RESUMEN
Lack of horizontal and vertical bone at the site of an implant can lead to significant clinical problems that need to be addressed before implant treatment can take place. Guided bone regeneration (GBR) is a commonly used surgical procedure that employs a barrier membrane to encourage the growth of new bone tissue in areas where bone has been lost due to injury or disease. It is a promising approach to achieve desired repair in bone tissue and is widely accepted and used in approximately 40% of patients with bone defects. In this Review, we provide a comprehensive examination of recent advances in resorbable membranes for GBR including natural materials such as chitosan, collagen, silk fibroin, along with synthetic materials such as polyglycolic acid (PGA), polycaprolactone (PCL), polyethylene glycol (PEG), and their copolymers. In addition, the properties of these materials including foreign body reaction, mechanical stability, antibacterial property, and growth factor delivery performance will be compared and discussed. Finally, future directions for resorbable membrane development and potential clinical applications will be highlighted.
RESUMEN
STATEMENT OF PROBLEM: The influence of different restorative materials, the divergence angle, and the preparation design of the pulp chamber floor in endocrowns on stress distribution is unclear. PURPOSE: The purpose of this finite element analysis study was to evaluate the stress distribution and maximum von Mises stress values in endocrown restorations and remaining teeth. MATERIAL AND METHODS: An endodontically treated first mandibular molar was prepared with 2-mm occlusal reduction, a butt-joint margin, and a mesial box with a 4-mm buccolingual extension to receive an endocrown restoration. The model was then scanned, and the exported standard tessellation language file was designed according to the anatomic references by using a computer-aided design software program. The reference model was duplicated, and 27 variations were formed: restorations made of IPS e.max, Vitablocs MarkII, and Vita Enamic, as well as different divergence angles of 6, 12, and 16 degrees prepared with 3 variations of pulp chamber floor designs, keeping the natural form, adding a 1-mm glass ionomer pulp chamber base, and adding a 2-mm extension into the distal canal. Stress distribution under axial loading and maximum von Mises stress values were analyzed and calculated by using the Ansys software program. RESULTS: The endocrown restoration presented the lowest von Mises stress values when a 6-degree divergence angle was used with Vitablocs MarkII. However, in other layers such as enamel, resin cement, and pulpal floor, the lowest von Mises stress values were observed in IPS e.max restorative material when the divergence angle was increased to 16 degrees. No difference was found in the stress distribution pattern and maximum von Mises stress values in the alveolar bone or periodontal ligament. CONCLUSIONS: Endocrowns fabricated with lithium disilicate ceramics without intraradicular extension exhibited lower stresses on tooth structure. An increase in the divergence angle improved the stress distribution on tooth structure; however, sound dental tissue should not be removed to achieve better stress distribution.
