Saturation behaviour of colloidal PbSe quantum dot exciton emission coupled into silicon photonic circuits.

We report coupling of the excitonic photon emission from photoexcited PbSe colloidal quantum dots (QDs) into an optical circuit that was fabricated in a silicon-on-insulator wafer using a CMOS-compatible process. The coupling between excitons and sub-µm sized silicon channel waveguides was mediated by a photonic crystal microcavity. The intensity of the coupled light saturates rapidly with the optical excitation power. The saturation behaviour was quantitatively studied using an isolated photonic crystal cavity with PbSe QDs site-selectively located at the cavity mode antinode position. Saturation occurs when a few µW of continuous wave HeNe pump power excites the QDs with a Gaussian spot size of 2 µm. By comparing the results with a master equation analysis that rigorously accounts for the complex dielectric environment of the QD excitons, the saturation is attributed to ground state depletion due to a non-radiative exciton decay channel with a trap state lifetime ~ 3 µs.

Hard proof of the NaYF(4)/NaGdF(4) nanocrystal core/shell structure.

Hexagonal-phase NaYF(4)/NaGdF(4) core/shell nanocrystals were synthesized and investigated by X-ray photoelectron spectroscopy (XPS) using tunable synchrotron radiation. Based on the ratio of the Y(3+) 3d to Gd(3+) 4d core level intensities at varying photoelectron kinetic energies, we conclude that Gd(3+) resides predominantly at the surface of the nanocrystals, proving a core/shell structure. These nanocrystals show potential for use as contrast agents in magnetic resonance imaging (MRI) applications and optical imaging.

Site-selective optical coupling of PbSe nanocrystals to Si-based photonic crystal microcavities.

A novel method for patterning optically active colloidal PbSe nanocrystals on Si surfaces is reported. Oleate-capped PbSe nanocrystals were found to adhere preferentially to H-terminated Si surfaces over oxide and alkyl-terminated Si surfaces. Scanning probe lithography was used to oxidize locally a dodecyl monolayer on the Si surface of a silicon-on-insulator wafer prepatterned with photonic crystal microcavities. Aqueous HF was then used to remove the oxide and expose H-terminated Si areas, yielding patterned PbSe nanocrystals on the Si surface after exposure to a nanocrystal solution. This patterning technique allows for the selective deposition of PbSe nanocrystals at the main antinode of the silicon-based microcavities. More than a 10-fold photoluminescence enhancement due to the cavity-nanocrystal coupling was observed.