pH 4.0, flow rate equal to 0.8 mL/min. Selectivity was found to be strongly pH dependent, allowing additional scope for manipulation of solute retention, and thus application to complex samples. This is illustrated with the analysis of an acidic mine drainage sample with a range of inorganic anions and transition metal cations, varying significantly in their concentrations levels.

Effective solvation of alkaline earth ions by proline-rich proteolytic peptides of galectin-3 upon electrospray ionisation.

In an analysis of a combined chymotrypsin/AspN digest of galectin-3 by positive ion nano-electrospray ionisation mass spectrometry (nanoESI-MS) several peptides were observed which showed metal adduct ions as their most abundant ion signals. The most prominent adduct ions were observed at m/z values corresponding to [M+40]2+, [M+41]3+, and [M+42]4+ ions. Detailed investigation of the [M+40]2+ ion of the peptide GAPAGPLIVPY showed that it was not, as originally expected, a [M+H+39K]2+ adduct ion but had the composition [M+40Ca]2+. This was verified by several approaches: (i) nanoESI-MS/MS of the [M+Ca]2+ adduct ions resulted in the virtually exclusive formation of doubly charged fragment ions; (ii) mass determination by quadrupole time-of-flight (QTOF)-MS provided a preliminary identification; and (iii) accurate mass measurement using nanoESI Fourier transform ion cyclotron resonance (FTICR)-MS at a mass resolving power of 500 000 allowed the specific detection and identification of the isobaric ion pairs [M+40Ca]2+/[M+H+39K]2+ and [M+24Mg]2+/[M+H+23Na]2+. All peptides in the chymotryptic galectin-3 digest without a basic residue (K or R) showed addition of calcium as the most prominent ionisation principle. A further common feature of these nonbasic peptides was the presence of several proline residues, which is assumed to be a factor promoting the intense addition of calcium. It was observed that the common trace levels of sodium and calcium in analytical grade solvents (about 1-10 microM) are sufficient to generate the [M+H+23Na]2+ and [M+40Ca]2+ ions as the most prominent species of the peptide GAPAGPLIVPY. We conclude that the sequence motifs P-XX-P and P-XXX-P favour the solvation of alkaline earth ions in ESI-MS. In view of the successful detection of physiological Ca/protein interactions by ESI-MS, this finding may point to a solvation of Ca2+ by galectin in solution. The findings open new routes of research in the study of metal/protein and metal/peptide interactions

Preparation and applications of weak acid cation exchanger based on monodisperse poly(ethylvinylbenzene-co-divinylbezene) beads.

New technology is reported here for the synthesis of an effective weak acid-cation exchanger for ion chromatography. Monodisperse macroporous poly(ethylvinylbenzene-co-divinylbezene) (PEVB-DVB) beads of 5 microm diameter were prepared by a two-step swelling and polymerization method. Then carboxyl groups were introduced by polymerization of maleic anhydride with unreacted vinyl groups on the resin beads, followed by hydrolysis of the maleic anhydride groups. A column packed with the carboxylate beads was used to separate alkali and alkaline earth metal ions in a single isocratic run. Separations were found to be better than those with similar resin particles that are simply coated with maleic acid. The columns containing the new particles were 100% compatible with solvents commonly used for HPLC. Additionally, the prepared column was stable and could be used for a long time in a wide range of pH. The column gave good resolution, low detection limits and good repeatability for the separation of common cations. Satisfactory results were also obtained for separations of organic amines and of common cations in rainwater.

Thin-layer chromatographic behavior and separation of alkaline earth metals on silica gel in aqueous sodium perchlorate solution.

The thin-layer chromatographic behavior of alkaline earth metal ions (Mg2+, Ca2+, Sr2+, and Ba2+) in aqueous sodium perchlorate solutions on silica gel thin-layers impregnated with sodium hydroxide has been surveyed as a function of salt concentration. At salt concentrations above 2 mol 1(-1), the selectivity of the metals increased with a decrease in the crystal ionic radii; with further increases in salt concentration, the selectivity differences among the metals expanded remarkably. In the present systems, it was supposed that the cation exchange, the surface complexation, and the salting-out effect participate simultaneously in the adsorption of the metals on silica gel. Typical chromatograms for the mutual separation of the alkaline earth metals are presented.