The effect of CO2 9.3 µm short-pulsed laser irradiation in enamel erosion reduction with and without fluoride applications-a randomized, controlled in vitro study.

The aim of this in vitro study was to evaluate the protective effect of short-pulsed CO2 9.3 µm laser irradiation against erosion in human enamel without and combined with TiF4 and AmF/NaF/SnCl2 applications, respectively, as well as compared to the protective effect of these fluoride treatments alone. After polishing, ninety enamel samples (3 × 3mm) were used for 9 different treatment groups: 4% TiF4 gel (pH 1.5, 24,533 ppm F-); AmF/NaF/SnCl2 rinse (pH 4.5; 500 ppm F-, 800 ppm Sn2); CO2 laser (average power 0.58 W); CO2 laser (0.58 W) + TiF4; CO2 laser (0.58 W) + AmF/NaF/SnCl2; CO2 laser (0.69 W); CO2 laser (0.69 W) + TiF4; CO2 laser (0.69 W) + AmF/NaF/SnCl2; negative control (deionized water). TiF4 gel was brushed on only once before the first erosive cycling, while samples treated with AmF/NaF/SnCl2 were daily immersed in 5 ml of the solution before cycling. Laser treatment occurred with a CO2 laser (wavelength 9.3 µm, pulse repetition rate 100 Hz, pulse duration 14.6 µs/18 µs, average power 0.58 W/0.69 W, fluence 1.9 J/cm2/2.2 J/cm2, beam diameter 0.63 mm, irradiation time 10 s, air cooling). TiF4 was applied only once, while AmF/NaF/SnCl2 was applied once daily before the erosive challenge. Surface loss (in µm) was measured with optical profilometry immediately after treatment, and after 5 and 10 days of erosive cycling (0.5% citric acid, pH 2.3, 6 × 2 min/day). Additionally, scanning electron microscopy investigations were performed. All application measures resulted in loss of surface height immediately after treatment. After 5 days, significantly reduced surface loss was observed after applying laser irradiation (both power settings) followed by applications of TiF4 or AmF/NaF/SnCl2 solution (p < 0.05; 2-way ANOVA and Tukey test) compared to fluoride application alone. After 10 days, compared to after 5 days, a reduced tissue loss was observed in all groups treated with AmF/NaF/SnCl2 solution. This tissue gain occurred with the AmF/NaF/SnCl2 application alone and was significantly higher when the application was combined with the laser use (p < 0.05). Short-pulsed CO2 9.3 µm laser irradiation followed by additional application of AmF/NaF/SnCl2 solution significantly reduces the progression of dental enamel erosion in vitro.

Progression of erosive lesions after Nd:YAG laser and fluoride using optical coherence tomography.

This study aimed to use optical coherence tomography (OCT) to assess the progression of erosive lesions after irradiation with Nd:YAG laser and application of topical fluoride. One-hundred and twenty dentin samples (4 × 4 × 2 mm) obtained from bovine incisors were used. Samples were protected with acid-resistant nail varnish, with exception of a central circular area 2 mm in diameter. All samples were submitted to erosive cycles with citric acid solution 0.05 M (citric acid monohydrate-C6H8O7·H2O); M = 210.14 g/mol) pH 2.3, at room temperature, for 20 min, 2×/day, throughout 20 days. After 10 days of acid challenges, lesions became visible, and each group received a different treatment (n = 15): control (without treatment), topical application of sodium fluoride 2 % for 4 min; Nd:YAG laser with different irradiation parameters (1, 0.7, and 0.5 W); and the association of fluoride with the laser parameters. OCT readouts were performed on day 01 (before the first acid challenge-OCT1), on day 05 (OCT2), day 10 (OCT3-after treatment), day 15 (OCT4), day 17 (OCT5), and day 20 (OCT6). The OCT images generated made it possible to measure the amount of tooth tissue loss over the 20 days of erosive cycle, before and after treatments, and to monitor early dentin demineralization progression. After statistical analysis, the fluoride group was observed to be the one that showed smaller loss of tissue over time. The OCT technique is promising for diagnosing and monitoring erosive lesion damage; however, further in vitro and in vivo research is needed to improve its use.